Asked Oct 19, 2019

What are the important things to consider when designing an aluminum part that will be manufactured via milling? What if that part is being die-cast?


Expert Answer

Step 1

The important things to consider when designing an aluminum part through the milling machine are,

  • The formation of built-up edge in tool takes place while milling of aluminum part, to overcom...

Want to see the full answer?

See Solution

Check out a sample Q&A here.

Want to see this answer and more?

Solutions are written by subject experts who are available 24/7. Questions are typically answered within 1 hour.*

See Solution
*Response times may vary by subject and question.
Tagged in


Mechanical Engineering

Related Mechanical Engineering Q&A

Find answers to questions asked by student like you
Show more Q&A

Q: In the system shown in the figure, the spring stiffness k = 2 × 103 N/m and the total massof the sys...

A: a) The free body diagram at the instant t, the mass system displaced x distance from the initial pos...


Q: A chamber is divided equally into two parts by a membrane. One side contains Hydrogen, H2, at a pres...

A:  Given information:Chamber is divided into two equal parts.Initial pressure  of hydrogen P1 = 200 kP...


Q: Complete the following table for refrigerant-134a. Show your work and explain how you got your value...

A: From row 1 in the table, the given pressure, P = 80 psia.The enthalpy is given as, h = 78 Btu/lbm.Fr...


Q: Calculate the maximum velocity of slider B if the system is released from rest with x y. Motion is i...

A: Refer the given figure and apply the Pythagorean Theorem.


Q: Question 6 Figure Q6 shows an idealised structure consisting of two rigid bars with pinned connectio...

A: Refer the given figure and apply the principle of moment about point A.


Q: As shown in the figure, air with a volumetric flow rate of 14,000 ft3/min enters an air-handling uni...

A: Determine the specific volume. 


Q: I need help answering problems 10, 11, and 12 pertaining to the print provided in the attachment.

A: 10.The radius of the four corners is 0.44 units.


Q: Determine the tension in the cable and the tension or compression in the strut (a) graphically, (b) ...

A: Consider the following scale parameters.


Q: Determine the expected diffraction angle (in degrees) for the first-order reflection from the (310) ...

A: Given:310 set of planes,wavelength=0.0711nmRcr = 0.1249nm