Question

Asked Oct 17, 2019

What would be the total single phase 120kVA capacity that could be used with the transformers size of 1.5 kVA?

Step 1

Given:

Rating of the single phase transformer = 1.5 kVA

Transformer is connected with a 120 kVA load.

Step 2

Case 1:

If transformer is used for only single phase,

Then,

The capacity of the load = Rating of ...

Tagged in

Q: Resistor Color CodeWhat Color Code would a 30Ω ±5% look like?

A: Use color code table to obtain the desired result of your problem: -Let us consider a resistor have ...

Q: 11- Find i (t) in the following circuit. You may employ any method you wish t = 0 22 22 24 V (t)

A: First calculate the current just after the switch is closed.Capacitor behaves as a short circuit jus...

Q: .il Verizon LTE 7:41 PM ร์ 100% Done 1- In the following circuit find ve) andi,(C) given; y(1) = 240...

A: From the given circuit, the switch is connected to v1(t) at t < 0. As the supply v1(t) is connect...

Q: Questions 5, 6, 7... and if you can 8--11

A: According to the modulation property of Fourier Transform, the following equation can be written:

Q: A three phase, 50 Hz salient-pole synchromous motor has per phase Xd of 0.8 pu and per phase Xq of 0...

A: The full load current of the synchronous motor is leading hence it is capacitive in nature.Consider ...

Q: The initial voltage across a 7.5F capacitor is 4.5V after 0.5 seconds. If the current is described a...

A: Initial voltage Vo=4.5 VC=7.5FAt 0.5s current is given as:

Q: If we want to have a Q+ state of 0, which of the following input combinations would work for a DFF w...

A: The table which gives input combinations with knowing the present and next state is called as excita...

Q: From this equation: How was this equation derived? Then from that derivation, how was this equation ...

A: The below equation should be derived from the given equation.

Q: Assume that even though the supply voltages are not shown, the op-amp remains in the linear region o...

A: Consider that the Va is voltage at + terminal pf op-amp. Apply voltage division rule.