What's the required bend radius for three-conductor, 3/0 AWG service entrance cable that's approximately 1 inch in diameter? A. 1′′ B. 3′′ C. 5′′ D. 15′′

Q: This code check whether a number is divisible by 5 and 11 or not. * 1-.. 2-.... 3-.... 4-... O 1-lf ...

A: The code for checking whether the given number is divisible by 5 and 11 or not:  

Q: H.W. For the circuit shown below, calculate the value ofRL which absorbs maximum power and then calc...

A:

Q: 5. How do you measure the current using a multimeter? 6. How do you measure the voltage using a mult...

A: 5. How do you measure the current using a multimeter ? Ans : connect the multimeter in series to mea...

Q: 3. At a certain temperature, the velocity of electrons in an intrinsic silicon material is 120m/s. T...

A:

Q: A capacitor consists of two parallel plates in air with a distance of 0.8cm between them. The area o...

A:

Q: Prob. 8: The current through the secondary of the 2.2 MVA 11/3.6 kV, Z = (1+j6.2)% transformer is gi...

A:

Q: Two resistors RI = 100 Ô and R2 200 Q, has temperature of 300 K and 400 K, respectively. If the two ...

A:

Q: A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical po...

A:

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of SF6 Circuit Breaker. Plea...

A: It is asked to draw the diagram and to explain the construction, operation, advantages and disadvant...

Q: please write the complete solution and the topic is AC parallel circuits thank you A sinusoidal 50 ...

A:

Q: 1. Two point charges are located in x-y coordinate system. A charge 2.00 x 10-9C is located at (0,4....

A:

Q: What is the characteristic time constant for a 6 mH inductor in series with a 3 Q resistor?

A:

Q: An RLC series resonance circuit has a capacitance value is 22µF, resistor value is 12002 and inducta...

A: Given, A series RLC resonance circuit has Capacitance, C=22 μF Resistance, R=1200 Ω Inductance, L=34...

Q: Explain Transducer classification adding EXAMPLE to each category. Note: Please do not handwritten.

A: Classification of Transducers The Transducers Can be classified based On a) The principle of Transdu...

Q: 3. Find the values of resistance R and capacitance C in the circuit, if I = 1.442 33.959 A. 130 s 40...

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions...

Q: A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical po...

A:

Q: A 54-slot 216-segment armature has a four-pole lap armature that is equalized 100 per cent at the co...

A:

Q: Determine the thermal noise voltage for a component operating at -60 °C having a bandwidth of 50 kHz...

A:

Q: OR gate with a small circle on the output gives the symbol of a O a. EX-NOR O b. NOT O c. EX-OR O d....

A:

Q: b. It is decided that the excess power generated from the preferred option will be transmitted to a ...

A: Given data, Sending end voltage, Vs=33 KV Sending end phase angle 3.500 Receiving end phase angle 9....

Q: Explain the essential features of Indicating Instruments

A: There are three type of essential torques that act in an indicating instruments these are, Deflectin...

Q: Grinding Force Desired DOC Force K¸(Rs+1) Machine Stiffness 1 2 Deflection ms + bs + k Control Filte...

A: Given

Q: 2.a. Find the total resistance between 'a’ and 'b’ for the circuit given below. 1Ω 1Ω 10 Ω a o Rab 5...

A: Given,

Q: A coil has a resistance of 4 ohms and an inductance of 2H. It is connected to a 20V dc supply. Calcu...

A: In steady state inductor acts as short circuit i.e impedance of circuit is purely resistance  of coi...

Q: A coil of 50 ohm resistance and of 150 mH inductance is connected in parallel with a 50 micro-farad ...

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: 1YO V 10 SL 20 N 10 L 16 N 82

A:

Q: a. A system is provided in Block Diagram form as shown in figure 4, draw its equivalent system in Si...

A: The given block diagram can be reduced by considering the parallel connected and cascade connected f...

Q: Solve for all current values though and voltage across each resistor.

A:

Q: When the load impedance is equal to the characteristic impedance of the transmission lines, then the...

A:

Q: 1YO V 10 SL 1X 2 20 . 10 2 16 2 82

A:

Q: A receiver has a noise temperature of 150 K. What is its noise figure in decibels? a1.29 dB b.9.21 d...

A: The solution is given below 

Q: Determine the voltage across R3 and the current through D3

A: The solution is given below 

Q: SCR is a three layered three junction power electronic switch? a.True b. False

A:

Q: prove in Parkial dereuation Cis)= =- (2/7)+

A: In this question,  We need to prove that the partial fraction of the given system. This function is ...

Q: 23 W compact fluorescent lamp (equivalent to a 100 W incandescent lamp) remains lit for 12 hr a day ...

A:

Q: PASSAGE Choose the correct option.(Marksc) Evaluate the no load speed at sip Assuming ari induction ...

A: Given:Induction motorf=50 HzP=6s=3% or.03

Q: Consider the system defined by i = Ax + Bu y = Cx 1 where, A = 1 -6 -11 -6 B= |0| and C = [10 5 1] C...

A:

Q: Question 1 Find the current, I which pass through 52 resistor by using Norton equivalent circuit. 2Ω...

A:

Q: A TV receiver has circuits with the following specifications: 2-RF Amplifier with gain of 10 dB each...

A: The solution is given below 

Q: Determine the stability of the following close-loop transfer function using Routh-Hurwitz Criterion....

A:

Q: 11 To increase the voltage in the system, :the modules are connected in (ähäi 2) .Series .Parallel

A: Given, To increase the voltage of the system, the modules are connected in ____.  

Q: The Illumination at any point of surface is to the cosine of angle the luminous flux makes with the ...

A:

Q: Q7. Explain what happen to a power supply if there is no smoothing capacitor connected across the ou...

A: If the capacitor are connected across the output then capacitor increase the DC voltage and there is...

Q: G4 R(s) C(s) G G3 Hz

A:

Q: A current of 1A passes through a 0.12 kQ resistor. What is the voltage across the system in Volts? Y...

A:

Q: A 440 V, 3-phase a.c. motor has a power output of 11.25 kW and operates at a power facror of 0.8 lag...

A:

Q: The cost of a single phase overhead feeder is OMR 7 a per km ( a is area of cross section in sq mm) ...

A: It is given that: For 1m of length and 1mm2 cross-section area of conductor,Resistance=162Ωcost of s...

Q: How much is the service charge? 2. How much is the energy charge subtotal? 3. How much is the dema...

A: Here, we have to find the following values, 1. The service charge 2. The energy charge subtotal 3. T...

Q: Explain about controlling torque using Spring control method. Please do not write the answer in a p...

A: Controlling Torque The control device is a device that is used to control the deflection of the poin...

Q: 4. Show the validity of the following translation properties of 2-D discreteFourier transform pairs....

A:

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.