Answered: What will be the value of the intrinsic…

What will be the value of the intrinsic carrier concentration of a semiconductgor is the equilibrium electron and hole concentration are 2.25x1016/cm3 and 1.5x1015/cm3 respectively?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter1: Atomic Structure

Section: Chapter Questions

Problem 6RQ: How many valence electrons are generally contained in materials used for insulators?

See similar textbooks

Related questions

Q: What is the difference between the outputs of the circuits (3.1 through 3.6) with ideal and silicon…

A: When Vin>0, the diode D1 acts as open circuit and remains off the output voltage is Vout=0 When…

Q: #10

Q: Diode current at 300k having current of 1mA; certain germanium diode requires forward bias of 0.1435…

A: The conductivity of semiconductor is lies in between conductor and insulator. The conduction in…

Q: Crystal diode of germanium bonded to the front bias in ser With equipped capacity (10V) load…

A: In this question , crystal capacity and load resistance is given.....We have to find out current…

Q: Find the type and electron and hole concentrations in a silicon sample at room temperature if it is…

A: Boron concentration= 1016/cm3 Phosphorus concentration= 2×1015/cm3 The equilibrium hole…

Q: P6.98 For abrupt silicon p-n juntion at 300K has acceptor atom Na=10^(18)cm^(-3) and donor density…

A: The conductivity of semiconductor is lies in between conductor and insulator. The conduction in…

Q: From the sketched curves, determine the threshold voltage for each LED. Determine also the forward…

A: Threshold voltage of diode :It is the minimum voltage needed to create a conducting path along…

Q: What are the p-layers of silicon separated by a depletion layer from an n-type layer

A: The explanation is as follows.

Q: Using complete diode model and assuming that the forward resistance of thediode is 152 and a…

A: In the piecewise model of diode we replace the diode with a constant battery with a series…

Q: The o/p voltage of a quadrupler is 540 V What min. PIV rating must each diode have?

A: Given Output voltage of the quadrupler is V0=540 v

Q: From the given semiconductor diodes which will act as a source of microwave

Q: T10. Fermi energy level for intrinsic semiconductors lies (a) At middle of the band gap (b) Close to…

A: Fermi energy level for intrinsic semiconductor is depends upon the number of holes in valance band…

Q: The depletion region in a PN junction is shown in the picture below. What is the relationship…

Q: how much is the nominal current with which a LED diode with semiconductor material (wavelength) LED…

A: (LED)light emitting diode is an electric component which emits light if the electric current flows…

Q: In a p-type silicon sample with the hole concentration is equal to 2x1016 cm³. If the intrinsic…

A: Given Data: p = hole concentration = 2 x 1016 cm-3 e = electron concentration = required ni =…

Q: Silicon is doped with 1016 boron atoms/cm3. How many boron atoms will be in a silicon region that is…

A: Considering the silicon is doped with the 1016 boron atoms/cm3. The number of the atoms can be…

Q: A silicon diode has a saturation current of 7nA at 25° what is the saturation current at 720C?

Q: As a project manager in your workplace, you have been asked to propose a reasonable cross-sectional…

Q: (iii) The number of intrinsic carriers in a semiconductor |/ Will be determined by the temperature…

A: Intrinsic carrier concentration depends on the temperature. As temperature will increase covalent…

Q: Q: calculate concentrations of carriers in silicon doped by acceptors Na=1014 cm³ at: (a) 0°C

A: Given data : Na=1014 cm-3 Concentration of semiconductor directly dependent on the temperature given…

Q: A single crystal intrinsic semiconductor is at a temperature of 300 K with effective density of…

A: Applying the following formula Ec+Ev2-Efi=kT2lnNcNv Substuting the values given in question, we get…

Q: Capacitance per unit area at no reverse bias is two pF/cm². For a step graded diode of area 5cm²,…

A: According to the question, it is given that Capacitance = 2pF/cm2 Area = 5cm² Reverse bias voltage =…

Q: QI: Using a piecewise linear diode models having an ideal diode, VB = 0.7N, and Rp = 20 0 for each…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Consider an n-type silicon for which the dopant concentration ND =10^16/cm^3 find the electon and…

Q: Determine vo and the required PIV rating for each for each diode.

Q: Semiconductor LED's have a slow response time and hence a low frequency operation and low band width…

A: Semiconductor LED's have slow response time because their produced photons are due to injected…

Q: What is the zero-bias junction capacitance per cm2 for a diode with NA =1018/cm3 on the p-type side…

Q: Sketch the voltage across RL of the given circuit assuming that the diode is silicon. Indicate the…

A: The given circuit is a positive biased clipper. During the positive input the wave will be clipped…

Q: Estimate the ratio of the electron densities in the conduction bands of gallium arsenide (Eg 1.42…

A: The electron density in the conduction band is, ne=4.83×1021T32e-Eg3KT (e/m3) The given data's are,…

Q: In a p type Si sample, the hole concentration is 2.25x1015/cm3. The intrinsic carrier concentration…

A: The law of mass action states that the product of the electron concentration (n) and hole…

Q: A single crystal intrinsic semiconductor is at a temperature of 300K with effective density of…

Q: diode with a voltage drop in the forward direction of 0.7V at 1.0mA and

Q: Find the position of the intrinsic Fermi level with respect to the center of the bandgap in silicon…

A: Given, Ti=400 Kmn*=1.08momp*=0.56mo

Q: A diode has wdo = 1.5 μm and φj = 0.8 V. (a) What is the depletion layer width for VR =5V? (b) For…

A: Given data: wdo=1.5 μmϕj=0.8 V a) The expression for the depletion layer width is given as,…

Q: 4. The band gap is the energy difference between the valance band and the conduction band. In any…

A: The bandgap is the difference between the valence band and the conduction band. The conduction band…

Q: In an experiment, the magnitude of the electron drift current equals the magnitude of the hole drint…

A: If n represents the equilibrium concentration of electrons in a semiconductor, then in the presence…

Q: Determine the diode current at 35°C for a silicon diode with Is = 0.1 μA at a reverse-bias potential…

A: In the question, Determine the diode current at T= 35°C A silicon diode Saturation current Is = 0.1…

Q: Schottky diode is formed by joining a doped semiconductor region with a metal. Select one: True…

Q: Determine the shot noise for a diode with a forward bias of 1.40 mA over an 80kHz bandwidth.

A: The solution is given below

Q: 5. In a P-type germanium, nį = 2.1 × 1019 m-³density of boran 4.5 x 1023 atoms /m³. The electron and…

A: (a) Calculate the conductivity before the addition of boron atoms.…

Q: In a N-type semiconductor, the positive of the Fermi level O a. Is lower than the centre of energy…

Q: The applied electric field in p-type silicon is E=10V/cm. The semiconductor conductivity is…

A: given E= 10V/cm conductivity o= 1.5 ohm cm-1 area= 10-5 cm2 we have to find drift current

Q: Determine the diode current at 20◦C for a silicon diode with its reverse saturation current at 50nA…

A: I'm this question we will find diode current of silicon diode.....

Q: The fermi level of a n-type material is located near the band. The fermi level of a p-type material…

Q: The hole concentration in a germanium semiconductor at T = 300 K is po = 2 X 1016 cm -3 a) Determine…

A: We need to analyse the given semiconductor .

Q: compound semiconductor intrinsic level is found to be 0.0003ev below the mid gap at 300l what is the…

A: We need to find ratio for electron mass to hole mass .

Q: A simple Ge n-i-n photo-detector sample has a length ofL=30 pm and a hole lifetime of 49p. Ifa…

A: According to the question we have to find the value of Gain.

Q: Determine the diode current at 25°C for a silicon diode with Is = 10 nA and an applied voltage of…

A: we need to determine diode current.

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

What will be the value of the intrinsic carrier concentration of a semiconductgor is the equilibrium electron and hole concentration are 2.25x10¹⁶/cm³ and 1.5x10¹⁵/cm³ respectively?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the zero-bias junction capacitance per cm2 for a diode with NA =1018/cm3 on the p-type side and ND = 1015/cm3 on the n-type side. What is the diode capacitance with a 9 V reverse bias if the diode area is 0.02 cm2?
What is the zero-bias junction capacitance/cm2 for a diode with NA = 1018/cm3 on the p-type side and ND = 1020/cm3 on the n-type side? What is the diode capacitance with a 3-V reverse bias if the diode area is 0.05 cm2?
3. Consider a silicon with intrinsic carrier concentration ni of 1010 cm-3 at room temperature.It is then doped to p-type doping with a concentration of NA = 5x1017 cm-3. What is thelocation of the Fermi level relative to the conduction band? (Hint: NC = 2.8x1019 cm-3).
Consider an n-type silicon for which the dopant concentration ND =10^16/cm^3 find the electon and hole concentration at T= 350 K
Compare the approximate radiative minority carrier lifetimes in gallium arsenide and silicon when the minority carriers are electrons injected into the p-type region which has a hole concentration of 10^18 cm−3. The injected electron density is small compared with the majority carrier density.
A silicon semiconductor material at T = 300 K is doped with arsenic atoms to a concentration of 2*10 ^15 cm -3 and with boron atoms to a concentration of 1.2*10 ^15 cm -3 . (a) Is the material n type or p type? (b) Determine n0 and p0 . (c) Additional boron atoms are to be added such that the hole concentration is 4*10 15 cm -3 . What concentration of boron atoms must be added and what is the new value of n0? Please answer in typing format
Find the type and electron and hole concentrations in a silicon sample at a temperature of 400 K if it is doped with a boron concentration of 1016/cm3 and a phosphorus concentration of 2×1015/cm3.
Silicon is doped with a boron concentration of 4×1018/cm3. Is boron a donor or acceptor impurity? Find the electron and hole concentrations at 300 K. Is this material n-type or p-type? Find the electron and hole mobilities. What is the resistivity of the material?
What is meant by the PIV rating of a diode?a) Maximum reverse bias potential which can be applied across a diode without breakdownb) Maximum forward bias potential which can be applied across a diode without breakdownc) Minimum potential required by a diode to reach conduction stated) Maximum power allowable to a diode
Calculate the built-in potential and depletion-region width for a silicon diode if NA is increased to 2×1018/cm3 on the p-type side and ND =1020/cm3 on the n-type side.
Find the type and electron and hole concentrations in a silicon sample at room temperature if it is doped with a boron concentration of 1016/cm3 and a phosphorus concentration of 2×1015/cm3.
Estimate the amount of free electrons and holes in a N-doped Silicon wafer a) at room temperature with 1014 cm-3 doping level, and b) at 650K with 1015 cm-3 doping level