What are the main parameters necessary for ordering a commercial IC?

Q: 2. If 750 μA is flowing through 11 k of resistance, what is the voltage drop across the resistor? A.…

A: Given data, Current flowing i=750 μA Resistance R=11 kΩ

Q: On full load, a 300 V series motor takes 90A and runs at 15 rev/s. The armature resistance is 0.1…

A:

Q: 10. Given a charge distribution with density px = 5r C/m³ in spherical coordinates, use Gauss Law to…

A: Given, charge distribution density, ρ=5rC/m3

Q: 5. For the circuit of Figure E, find i₁, i2, i3, and i4.

A:

Q: - In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…

A:

Q: 2. Determine the current I in each of the circuits given in Figure B. 1.5 V 7A (a) 3 A (b) Figure B.…

A: We need to find out current for given circuit .

Q: Find / and Vab in the circuit given below, where the value of Vv is 30 V. Vv +1 3Ω ww 10 V + Vab b…

A: The given circuit is shown in below,

Q: A coil has an ac voltage of 120 V. The current through the coil is 104-85° A What is the inductive…

A:

Q: Three capacitors of 5 μF, 10 μF and 15 μF respectively are connected in series across a 100-V…

A:

Q: 5. Solve for all possible values of the real numbers x and y in the following equation: x+iy+2+3i…

A:

Q: Please solve for 0xBC + 0x08 and specify the flag bit results in the STATUS register (C, DC & Z…

A:

Q: Find Vout 10.0 V 2 k 2 k Vout

A: The given circuit,

Q: 4. In ac circuit takes a load of 160 kVA at a lagging power factor of 0.75 when connected to a 460-V…

A:

Q: Q.3 When a line-to-ground fault occurs, the current in faulted phase 'a' is 100A. The zero-sequence…

A:

Q: Types of DC Generators 1. The armature of a separately-excited DC generator has 0.06 effective…

A:

Q: Two long parallel current carrying wires are separated by 5 cm in air and are carrying current of…

A: Given: Current, I1=I2=20A Distance, d=5×10-2 m

Q: Zero Flag explained in a few lines

A: In microprocessors and microcontrollors there required a status flag for every operation performed…

Q: In the given circuit, obtain V₁, V₂, and v3. Assume A = 40 V, B = 130 V, C = 70 V, and D = 30 V. + A…

A: Given, Voltage,  A=40V Voltage, B=130V, Voltage, C=70 V Voltage, D=30V

Q: Simplify the following boolean expression: F = a + (c'ab'd)

A: Given: The Boolean expression is, F=a+c'ab'd.

Q: The supply frequency to the stator of an 8-pole induction motor is 70 Hz, and the rotor frequency is…

A: Given data: Supply frequency, f=70 Hz Number of poles, P=8 Rotor frequency, fr=6 Hz The question is…

Q: Q5: The output signal from an AM modulator is: s(t) = 5 cos(1800nt) + 20 cos(2000nt) + 5cos (2200nt)…

A:

Q: The system that has the transfer function G(s) = Underdamped system Undamped System Critically…

A: Given data, Transfer function is given as, Gs=144s2+6s+144.

Q: Your turn: Determine V3 employing voltage division 6 Volt 102 202 + V3 W + 402 202 w V₂

A: Given data, Circuit diagram is given as,

Q: 0.4-µF capacitor has a charge of 20 μC. How much is the voltage across it? 20 V 30 V 45 V 50 V

A:

Q: A 3-phase, 60 Hz induction motor has two poles. If the slip is 2% at a certain load, determine the…

A: synchronous speed (Ns)=120×frequencyPoles. speed of the rotor = (1-slip )× synchronous speed (Ns).…

Q: Using Nodal analysis and following the given figure, write the equation at node B under this…

A: Given a circuit  Asked to write nodal equation at node B at the given condition.

Q: Let f be the function defined for - ≤ x ≤ π by f(x) = [1 if π/2 ≤ x ≤ π/2 otherwise 0 and then…

A: A Fourier series is a total that sums the sine and cosine waves to depict a periodic function. Each…

Q: In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…

A: When two inductance L1 and L2 are connected in series and coupled through mutual inductance M then…

Q: Explain how basic gates can be realized by NOR gates. Give an example.

A: Basic gates can be realized by using NOR gate,  Basic gates like OR, NOT, AND, Ex-OR, Ex-NOR

Q: A coil has an ac voltage of 120 V. The current through the coil is 10 -85⁰ A What is the inductive…

A:

Q: The zeros of the transfer function * s²+2s+2 s4 +6s3 +4s²+7s+12

A: Given transfer function: F(s)=s2+2s+2s4+6s3+4s2+7s+12

Q: QUESTION 3 A coil has an ac voltage of 120 V. The current through the coil is 10 -85° A What is the…

A: Given data, Voltage V = 120 V. Current I=10∠-850 A.

Q: An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 3.2kHz.…

A:

Q: The gate of a MOSFET transistor is initially uncharged.   A voltage of 3V is applied starting at t =…

A: Charger Q = ∫itdt C . And energy delivered E = ∫VI dt watts .

Q: The zeros of the transfer function s²+2s+2 s4+6s3 +4s²+7s+12 -1 and -2 -2-2j and -2 +2j O-1+jand-1-j…

A: We need to find out the zeros of transfer function .

Q: In the network shown in the figure, each of the resistance is equal to 20. The resistance between…

A:

Q: Sine-wave www 1.0 k generator 1.0 kHz 1.0 V Voltage across R1, VR Total current, I Voltage across L,…

A: In the given questions, we need to calculate the calculated and measured value of voltage across…

Q: If the maximum analog frequency is 50Hz, the minimum sampling frequency to avoid aliasing is 75Hz…

A:

Q: Vo(s) 1. Find the transfer function, G (s) = for the given network below: Vi(s) vi(t) 1H oooo 1H…

A:

Q: Solve for I1, 12, 13, and Vx. 4ΚΩ 220V Hilt M 11 12 a 4ΚΩ 8kΩ 13 Vx Μ 4ΚΩ ΣΚΩ

A: Given that: The circuit is shown below. Find: Using KCL and KVL find I1, I2, I3, and Vx.

Q: * The voltage Vout in the circuit shown is

A: In this question, We need to determine the voltage Vo as shown the circuit. We are solving this…

Q: An analog signal is sampled at the Nyquist rate of  8MHz and quantized into 180 levels. Find the…

A: Given that: Nyquist rate, fS=8 MHz Quantized level, L=180 Find time duration T ( in second) of 1…

Q: Using logic gates, design an active low chip select for the memory a 256 K memory device starting at…

A: The Memory device starts at address=38000016 Active low chip select memory =256 k The memory space =…

Q: A workshop 100 m x 50 m is to be illuminated with intensity of illumination being 50 lux. Determine…

A: Given: The workshop is dimension is 100 m x 50 m The illumination is 50 lux The coefficient of…

Q: O G .30 Is 60 40 5

A:

Q: 39A ww 3.2 type your answer... 13Ω www The circuit above is in DC steady state. What is the value of…

A:

Q: Question 2 For a two pole-pairs, 50 Hz, 3-phase synchronous motor, the speed of rotor is 1450 rpm…

A: Given: A 3-phase synchronous motor has, Number of pole pair is 2. Frequency, f=50 Hz.

Q: Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3- line…

A: Given data, No. of insulators n=3 Current Ic=CeC=0.15 Line voltage VL=33000 V

Q: Q.3 When a line-to-ground fault occurs, the current in faulted phase 'a' is 100A. The zero-sequence…

A:

Q: How would 0.75V be encoded for a step of 3.84mV?

A:

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.