Answered: Water R= 6 m 6 m 6 m

Engineering

Mechanical Engineering

Water R= 6 m 6 m 6 m

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.88P: Compute the surface area of the axi-symmetric domed structure.

See similar textbooks

Related questions

Q: Q2: Gata AB Fig, below, 6m wide and weight 5 kN, it is hinged at B, determine the water level h,…

Q: A 3-m-high, 5-m-wide rectangular gate is hinged at the top edge at A and is restrained by a fixed…

A: The schematic of the diagram is given below:

Q: A long, solid cylinder of radius 2 ft hinged at point A is used as an automatic gate. When the water…

A: Hydrostatic force and its direction to be calculated

Q: A closed cylindrical vessel 1.2 m in diameter and 2.1 m high is filled with water to a height of 1.6…

Q: (A) In Fig. (4), the rectangular tank have internal width (700cm) , find. a- The value of depth (H).…

A: Given, Width (W)= 700 cm = 7 m (a) Taking figure into consideration, The density of oil…

Q: The semicircular plate as shown in the figure is 4 ft long and acts as a gate in channel. Determine…

Q: Problem 3 A gate is 1.5m in width and hinged at point A. Another point on the gate, B, is resting…

Q: 4. Find the force on the following triangular submerged plate in water and location of its center of…

A: Introduction: The pressure produced by a fluid at equilibrium owing to gravity at a specific place…

Q: Gate AB in Fig. of pressure. is 1.0 m long and 0.9 m wide. Calculate force F on the gate and the…

Q: Q4/ A4-m-long curved gate is located in the side of a reservoir containing water as shown in Fig.…

Q: In Fig. , curved section AB is 5 m wide into the paperand is a 60 ° circular arc of radius 2 m.…

Q: The distance between the two plates, which are 2 m x 2 m in size and parallel to the earth surface,…

A: Given data: The area of the plate is A=2×2=4 m2 The distance between the plate is h=9 mm=0.009 m The…

Q: Consider a dam of width D and a water body of a depth of H, as shown in the figure below. Determine…

A: In this question we can consider dam wall as vertical surface submerged in water and by figure it is…

Q: In the pressurized oil tank (p = 60 kPa gage), a triangular gate ABC is pivoted along the lower…

Q: A rectangular plane surface b = 1 m and d = 3 + 0 lies in water such a way that its plane make an…

Q: The hemispherical dome in Fig. (4) weighs 30 kN and is filled with water and attached to the floor…

Q: Watersurface. -3 m hinged. gate P 3 m

A: Given data:-specific weight of water, ω=9810N/m3weight of gate, W=800NNow,length of the gate,…

Q: A circular surface (gate) submerged in water at an inclined angle of 45° as shown in the figure. If…

A: A submerged body underwater experiences a hydrostatic force due to pressure loading. This force is…

Q: A triangular lamina is immersed vertically in water in such a way that its 6 m wide horizontal base…

Q: A wall is made from a quarter circle and flat plate with h = 4 m, R = 1.5 m, and w 3 m. The water is…

A: we will use projected area for horizontal force for vertical force we will use weight of fluid that…

Q: A 5-m-high, 8-m-wide rectangular gate is hinged at the top edge at A and is restrained by a fixed…

A: Given: Dimensions of the Gate=5m×8m Assumption Density of water (ρ)=1000kg/m3

Q: A vertical rectangular wall with a width of 20 m and a height of 12 m is holding a7-m-deep water…

A: Given data: H=12 mw=20 mh=7 m Need to determine the resultant hydrostatic force acting on this wall.

Q: If the wall AB shown is 48 meter long calculate the total force (in the uhlt of KN) on the wall due…

Q: The two sides of a V-shaped water trough are hinged to each other at the bottom where they meet, as…

A: Given data: The angle of each side is θ = 45o. The width of the each side is x = 0.75 m. The length…

Q: QUESTION 5 A vertical rectangular plate with a width of 16 m and a height of 13 m is located 4 m…

Q: Find the location of resultant force( F)of the water on the triangular gate and the force(P)…

A: The force on a plate that is fully submerged in water can be evaluated using the formula given below…

Q: A semicircular 40-ft-diameter tunnel is to be built under a 150-ft-deep, 800-ft-long lake. Determine…

A: Given data: Depth of the lake, hd =150 ft Length of the lake, l = 800 ft Diameter of tunnel, d = 40…

Q: A long, solid cylinder of radius 2 ft hinged at point A is used as an automatic gate, as shown in…

A: Given datar=2fth=15 fthinged at point ATo find1) hydrostatic force2) weight of cylinder per ft…

Q: Question 2:- For the quarter curve with 60 m wide as shown in fig. below. Determine the vertical and…

Q: 15 ft 2 ft A

Q: An elliptical gate covers the end of a pipe 4 m in diameter. If the gate is hinged at the top, what…

A: Diameter = 4m water is 8m deep find the normal force F

Q: find a) the total force on gate AB in KN and b) the position of the center of pressure in m with…

Q: A car, travelling from Kangar to Padang Besar, has met an accident near the dam. The driver has…

Q: 1. Llyn Cau in Snowdonia, Wales, is a 35.0-m deep glacial lake popular among outdoor swimmers. (a)…

Q: The gate shown is 3.0 m wide (into the page), hinges around the bottom point, and for the purposes…

A: Force acting on the plate due to weight Fw= 2500 * 9.81 = 24525N Sin60 = d/OA OA= d/sin 60 = 2d/ √3…

Q: In Fig. , a one-quadrant spherical shell of radius R issubmerged in liquid of specifi c weight γ and…

A: Given Radius = R Specific weight = γ Depth h >R To find Expression for the resultant hydrostatic…

Q: 3. Shown in the figure is a flat parabolic gate with axis vertical. If the vertex is 2 m. below the…

Q: 3. A semicircular 40-ft-diameter tunnel is to be built under a 150-ft-deep, 800- ft-long lake, as…

Q: A circular plate of diameter 3 m is immersed in water in such a way that its least and greatest…

Q: An elliptical gate covers the end of a pipe 4 m in diameter. If the gate is hinged at the top., what…

Q: The parabolic shaped gate with a width of 6 m shown below is hinged at point B. Compute for the…

A: The pressure exerted by the fluid at a point which is located at a depth of h from the surface is…

Q: Proof that a solid aluminum block of 4 mm x 3 mm x 3 mm, such as shown in Figure QI (a), can float…

A: The surface tension of water at 20 degrees Celsius is 0.072 N/m.

Q: A vertical circular gate ABC is 4 m in diameter and is hinged at B, the middle of the gate. When h =…

Q: Gate AB in the figure below is a 5-ft wide, vertical, rectangular gate, hinged at A and restrained…

Q: What vertical force is needed to keep the 2- m wide (into the paper) cylindrical gate closed as…

A: Given data as per question Radius of cylinder gate =3 ft =0.9144 m Length of cylinder =2 m the…

Q: An elliptical plate, major axis 6 feet and minor axis 4 feet, is submerged vertically until its…

Concept explainers

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.

Question

Gate ABC is a circular arc, sometimes called a Tainter gate ,
which can be raised and lowered by pivoting about point O .
See Fig.. For the position shown, determine ( a ) the
hydrostatic force of the water on the gate and ( b ) its line of
action. Does the force pass through point O ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Answer: 57.4 ft/s=17.5m/sTorricelli's equation does not apply but the simplified Bernoulli's equation does apply.
Answer is: V = 14.17 ft/s
1300 m^3 to t
Find: 1) submergence h 2) radius of circular base along free water surface 3) Metacentric height
A dam with triangular cross section holds back a body of water. The dam has height h. The dam is made of concrete, which has speci…c gravity 3.1. What is the maximum angle, , for which thedam will not tip over about point O?
The three reservoirs system contains water. If L1 = 2000 m, f 1= 0.013, D1 = 1m; L2 = 2300 m, f2 = 0.02, D2 = 0.60m; and L3 = 2500 m, f = 0.023, D3 = 1.20m. Compute Q3 in m3/s.
Pls show complete solution MN = 94 SN = 82
6 and 7 pleeeeeeeeease
Show complete solution pls SN = 93
The Mayflower ship having a displacement of 27000 metric tons and a draft of 10.4 m in ocean (sp. gr. = 1.03) enters in the Legazpi International Port with a specific gravity of 1.0 (seawater). If Mayflower’s horizontal section of the ship at the waterline is 3000 m2, what depth of seawater is required to float the ship? a. 10.63 m b. 10.58 m c. 10.66 m d. 10.54 m
A cylindrical tank with closed ends is filled with compressed air at a pressure of 690 kPa. The inner radius of the tank is 4 m. and it has wall thickness of 10 mm. Determine the magnitude of maximum in-plane shear stress.
Fast pls solve this question correctly in 5 min pls I will give u like for sure Class: Structures 1 Question: locate the centroid of the box section shown, a cross-section often used in bridge construction Answers: Ax=0 Ay=3.92 kn By=11.08 kn Sub.