I need the answer as soon as possible The following structure was used to hang an ornamental container. The brackets holding thestructure OA can oppose a maximum torque of 315 Nm. What will be the largest weight of theornamental container could be supported by the structure to avoid rotation about OA axis./Struktur berikut digunakan untuk menggantung hekas hiasan. Pendakap yang memegang struktur OA bolehmenahan tork maksima 315 Nm. Apakuh nilai berat terbesar bekas hiasan yang boleh disokong oleh strukturuntuk mengelakkan pusingan pada paksi OA.1.5 m1.3 m5501.8 m1m35°

Given: Moment about OA is 315 Nm To determine W

Answered: What will be the largest weight of the

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.75P

See similar textbooks

Similar questions

This airplane nose wheel assembly is raised by applying a torque M, as shown. The arm AD and the wheel have a combined weight of 100lbs, and the center of gravity is at G, as shown. Determine the torque required to maintain the assembly at the configuration shown in the following figure (D is directly below B and ?= 15°).
A uniform beam that 10-m long is being supported by two men, one man at each end. The weight of the beam. Is 100-N. If the first man supporting at the right side exert twice as much as the second man on the left, where must a 50-N motor be placed (measured from the first man) on top of the beam? Show complete solution.
What is the mass supported as shown, when the torque created by an axis at position A is 1800 mN?
2. ANSWER A AND B WITH DETAILED SOLUTIONS AND COMPLETE FREE BODY DIAGRAM
A loaded truck is transmitting 10 kN pressure on each wheel. The centre of gravity of the loaded truck is 1·2 m above the road level and the centre to centre distance of wheels is 2 m. Find the pressure exerted by the inner and outer wheels, when the truck is going round a curve of 440 m radius at 48 km.p.h.
Calculate the center of mass of the 6 lb right angle bar assuming constant density.
Find the force P needed to hold the 10-m-long cylindrical object in position as shown in figure.
2. answer B C and D including free body diagram
Q.) A loaded scow has a draft of 1.8 meters in fresh water when erect. The scow is 6 meters wide and 12 meters long and 2.4 meters high. The center of gravity of cow is 1.8 meters above the bottom along the vertical axis of symmetry. What is the maximum single weight that can be moved transversely from the center of the scow and unloaded over the side without sinking the scow?SHOW ALL SOLUTIONS AND THE FIGURES THAT SUPPORTS THE SOLUTIONS
The structure AB supports a suspended 2-Mg (megagram) mass. The structure isattached to a slider in a vertical slot at Aand has a pin support at B. What are thereactions at A and B?
answer A B and C with complete solution and free body diagram
please illustrate the corresponding free body diagram

SEE MORE QUESTIONS

Recommended textbooks for you

International Edition---engineering Mechanics: St…

Mechanical Engineering

ISBN:

9781305501607

Author:

Andrew Pytel And Jaan Kiusalaas

Publisher:

CENGAGE L