(vv)% = (10.0 mL150 mL) × 100 %Here, first solve the bracket,= (0.06666) × 100%now, do multiplication of above step,= 6.666 %= 6.7%vv% = 10.0 mL150 mL × 100 %Here, first solve the bracket,= 0.06666 × 100%now, do multiplication of above step,= 6.666 %= 6.7% This problem answer is not helping me. Is there any way you can give me a video I can watch or something please stuck on a homework problem? I'm trying to understand what v/v w/v and molairty

(vv)% = (10.0 mL150 mL) × 100 %Here, first solve the bracket,= (0.06666) × 100%now, do multiplication of above step,= 6.666 %= 6.7%vv% = 10.0 mL150 mL × 100 %Here, first solve the bracket,= 0.06666 × 100%now, do multiplication of above step,= 6.666 %= 6.7% This problem answer is not helping me. Is there any way you can give me a video I can watch or something please stuck on a homework problem? I'm trying to understand what v/v w/v and molairty

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter6: Random Errors In Chemical Analysis

Section: Chapter Questions

Problem 6.8QAP

See similar textbooks

Similar questions

1. Calculate the experimental density of a salt solution and the percent error (same as relative error percent) using some or all the data given below. solubility of NaCl salt in water: 0.357 g/mLmass of empty graduated cylinder: 25.19g mass of graduated cylinder + salt solution: 30.47g total volume of salt solution: 4.98 mLtrue density of salt solution: 1.07 g/mL
You are checking the accuracy of a volumetric flask marked 10.00 mL . To calculate the volume of water contained in the flask, you first measure the mass of the empty flask and the mass of the flask filled with water and take the difference. Then, you correct for the buoyancy factor and divide by the density of the water. The result of 8 such measurements is given in the table. Calculate the 95% confidence interval for these measurements with a mean of 10.03.
Solve the required of the following and show the complete process to be able to gain the value of the correct answer. Given: Volume of Vinegar used (ml) = 25.00 mL Volume after dilution = 250.00 mL Volume of Aliquot used (ml) = 50.00 mL Volume NaOH used (ml) = 34.85 mL Concentration of NaOH = 0.09919475765 M Required: Calculate % (w/v) CH3COOH = ? P.S. Use weight in grams and volume of vinegar in mL, but correction based on aliquot should be made.
To determine the organic material in a dried lake bed, the percent carbon by mass is measured at two different locations. To compare the means of the two different locations, it must first be determined whether the standard deviations of the two locations are different. Location 1 standard deviation: 0.050 Location 2 standard deviation: 0.34 What is the calculated ? value for comparing the standard deviations?
To determine the organic material in a dried lake bed, the percent carbon by mass is measured at two different locations. To compare the means of the two different locations, it must first be determined whether the standard deviations of the two locations are different. Location 1 Standard deviation = 0.050 Location 2 standard deviation = 0.34 a) What is the calculated ? value for comparing the standard deviations? Fcalc = __________________
What is the relative error in the ppt of the following data if the accepted value is 70.05 M? 70.24 M, 70.22 M and 70.10 M
(a) Explain the difference between systematic and random errors. State whether the errors in (b)–(e) are random or systematic. (b) A 25-mL transfer pipet consistently delivers 25.031 + 0.009 mL when drained from the mark. (c) A 10-mL buret consistently delivers 1.98 6 0.01 mL when drained from exactly 0 to exactly 2 mL and consistently delivers 2.03 6 0.02 mL when drained from 2 to 4 mL. (d) A 10-mL buret delivered 1.983 9 g of water when drained from exactly 0.00 to 2.00 mL. The next time I delivered water from the 0.00 to the 2.00 mL mark, the delivered mass was 1.990 0 g. (e) Four consecutive 20.0-mL injections of a solution into a chromatograph were made (as in Figure 0-6) and the area of a particular peak was 4 383, 4 410, 4 401, and 4 390 units. (f) A clean funnel that had been in the lab since last semester had a mass of 15.432 9 g. When filled with a solid precipitate and dried thoroughly in the oven at 1108C, the mass was 15.845 6 g. The calculated mass of precipitate was…
To determine the organic material in a dried lake bed, the percent carbon by mass is measured at two different locations. To compare the means of the two different locations, it must first be determined whether the standard deviations of the two locations are different. For each location, calculate the standard deviation and report it with two significant figures. What is the calculated F value for comparing the standard deviations? Are the standard deviations for the two locations significantly different at the 95% confidence level? ample Location 1 (% C) Location 2 (% C) 1 10.40 10.10 2 10.30 10.90 3 10.30 10.20 4 10.40 10.70 5 10.30 10.30
0.2 to 1.0 mg/ml: For each concentration, a volume of 1.0 mL should be prepared. How will you prepare these standards using micropipettes and which one would you use? There is a: 0,5-10 microliter pipette; 2-20 microliter pipette 20-200 microliter pipette 100-1000 microliter pipette.
Standard deviation- 0.0371 mL, 0.0392 mL, 0.0392 mL, 0.03887 mL, 0.0398 mL Mean- 0.194 mL
Standard deviation 0.6318 mL, 0.1216 mL, 0.1056 mL, 0.0681 mL, 0.0056 mL Mean-0.18654 mL
Sum of coefficients C7H8 + O2 --> CO2 + H2O after balancing