Answered: When the mutual effect is add, the…

Engineering

Electrical Engineering

When the mutual effect is add, the equivalent inductance will. a or b Decreasel Increase Non-of-them

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 2PP: What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?

See similar textbooks

Related questions

Q: 1) A. a heater is connected to voltage source of 250 V and absorbs P= 1000 W.S= 1400 VA .What is the...

A: The heater is connected to a voltage source of 250 Volts. The real power absorbed by the heater is 1...

Q: at; RG » RS1, R$2. Ipss 10 mA and und Veso (-2 V). %3D

Q: Design an asymmetrical inverter to meet the delay of 250 ps for a load capacitance of 120 fF. Use VD...

A: On-Resistance for the NMOS can be calculated as, The width to length ratio can be calculated as,

Q: A 3-phase, Y-connected, 55-Hp, 460-V, 60-Hz, 4-pole wound rotor induction motor has the following im...

A: Part (a): The equivalent circuit diagram is shown in the below figure,

Q: The two loads in the circuit shown can be described as follows: Load 1 absorbs 8 kW at ...

A: (a) Calculate the current in the first load.

Q: Assume that; Rg »Rsi, Rs. Ipss 10 mA and

Q: Using the graph of Fig. 2.25, how much longer can you maintain 1.2 V at a discharge rate of 25 mA co...

A: Referring to the given figure, for 25mA of current, the graph is not dropping below the 1.2V till 47...

Q: 62 2V 2V Find the magnitude of I, and I2 in electrical circuit? a

Q: A 230-V, 60-Hz, 6-pole, Y-connected, three-phase induction motorhas the following parameters in ohms...

A: Note: As per our honor code, we are authorized to answer only 3 sub-parts, we’ll answer the first ...

Q: How are the Resistance Factors determined?

A: The resistance of the materials depends upon many factors like type of the materials used, width o...

Q: Q2: A 4000/400 V, 10 kVA transformer has the following constants: Primary and secondary winding resi...

A: The transformation ratio of the transformer is determined as:

Q: Choose the correct answer

A: At relative light loads, transformer efficiency is low because there are some losses which are fixed...

Q: Electrical Engineering Question

A: The efficiency of the transmission line at unity power factor is calculated as, Here, PR is the rec...

Q: 6 Find RAR in Fig. E2.16.| A 4 kN 3 kN 2 kN 12 kN RAB 8 kΩ 6 kN 2 ΚΩ АВ ure E2.16 В 4 kN 4 kΩ 2 kN

Q: . Find the complex power delivered to the load that draw: 1) 500 VA and leading power factor of 0.75...

A: (1) The power factor angle can be calculated as,

Q: In the circuit of Figure 1. Assume that; RG » Rs1, Rs2. Ipss = 10 mA and Vp = 4 V, VDD = 15 V, V psQ...

Q: Find Vs in the circuit in Fig. E2.18. 20 kN + Vs 60 kN 120 kN 0.1 mA re E2.18

Q: It consists of a vacuum Q3. The vacuum diode works mostly like a modern diode. container with cathod...

Q: (a) The voltage v across a load and the current i into the positive-polarity terminal are as follows...

Q: Full the following blanks

A: Class AB amplifiers are normally operated in a push pull configuration in order to produce an output...

Q: Find the Norton equivalent circuit for the network external to the 72 capacitive reactance in Figure...

A: Write the Norton resistance by using parallel impedance formula,

Q: Q.2 For the circuit shown, using Superposition Theorem: 1) Calculate the current through 42 resistor...

A: a) First, take the source V1 alone and short circuit the V2 source as shown in the circuit diagram b...

Q: Hi. In the circuit E = 230 V 50 Hz, sinusoidal AC voltage, R = 9 Ω and L = 0.9 How large should capa...

Q: Write down the possible representation level from high level language to logical gates exists in mac...

Q: Electrical Engineering Question

Q: Determine the s domain impedance of the series RLC circuit.

Q: What is the instantaneous power delivered to the inductor?

Q: Determine the s domain impedance of the series RLC circuit.

A: The impedances in the s-domain are given below:

Q: Which among the following is regarded as short circuit ?forward transfer admittance

A: In two port network short circuit forward admittance is It is the ratio of output current and input...

Q: Q6) for class A amplifier calculate the input power, output power and efficiency for the circuit sho...

A: Given VCC= 18 V, RL = 6 ohm, β = 40, IB = 8 mA DC base current Collector current

Q: Be able to state and use Ohm’s law For the circuit shown, If vg=1 kV and ig=5 mA, find the value of ...

A: GIVEN: Vg = 1 kV Ig = 5 mA

Q: If a current enters the dotted terminal of one coil, the reference polarity of the mutual voltage in...

A: It is given that current enters at the dotted terminal of first coli. Then the reference polarity wi...

Q: 10 Ohm resistance in parallel with 50 uF capacitance and the current through the capacitance is: ic...

Q: Electrical Engineering Question

A: Given VR = 33 KV (line to line), R = 1.5 Ω, X = 5 ohm/phase, cosø = 0.8(lagging), P = 8000 KVA VR pe...

Q: Qs: Identical JFETS characterized by ic 0; Inss 10 mA, and Vp (4V) are connected as shown in Figure ...

Q: Solve for 1.4 , 1.5 & 1.6

Q: Q.2/ Choose True or False: 1- Resistance is defined as the property of material due to which it allo...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: A certain 480-V-rms delta-connected synchronous motor operates with zero developed power and draws a...

A: Write the given values in the question.

Q: The voltage across a load is v(t)=1042 cos(ωt+10°) V, and the current through the load is i(t) = 202...

A: Given: voltage across the load is, v(t)= 1042cos(ωt+10°) V Voltage across the load i...

Q: VpD

Q: Three resistors are connected as shown in 27.9a.A potential difference of 18.0 V is maintained betwe...

A: calculate equivalent resistance, Calculate the current I,

Q: A- From fig bellow, Draw the diode load line and determine operating poir and current through the di...

A: Applying Thevenin’s theorem in the above circuit For calculating Thevenin’s resistance a voltage sou...

Question

When the mutual effect is add, the equivalent inductance will.
a or b
Decreasel
Increase
Non-of-them

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
List the five capacitor replacement rules.