Water vapor saturated at 150 degrees Celsius (h = 2745.9 kj / kg) flows at an altitude of z = 10 meters and at a velocity of V = 50 m / s. Calculate the total energy of water vapor relative to the ground as J / kg.

Water vapor saturated at 150 degrees Celsius (h = 2745.9 kj / kg) flows at an altitude of z = 10 meters and at a velocity of V = 50 m / s. Calculate the total energy of water vapor relative to the ground as J / kg.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.37P

See similar textbooks

Related questions

Q: A sealed tank containing seawater to a height of 12m also contains air above the water gage pressure…

A: Given, h1 = 12 m guage pressure = 5 atm efflux speed is nothing but the velocity of liquid flowing…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A: Given, Nozzle inlet: Nozzle outlet:

Q: A liquid of density p is filled in a vessel of cross- sectional area A. The vessel has a hole of…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A: h1=3089 KJkgc1= 229 kmhrc1= 229×518=63.61 msech2= 2569 Jkg v2= .63 m3kgA1=.2 m2v1=.31 m3kgNow apply…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

Q: Calculate the total enthalpy of 3 lbs of fluid that occupy a volume of 20 cu.ft. if the internal…

A: Given data, m= 3 lbs V=20 cu. ft. Pressure P= 2 atm =4232.43 lbs/ft2 u= 1000 BTU/lb

Q: 2. Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 74 m/s and leaves the same stage…

Q: the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle is operating steadily…

Q: A pipe that has a diameter of 75 mm and a length of 90 m transports oil of density 850 kg/m3 and a…

Q: flying at an altitude of 16,000 m. Determine its speed in km/h if the GAGE pressure at the…

Q: A reservoir of volume V with an ideal gas of molecular mass M and specific heat ratio k is initially…

Q: Characteristic curves are available for a fan running at 850rpm and passing air of inlet density 1.2…

A: We know that PH,aPH, b=ηa2ηb2.da2db2.ρaρb So, P1=2.2×11008502×1.11.2 P1 =3.37 kpa…

Q: An air compressor delivers 10 ft of air at a pressure of 130 psia and 85°F into an air reservoir.…

A: Write the expression for the ideal gas equation.

Q: Gas is flowing through a square conduit whose section gradually changes from 150 mm (section 1) to…

A: Given:Side of square conduit at section 1, L1=150 mm=0.150 mSide of square conduit at section 2,…

Q: The pressure ratio across a normal shock wave is given by the following equation: P2 P1 P2 P1 Show…

A: The given relation to be proven is : P2P1 = γ+1γ-1ρ2ρ1-1γ+1γ-1 - ρ2ρ1

Q: A gas with a velocity of 300 m/s is flowing through a horizontal pipe at a section where pressure is…

Q: Air at a temperature of 95 F and a velocity of 20 ft/s flows over a hot flat plate, maintained at…

Q: Part A Nitrogen having a temperature of T = 310 K. and absolute pressure of pi = 320 kPa flows into…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

Q: Six kilogram of water has 7166.46 kJ entropy and 7212.12 kJ enthalpy. Determine its (a) temperature…

Q: The speed of an aircraft is given to be 950 km/h. If the speed of sound at that location is 315 m/s,…

A: solution : given that → V = 950 km/n =9503.6ms Velocity of sound ⇒C = 315 ms

Q: The flow energy of 124 li/min of a fluid passing a boundary to a system is 2 KJ/sec. What is the…

A: Given data: Q=124 li/minPower=2 kJ/s Need to determine the pressure at this point.

Q: Calculate the rate of mass flow through the surface S of an fluid with constant density p,…

Q: Air at a temperature of 40 °C is steadily (continuously) inside the pipe as given in the figure.…

A: Given: Initial pressure P1=150kPa Final Pressure P2=110kPa Initial velocity V1=30m/s R=0.287kJ/kg.K…

Q: Send 20 degree Celsius of water at 4.0 [m3 / h]. How many inches of standard steel pipe should be…

A: The volume flow rate is 43600m3s Q = AV43600 =π4×d2×1.5+22d = 0.0284 md = 1.12 inThe diameter at…

Q: a) The air temperature at the outlet: Response ° C b) The cross-sectional area at the outlet of the…

A: From the given data For air Cp=1.005 kJ/kg.KR=0.287 kJ/kg.Km˙= 6500 kghr=65003600kg sec P1=82…

Q: In a central air-conditioning system, 72 kg per hour of air at 150C and 1.1 bar enters a rectangular…

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

Q: What is the mass flow rate of air is flowing at a velocity of 20 m/s through a tube with an area of…

Q: The air in a 7 m x 5 m x 3.5 m hospital room is to be completely replaced by conditioned air every…

Q: A sealed tank containing seawater to a height of 12 m also contains air above the water at gage…

A: The velocity of the water leaving the tank can be calculated using the Bernoulli's theorem which is…

Q: to increase the pressure of a stream of air circulating at 6500 kg / h. The initial conditions of…

A: Given that , m'=6500 kg/hr…

Q: An ideal gas enters a turbine with a velocity of 40 m/s through an inlet pipe with a diameter of 160…

Q: A tea maker whose top (1 point) is open to the atmosphere is completely full. The tea flows from the…

A: we will use Bernoulli's equation to solve this problem p1ρg+v122g+z1=p2ρg+v222g+z2

Q: convergent nozzle is analysed. The nozzle is operating steadily and heat loss is assumed negligible.…

Q: At a particular operating condition, an axial flow compressor has a reaction of 0.6, a flow…

Q: The mean velocity of fluid flow does not change with respect to time at any point is A- Unsteady…

A: The correct answer is option C- Uniform flow. Uniform flow: In uniform flow if the velocity at a…

Q: The cv and cp values of incompressible substances are identical and are denoted by c.

A: The incompressible fluids are those fluids that don't change their properties like volume and…

Q: A gas enters a 2 m diameter cylindrical pressurized tank with an existing pressure of 4 atm at a…

A: Given data, The schematic diagram is Point 1 is the entry point to the cylinder Point 2 is the exit…

Q: An air compressor delivers 10 ft^3 of air at a pressure of 130 psia and 85°F into an air reservoir.…

Q: A sealed tank containing seawater to a height of 12 m also contains air above the water at gage…

Q: Air exits from a reservoir maintained at 15 °C and 400 kPa absolute into a receiver maintained at…

A: Data given - T1 = 15°C = 288 K P1 = 400 kPa For part a)P2 = 200kPa b) P2 = 100kPa

Q: A sealed tank containing seawater to a height of 12 m also contains air above the water at gage…

Q: Specify the pipe required to carry 272.200 kg of steam per hr at 87.9 kg/cm^2 ga, 538 °C, with…

A: 87.9 kg/m^2 = 8620.045 kPa 272.200 kg/hr = mass flow rate = 0.0756111111 kg/s We know that P =…

Q: The flow energy of 24 li/min of a fluid passing a boundary to a system is 2 kJ/sec. What is the…

A: Solution:

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Air at 20oC (density = 1.204 kg/m3) flows towards a rotating cylinder of diameter 1.50 m. If the velocity of the air is 100 km/h and the cylinder rotates clockwise at 220 rpm, determine (c) the maximum velocity of the air around the rotor, and (d) the pressure coefficient at the location corresponding to the maximum velocity.
Wind blows steadily at 7 m/s into the blades of a wind turbine. Compute the mass flow rate of the wind on a turbine with 80-m-diameter blades. The air density is 1.25 kg/m3. Answer in kg/s.
Consider a case in which the air inside the pressurized cabin of a jet transport flying at some altitude is at a pressure of 0.9 atm and a temperature of 15°C. The total volume of air at any instant inside the cabin is 1800 m^3. If the air in the cabin is completely recirculated through the air conditioning system every 20 min, calculate the mass flow of air in kg/s through the system.
Figure 13 shows a steady flow of 40 kg / s of water at 20 ° C through a nozzle if D1 = 18 cm and D2 = 5 cm calculate the average velocity in meters per second in (a) section 1 and (b) section 2
An air compressor delivers 10 ft3of air at a pressure of 130 psia and 85°F into an air reservoir.Calculate the mass of air delivered (lbm).
Imagine a plate 1 m long by 1 m wide at a temperature of 80 °C. Water is passed over its surface at a speed of 1 m/s with a temperature of 40 °C.Calculate the heat dissipated by the plate. Assume the following properties of water at 60 °C: k=0.651 W/mK, Pr=3.02, v =0.478 x 10-6 m²/s.
Use the thermal wind equation to explain the presence of the jet stream.
Water (modeled as an incompressible substance) flows steadily through a circular pipe oftotal length ? = 10 m. The mass flow rate through the pipe is ?̇ = 2 kg s⁄ and the watertemperature drops by 25°C as it moves through the pipe. Pressure losses within the pipeare negligible, as are any changes in potential and kinetic energy of the flowing fluid.a) Determine the rate of energy loss from the water as it moves through the pipe. Youmay treat the water as having a constant specific heat (? = 4.18 kJ kg-K⁄ ). Recall thatfor an incompressible substance Δℎ = Δ? + ?Δ?, where Δ? = ∫ ? ?? and ? is thespecific volume of the substance. Your solution should start with an energy balanceon an appropriately defined system/control volume.b) The air surrounding the pipe is at ?∞ = 25°C and the convection coefficient at theouter surface of the pipe is ℎ = 15 W m2-K⁄ . It is also known that the surfaceemissivity of the pipe is ? = 0.3 and the walls of the room where the pipe is locatedare at ?sur =…
The cv and cp values of incompressible substances are identical and are denoted by c.
Explain the work of Nozzles and diffusers are shaped so that they cause large changes in fluid velocities and thus kinetic energies.
A reservoir of volume V with an ideal gas of molecular mass M and specific heat ratio k is initially at pressure p1 and temperature T1. The reservoir then begins to be supplied at constant flow m˙ and with the same gas, at the inlet temperature given by Te , also constant. (a) Calculate the time required for the final mass of the reservoir to increase by 4 times (m2 = 4m1); (b) Assuming the process is isothermal, calculate the time required for the pressure to from the reservoir increases by 4 times (p2 = 4p1), and calculate the rate at which heat is removed from the reservoir. reservoir Q˙ r ; (c) Assuming that the process is adiabatic, calculate the time required for the pressure of the reservoir increases by 4 times (p2 = 4p1). Calculate the final temperature T2 for this situation.
At what maximum speed does a compressed air torpedo move, which expells 18 kg of air every second at a speed of 118 m/s? The force of water resistance is proportional to the square of the velocity and is equal to 480 N at a speed of 21 m/s. (The solutiom is 44 m/s)