Water at 20° C flows steadily with negligible viscous effects through the pipe shown. Both the pipe exit and top of the manometer are exposed to atmospheric pressure. The fluid in the vertical tube (manometer) is stationary so that the hydrostatic equation can be applied. Find a) The gage pressure at point A (inlet of the pipe) b) The velocity at point A c) The diameter of the pipe outlet The density of water is 62.4 Ibm/ft and 1 lbf s²/ft = 32.2 lbm.

Water at 20° C flows steadily with negligible viscous effects through the pipe shown. Both the pipe exit and top of the manometer are exposed to atmospheric pressure. The fluid in the vertical tube (manometer) is stationary so that the hydrostatic equation can be applied. Find a) The gage pressure at point A (inlet of the pipe) b) The velocity at point A c) The diameter of the pipe outlet The density of water is 62.4 Ibm/ft and 1 lbf s²/ft = 32.2 lbm.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A pipe inclined at 45° to the horizontal (Fig. 2) converges over a length l of 2 m from a diameterd1 of 200 mm to a diameter d2 of 100 mm at the upper end. Oil of relative density 0.9 flowsthrough the pipe at a mean velocity ?̅1 at the lower end of 2 m/s. Find the pressure differenceacross the 2 m length ignoring any loss of energy, and the difference in level that would beshown on a mercury manometer connected across this length. The relative density of mercury is 13.6 and the leads to the manometer arefilled with the oil.
When gage A indicates a pressure of 100 kPa gage, then cavitation just starts to occur in the venturi meter. If D = 40 cm and d = 10 cm, what is the water discharge in the system for this condition of incipient cavitation? The atmospheric pressure is 100 kPa gage, and the water temperature is 21°C. Neglect gravitational effects.
The pressure in a section of horizontal pipe with a diameter of 2 cm is 152 kPa. Water flows through the pipe at 2.80 L/ s. If the pressure at a certain point is to be reduced to 109 kPa by constricting a section of the pipe, what should the diameter of the constricted section be? Assume laminar nonviscous flow. Express your answer in meters to four decimal places. Us the continuity equation and water flow rate to find the speed of the fluid in one region.
Provide complete solution and diagram for this problem. What is the equivalent head of 15cm mercury in water ? A. 10m B. 1.36m C. 2.04m D. 16.34m
The pressure in a water tower is 27,030 Pascals (N / (m ^ 2)) higher than at an open faucet. The density of water is 1000Kg / (m ^ 3). Use Bernoulli's equation to determine the velocity of outflow from the open faucet. the height difference between the top water level in the tower and the faucet is 9 meters, then the velocity of outflow is
(Just Question a.) A water filled pipe has water flowing at v1= 5.90 m/s in a section of pipe where the diameter is d1= 20.2 cm and the pressure is known to be P1= 7.00×104 N/m2 above atmospheric pressure. If the pipe carries the water 3.5 meters up hill without any change in diameter, what is the new absolute pressure within the pipe? After flowing up the hill described above, the pipe narrows to 80% of its original radius, what will be the new water velocity (v2) in the pipe? What will be the absolute pressure (P3) in the smaller pipe? a. What is the volume flow rate through the smaller pipe?
Fluid Mechanics Water flows steadily from the large open tank as shown in the figure. if viscous effects are negligible determine a) the flowrate, Q, in M^3/s b)The manometer reading, h, in m.
The discharge of water through a pipe of diameter 40 cm is 400 litres/s. If the pipe is bend by 135", find the magnitude and direction of the resultant force on the bend. The pressure of flowing water is 29.43 N/cm²
The plunger diameter of a single-acting reciprocating pump is 115 mm and the stroke is 230 mm. The suction pipe is 90 mm in diameter and 4.2 m long. If cavitation takes place at the suction head of 4 m, the barometer stands at 10.3 m of water, and the water level in the sump is 3 m below the pump cylinder axis.3.1 Find the maximum allowable speed to operate the pump3.2 What power is expected in overcoming friction at this speed, take ƒ = 0.01
The plunger diameter of a single-acting reciprocating pump is 115 mm and the stroke is 230 mm. The suction pipe is 90 mm in diameter and 4.2 m long. If cavitation takes place at the suction head of 4 m, the barometer stands at 10.3 m of water, and the water level in the sump is 3 m below the pump cylinder axis.1. Find the maximum allowable speed to operate the pump
A pipe has a cross-sectional area of 16.5cm2 at point A, where the speed of the fluid (water) is 1.2 m/s and the pressure is 2.00 atm. The pipe ascends 3.00 m and narrows to 8.20 cm2 at point C. a) what's the speed of the fluid at point C. b) what's the absolute pressure at point C.
U - tube is used to pressure the difference in water channel. p1= 1000 kg/m3. The orange fluid in the U - tube has a density: p2= 2000 kg/m3. The height a = 10 cm and h = 15 cm. If the pressure at point ① is 111 kPa, what is the pressure at point ② ?