Water flows from a reservoir through a pipeline as shown in the following diagram. The flow is considered frictionless and discharges freely at point C. (a) What is the total head (total specific energy) at point A? (b) What is the total head (total specific energy) at point B? (c) What is the discharge velocity at point C? A 150' (45.7 m) B

Water flows from a reservoir through a pipeline as shown in the following diagram. The flow is considered frictionless and discharges freely at point C. (a) What is the total head (total specific energy) at point A? (b) What is the total head (total specific energy) at point B? (c) What is the discharge velocity at point C? A 150' (45.7 m) B

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter13: Energy And Power

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

If the velocity in a 12-in diameter pipe is 1.60 ft./s, what is the velocity in a 2.5-in diameter jet issuing from a nozzle attached to the pipe?
An orifice having an area of 0.0003 sq. m is located on the vertical side of a tank. The tank has a constant cross - sectional area of 0.40 sq.m. It takes 312 seconds to lower the head from 1.20 m to 0.60 m. Determine the: THUMBS UP GUARANTEED 1. the value of the coefficient of discharge? 2. Using c = 0.60, what is the value of head after 240 seconds from an initial head of 1.20m? 3. Using c = 0.60, what is the time to lower the head from 1.20m to 0.80m?
Water enters a pump through a 150 mm diameter intake pipe and leaves through a 200 mm diameter discharge pipe. If the average velocity in the intake pipeline is 1 m/s, calculate the average velocity in the discharge pipeline.
A full tank consists of a hemisphere of radius 4 meters surmounted by a circular cylinder of the same radius and of altitude 8 meters. Find the work done in pumping the water to an outlet at the top of the tank. a. (83456π/15)γw b. (2752π/3) γw c. (2752π/15) γw d. (83456π/3) γw
Determine whether the flow is turbulent or laminar if a fluid flows at 0.001?^3/? through a 100mm diameter pipe.
If the flow rate of water through the pipe system shown in the following figure is 0.050 m^3/s under total head loss of 9.0m, assuming a C coefficient of 120 for all pipes determine the following A.The head loss in pipe B Choices: 1.975m,4.465m,2.560m,5.886m B.The flow in pipe B in m^3/s Choices: 0.019,0.034,0.029,0.023 C.The diameter of pipe C Choices: 190mm,180mm,160mm,170mm
Three pipes of lengths 800 m, 600 m and 300 m and of diameters 400 mm, 300 mm and 200 mm, respectively, are connected in series. The ends of the compound pipe are connected to two tanks, whose water surface levels are maintained at a difference of 15 m. Determine the rate of flow of water through the pipes if f= 0.005. What will be diameter of a single pipe length 1700 m and f = 0.005, which replaces the three pipes?
At a water-treatment plant, water (68ºF ) flows from tank A to tank B at a rate of 0.50 cfs through a 3-in, cast-iron pipe that is 200 feet long. Determine the difference in water surface elevation between tanks (open to the atmosphere) if there are two bends(R/D=2.0) and a fullyopen gate valve in the pipeline
The discharge of water in a 25 cm diameter pipe is 0.05 m3/s. What is the mean velocity?
Pipelines 1, 2, and 3 are connected with parallel to each other with pipeline 1 having diameter of 884 mm, 797 m. long, pipeline 2, 608 mm diameter, 845 m long ad pipeline 3, 641 mm diameter, 773 m long. The 3 pipes carry a combined discharge of 0.993 m3/s. Assuming f = 0.055 for all pipes. Compute the head loss of pipeline 3 in m. Round 3 decimal places
The discharge of water through a rectangular channel of width 6.0 m, is 18 m3/sec when depth of flow of water is 2.0 m. draw Specific Energy Graphs and find : a) Critical depth b) Specific Energy c)Minimum Energy d) Critical velocity
Calculate the discharge, in ft3/s, m3/s, and liter(s)/s of the stream according to the given measurement: cross sectional area is 18ft2, and velocity is 0.5 ft/s. Show your math-work.