What are the factors affecting the RMS noise voltage of a circuit?

Q: 37. Discuss the causes and consequences of harmonic distortion?

A: Here we discuss about the causes & consequences of the harmonic distortion   NOTE:- As per our…

Q: What are the factors affecting the RMS noise voltage of a circuit?

A: Noise voltage induced in any circuit is due to the ambient temperature in which the circuit is being…

Q: If a high frequency AC signal, whose rms value is √2 V, is applied to a PMMC instrument, then the…

A: Given, A high frequency AC signal, whose rms value is √2 V, is applied to a PMMC instrument,

Q: Peak RMS Phase Instantaneous Average Value Value Value Angle Value (a) 45 A ? ? 45° ? (b) ? 220 V ?…

A: Consider a sinusoidal signalx(t)=Asinωt

Q: What is the value of frequency of dc

A: The number of times a repeated event occurs per unit of time is known as frequency.  It's also…

Q: The microwaves in a certain microwave oven have a wavelength of 12.2 cm. Part A How wide must this…

A: Given : a Wavelength : 12.2 cmLength of oven : L = 6×λ2L = 6×12.22L = 36.6 cm

Q: Why sub transient current magnitude is large compare to steady state current?

A: i) The flux produced by field winding and flux produced by armature winding are assumed to be…

Q: What basic steps are involved in a power quality evaluation procedure?

A: There is wide range of different phenomenon associated with  Power Quality, each phenomenon's have a…

Q: Q3) what is the diffrence between Loss and attenuation ?

A: The solution is given below

Q: values for the same component. This causes different signed power therefore we cannot state whether…

A: Simple solution regarding this chaos: If the current is discharging from any device that means if…

Q: hat is the approximate voltage amplitude and frequency of the waveform below?

A: Disclaimer: "Since you have asked multiple questions, we will solve the first question for you. If…

Q: What's the importance of mutual impedance of antenna elements? Please include an application

A:

Q: Electrical Engineering How to measure the electric field intensity at 2m away from a Parallel…

A: Given data: Charge of the electron q=1.6×10−19C Mass of the electron m=9.1×10−31 kg Acceleration due…

Q: Explain in detail about voltage harmonics ?

A: The harmonics that are one that can arise mostly from the linear loads. As the current harmonics…

Q: phase angle discussion 1-why is there a phase shift in RC cct ? How do we make it exactily 90 degree…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Are the following statements correct or wrong? Justify your answer.  (d) Thyristors are used only…

A: generally thyristors are usually used for High voltage and high current applications at low…

Q: Discussion of power quality aspects that need to be considered before installing the power factor…

A: power factor correction aims to improve power factor and therefore power quality. It reduces the…

Q: . Motor & appliances

A:

Q: Draw the relationship between excitation current and short circuit, and Please explain

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: How

A:

Q: Please write short introduction about AC Circuits - Series Circuits

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: As frequency increases, how does AC circuit resistance change when dealing with an LR circuit?

A: The explanation is as follows.

Q: Which one is not correct? a. Phase is given in radial unit. b. Main frequency of a signal is called…

A: Here some statements are given and we have to find incorrect

Q: Introduction: write about Voltage, Current and Electrical Impedance

A: Voltage or potential difference is the difference in electric potential between two points, which…

Q: What is Hopkinson's test and its advanatage?

A: Testing is very important for any type of machine. So, for testing the efficiency of DC shunt…

Q: Explain in detail (no mathematical expressions) the following terms used in microwave theory:…

A: The transmission line helps in transmission of power from the generation side to the load…

Q: Identify the given statement. The bandwidth required to transmit an angle-modulated wave is…

A: given statement is the bandwidth required to transmit an angle modulated wave is approximately…

Q: What is the term for total AC circuit resistance when dealing with AC inductors and capacitors?

A: According to the given question, it is only required to determine the term for total AC circuit…

Q: Subject - Design electrical circuits for single-phase AC networks Question Discuss the difference…

A:

Q: 5. What is the wavelength in ft of a 60 Hz ac signal?

A:

Q: 2.How Capacitor filter is removing the AC components ?

A: In capacitor filter capacitor connected across output.

Q: Can PSD of a power signal be periodic? а. Yes b. No

A: For example if we have a power signal is that a period signal Cos(w0t) then its psd will be square…

Q: What are Microwaves? Bring out the basic advantage of Microwaves over Co-axial cables and the Fiber…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Given the plot shown in the figure, what is the value of peak overshoot? jao j7= ja s-plane -3 --o4…

A: Using given pole zero plot calculator sets of the second order system.  Now using peak over shoot of…

Q: What is meant by the "envelope" of an AM waveform, and what is its significance?

A: Amplitude modulation is the process through which we get an output AM waveform. It is used in…

Q: What are the three main signal noises and their SI units?

A: From an electrical point of view, the noise is defined as the unwanted form of energy which leads to…

Q: 9. Explain, how Lissajous figures are used for measurement of frequency and phase of a high…

A: LISSAJOUS FIGURE: It is the pattern generated on the screen, when sinusoidal signals are applied to…

Q: Describe an example of CR circuit with diagrams, phase shift between voltage and current. How it can…

A: Circuit diagram of CR circuit is given by, The given circuit is series RC circuit in which…

Q: what is a locus

A:

Q: My question is, there is a way to know if our circuit works in the low frequency or high frequency?

A: The overall response of the amplifier circuit is band pass response. It will frequency coupling…

Q: Draw the butterfly structure of 8-point Decimation in Frequency.

A: Given N=8 We have to draw butterfly structure of 8 point DIT -FFT using decimation in frequency…

Q: 8. Write the trigonometric expression for a sine wave carrier signal.

A: Solution: The carrier signal in terms of the sine wave is represented as, vct=Vcsin2πfctwhere,Vc is…

Q: Why is the negative effect of stray capacitance more pronounced in very high frequency circuits?

A: Stray capacitance-    It is an unwanted capacitance in the circuit.   When this capacitance is…

Q: Determine the diameter of the mouth and HPBW of a parabole refectur with a power gain of 300 and…

A:

Q: What is the difference between the salient pole type and Non- salient pole type ?

A: The explanation of differences is as follows.