What is the elevation at point A, C, and E?

Q: 4. A building 38m X 45m is to be laid out with a 50m long metallic tape. If during standardization…

A: 4. a) Width = 38 m Length = 45 m Tape Length, TL = 49.950 m Nominal Length, NL = 50 m Correction =…

Q: Explain grid leveling.

A: LevelingLeveling is the method or procedure to determine the relative altitude of any point on the…

Q: Draw the 1 ft contours for the grid elevations below.

A: Contours are the lines that drawn by joining the equal elevations.  Contour interval is the vertical…

Q: What is DALR line?

A: Lapse rate: The rate at which an atmospheric variable that shows the variation of moist adiabatic…

Q: Where is tangent?

A: Answer : We know that slope by Area Moment Method is given by the angle between the tangents drawn…

Q: The elevation of a point is the vertical distance a. distance from level line b. measured from the…

A: Option C is correct  Mean sea level or any selected datum

Q: Arrange the following description in the form of profile level notes and sketch the profile. A level…

A: BS + RL = HI HI – FS = RL HI – IS = RL

Q: What is Dimension D? Setback = 0.252, Bend Allowance = 0.345

A: The given values are as follows,The set back =0.252The Bend allowance=0.345To determine The…

Q: 25° 50° C. A 51

A: Consider the force diagram of the system shown below. The x component of the resultant force is…

Q: How did the angle become 85 degrees on the one encircled with red pen below?

A: The sum of angles T a point on a straight line is 180°.

Q: A triangular lot has the following azimuths and distances. LINES BEARING DISTANCE 1-2 180°00 unknown…

A: Given  Bearing of 3-1line =400 and iTs length is 960.22m

Q: What is the contour interval?

A: Contour may be defined as the imaginary line passing through the points of equal  or same elevation.…

Q: Draw the plan and elevation of the given line diagram. W. W.C V D,+ 2100x1200 KITCHEN 3600x2800 BATH…

A:

Q: Where is the southwest corner of Section 32, T1N, R1E, Humboldt Meridian located? O About 2 miles…

A: The Humboldt meridian in California longitude 124° 07' 10" west from Greenwich, common points the…

Q: cross-sectional area c

A:

Q: 2. What is the Length of Perimeter Line 1-2 in meters? 3. What is the Length of Perimeter Line 2-3…

A: Length of Line 1-2 = 12.53 m Length of Line 4-5 = 13.60 m Length of line 5-6 = 6.79 m

Q: What are cutoff lines?

A: The cut-off line is a:

Q: How many divisions are on the vernier scale?

A: A vernier scale is a visual representation that uses mechanical approximations to obtain an exact…

Q: What are inaccessible points?

A: Points which cannot be viewed via ranging rods or other instruments directly from a point of…

Q: Define the angle of repose ?

A: In granular matters, the steepest angle that is formed with the horizontal plane when there is a dip…

Q: Define Aerodrome

A: To define: Aerodrome

Q: the elevation of the contour line that has the highest elevation?

A: From the contour line having elevation 495m towards the counter line having elevation 500m, we can…

Q: Q4. Given the line DE is parallel to AABC, complete the horizontal projection of AABC. d'e

A: Given Data given the line DE Is parallel to triangle ABC , complete the horizontal projection of…

Q: 5. What does the "Area Rule" mean and when is it applied? 本本

A: When the aircraft approaching speed of sound, at some sections the flow tend to become supersonic in…

Q: Give the location dimensions to the three (3) Ø.437±.005 holes from B

A: Consider the given plan.

Q: What is the angle of inclination of the resultabt with respect to the horizontal in degrees?

A:

Q: Explain: 1) Elevation  2)Mean sea level 3)Bench mark

A: 1) Elevation of any point or location in surveying is defined as the vertical distance of that point…

Q: What are different local attractions that affect compass?

A: The deflection of magnetic needle from its true position is called local attraction. The different…

Q: 50 A

A:

Q: 1. Calculate the total area of the given plan. Assume that all the dimensions are given in meter.…

A: Given plan

Q: Given the coordinates (0,0) (0,-3) (-5,-4) (-10,-2) (-10,0) solve for the area

A:

Q: RELATIVE COORDINATES Y Figure 5 start with Jabsolute coordinates 21 18 10 -6.5 7 -6.5 -10 11 -2 1 11…

A: Given:- Figure 5 X Y 21 18 10 6 -6.5 7 -6.5 -10 11 -2 1 11 -12 -3 3 -9 Figure…

Q: Q1: determaine the coordinates of the centeroid of the snaded 40 30

A: The moment of inertia depends on the following factors, The density of the material Shape and size…

Q: Practice problem 1. A building 38 m x 45 m is to be laid out with a 50- m long metallic tape. If…

A:

Q: What is the length of course 3-4*

A:

Q: May I ask where did 45 N in step 1 come from?

A: It has been given that to ask explanation in 1st step in solved problem. Please refer step 2 for…

Q: Determine the x- and y-coordinates of the trapezoidal shape. у 0.88h 0.39h Answers: (X, F) =(L

A: Let divide the trapezoidal into two regular shape.From area (1),A1 = 12×(0.88h - 0.39h)×h =…

Q: SANITARY PLANNING LAYOUT " E.   ISOMETRIC WATERLINE LAYOUT

A:

Q: Which shape has more sides than a quadrilateral?

A: A polygon can be defined as a two-dimensional shape that is formed by a set of line segments forming…

Q: Point 1-2 S. 7’’ 58’ W, 16.87m Lot-17 Point 2-3 N. 85’ 57’ W, 12.00m Road (6.0m wide) Point…

A: given data to plot given technical description LOT-16     Point 1-2 S. 7’’ 58’ W,…

Q: The following tabulation (see image) gives elevations of points over the area of a 60-by-100 ft city…

A: We need to draw contour map

Q: Discuss about rectangular coordintes

A: A Cartesian coordinate system in a plane is a system of coordinates that uniquely identifies each…

Q: Arrange the following description in the form of profile level notes complete to elevation. A level…

A: Given:- A level is set up to take up the reading The reading of the benchmark = 3.120 m The…

Q: What is geoid heigh?

A: The height of geoid above the reference ellipsoid is known as geoid height.

Q: In a survey of a piece of oceanfront property, measurements of the distance to the water were made…

A:

Q: The choices are 455, 450, 440 and 445 kN

A:

Q: What is the elevation of point A i

A: