Start your trial now! First week only $4.99!*arrow_forward*

Question

What is the difference bewteen a grounded control system And a floating control system?

Tagged in

Engineering

Electrical Engineering

Find answers to questions asked by students like you.

Q: The question is attached below

A: Click to see the answer

Q: what is value of current (I).

A: Given circuit is -

Q: How is the size of the overload heaters selected forma a particular instalación?

A: Overload heaters: They are current sensing unit used in overload relay. It is used to protect a moto...

Q: Design a parity checker circuit for a 4-bit data.

A: Click to see the answer

Q: Explain ARM Cortex M4 controller (STM32F407) and compare ARM Cortex processors, e.g. M0,M1,M2,M3,M4 ...

A: ARM Cortex M4 controller (STM32F407) can be defined based on certain characteristics, these are expl...

Q: Q2/ Find the dimensions of arectamgular box oPen at the top having Volume of 32m

A: Given volume of rectangular box Surface area of rectangular box open at the top

Q: What is the resonant frequency

A: The mutual inductance is determined as:

Q: Questions: - 1-why does the speed fall slightly when the d.c. shunt motor is loaded? 2- What is the ...

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question s...

Q: Suppose the waveforms iare those of an ECL gate with VL = −2.6 V andVH = −0.6 V, and t1 = 100 ns, t2...

A: The ∆V is the difference between VH and VL: Thus, the value of V90% and V10% are respectively:

Q: Please do part D and E

A: Click to see the answer

Q: 1. What is output vortage Vo of the below chacylt 15V 2v 4.7K JOKN +15V 4-7KA 2KA 4.7KA JOKN 4-7KN

A: Modified circuit of the given circuit is:

Q: Sketch the output voltage of the circuit shown in FigureP13.74 to scale versus time. Sometimes, an i...

A: Given data: The output voltage is: -10 V The resistance is: 10 kΩ. The expression for the output vol...

Q: a. Consider the circuit as shown in figure 3. 150V 3.5kQ Vout 1.5kQ { VGT= 1.2V 0.4 µF; IGT = 180|LA...

A: Click to see the answer

Q: Please, I need to solve this question

A: Since the counter is counting to the number 15, the required number of the flip-flop will be four to...

Q: Use Kirchhoff's laws to find the current. Picture attached.

A: Given data: The current flowing through 4 Ω resistor is I1, The current flowing through 12 Ω resisto...

Q: S.4) the length of a three-phase power transmission line with a Nominal operating voltage of 69 kV i...

A: Given: Nominal operating voltage, Transmission line impedance, Length of transmission line, Power of...

Q: Use the node-voltage method to find the power dissipated in the 5 Ω resistor in the circuit shown.

A: Redrawing the circuit diagram,

Q: Q: Explain in details with all figures and equations the modulation index of Amplitude Modulation (A...

A: Click to see the answer

Q: With all explanation please

A: Butterworth filter: This is a type of filter which is having a flat frequency response in the passba...

Q: find voltage Vxy. Quick.

A: Given circuit is -

Q: The D flip-flops of Figure P7.83 are positive-edge triggered. Assuming that prior to t=0, the states...

A: Truth table of D flip flop

Q: Find :ResponsesSteady stateSteady state errorRouth stability

A: Click to see the answer

Q: The circuit has no initial stored energy. At t=0, the switch closesand the circuit is driven by a si...

A: Given a circuit in which initial conditions are zero and Formula and concept: KVL is used here and ...

Q: (iv and V)last two questions

A: In 12-bit signed integer, MSB is use to represent sign and rest of 11 bits are used to represent the...

Q: A 400 Ω resistor, a 2.5 mH inductor, and a 40 nF capacitor are inseries. Give the numerical value of...

A: Capacitance is given,

Q: The ac equivalent circuit for an amplifier is shown . Assume the capacitors have infinite value, RI ...

A: Write the given information in the question.

Q: A C-S amplifier is operating from a single 9-V supply. What is the maximum value of VGS −VT N that c...

A: Click to see the answer

Q: If a given second-order system is required to have a settling time (2% criterion) less than 4 sec, f...

A: It is given settling time is less than 4 sec for 2% criterion. For a second order system for 2% crit...

Q: What are the noise margins of a minimum size CMOS inverter in which both W/L ratios are 2/1 and VDD ...

A: Click to see the answer

Q: (a) What are the Q-points of the transistors in the amplifier as shown if I1 =500 μA, R1 =1MΩ, I2 = ...

A: Click to see the answer

Q: 14. Fin 2KL 5KA IKA 0-1uf 1OKA V. -Vo

A: Click to see the answer

Q: find Steady state responsesSteady state error

A: Click to see the answer

Q: For the RLC circuit shown below, Derive an expression for the transfer function VR(S) v(s) G(s) = Co...

A: Convert each element of the circuit in s domain, then Write Voltage divider rule and find VR(s),

Q: Simplify the given Boolean function in SOP form using K-map F (A,B,C,D,E) =Σm(8,9,10,11,13,15,16,18,...

A: Click to see the answer

Q: Calculate the rms value of the half-wave rectified sine wave shown in Figure P5.12.

A:

Q: Find the time-domain expression for the current in the inductor . Assume the reference direction for...

A: Drawing the circuit in s-domain, Applying current division to find the current through the...

Q: Sketch |F(ω)| versus ω when A=10 and τ=0.1. Hint: Remember that|F(ω)| is an even function of ω.

A: Given data: The amplitude of the given waveform A=10 The value of τ=0.1

Q: The magnetic field through a circular loop of radius 10.0 cm varies with time as shown in the accomp...

A: Given: N =1; r = 0.10 m; A = πr2 = π(0.1)2 0.0314 m2 Induced emf is given by the given equation; An...

Q: Consider a real sequence x[n] with period N =5 and if c̟ is the complex Fourier series coefficient o...

A: Click to see the answer

Q: Please, I need to solve this question

A: Click to see the answer

Q: Ideally, we want the voltage for a Zener diode to be constant in the breakdown region. What does thi...

A: As it is known that the voltage of an ideal Zener diode is constant in the breakdown region, and the...

Q: 3. Design a unity gain second order Butterworth filter which allows frequency up to 5 kHz. Use Op-am...

A: The circuit can be drawn with the help of multisim as, Its corresponding amplitude can be obtaine...

Q: Design a noninverting amplifier (as shown ) with a gain of 2.5. Use resistors from Appendix H. You m...

A: As the given op-amp is ideal, no current flows into the terminal of op-amp as well as it follows the...

Q: The power to a device is 40 joules per second (J/s). How long will it take to deliver 640J?

A: Given data: To power the device power required is P= 40 Joules/sec The energy required to be deliver...

Q: 2. Design apaxity checker cct for atbt d thea implement its cet dingfam.

A: The truth table for parity checker is mentioned as, If the parity means the no. of 1’s from the 4-b...

Q: 15. Determine v(t) in the circuit shown below. Answer: v(t) = 10 – 5(1-2t)e 10 V IH 16. The response...

A: Click to see the answer

Q: How to solve this question?

A: Click to see the answer

Q: A discrete-time signal, x[n], is shown below. Sketch each of the following signals.

A: Hi there !! Thank you for your question. Since you have asked multiple questions, with multiple part...

Q: The magnetic circuit shown in Figure P13.11 hastwo parallel paths. Find the flux and flux density in...

A: Given values N = 1000 turns, I = 0.2 A, lg1 = 0.02 cm, lg2 = 0.04 cm, µr = 1 Expression of reluctanc...

Q: The rotor winding current for a four-pole synchronous ac generator with a distributed rotor winding ...

A: poles =4, winding factor=0.9, air gap length =0.6 mm, number of turns =263, peak flux density =1.6 T...