When water is pumped into a water tank 20 m above a lake with a flow rate of 70 l/s, 20.4kW of electrical power is consumed. Determine the efficiency of the pump-motor group by ignoring the friction losses in the pipes and the change in kinetic energy. Determine the pressure difference between the inlet and outlet of the pump.

Q: A stream with Q = 8 m3/s Flow rate is passed through the turbine by means of a pressure pipe. its…

A: Fluid is a state of matter which deforms continuously on the application of force externally,…

Q: well water is pumped into a thank that is 25 meters high through a pipe with an inner diameter of…

A: Given data:

Q: A garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the…

A: The mass flow rate, volume flow rate and average velocity of flow to fill the bucket are calculated…

Q: In climates with low night-time temperatures, an energy-efficient way of cooling a house is to…

A: Given data (a). The flow rate of the fan is given by Substitute the necessary values in above…

Q: An 80-percent-efficient pump with a power input of 20 hp is pumping water from a lake to a nearby…

A: The power supplied by the pump to the fluid is

Q: Water, an incompressible fluid, is flowing in a horizontal pipe at a velocity of vavg = 1.15 m/s.…

A:

Q: Water is pumped from a lake to a storage tank 18 m above at a rate of 70 L/s while consuming 20.4 kW…

A:

Q: Water enters a hydraulic turbine through a 30-cm-diameter pipe at a rate of 1.1 m3/s and exits…

A:

Q: Water is pumped from a lake to a storage tank 15 m above at a rate of 70 L/s while consuming 15.4 kW…

A: The electric power supplied to the pump is The power supplied to the water by the pump can be…

Q: A 73-percent efficient 12-hp pump is pumping water from a lake to a nearby pool at a rate of 1.2…

A: The useful pumping power and the corresponding pumping head; Pumping head:

Q: A 78-percent efficient 12-hp pump is pumping water from a lake to a nearby pool at a rate of 1.2…

A: The density of water is

Q: A water pump that consumes 5 kW of electric power when operating is claimed to take in water from a…

A:

Q: 2. A water jet that leaves a nozzle at 60 m/s at a flow rate of 120 kg/s is to be used to generate…

A: Given: The mass flow rate, m = 120 kg/s The velocity of jet, v = 60 m/s

Q: A wind turbine is rotating at 15 rpm under steady winds flowing through the turbine at a rate of…

A: Given: The speed of wind turbine, N = 15 rpm The mass flow rate of wind, m = 42000 kg/s The tip…

Q: Consider water flow through a horizontal, short pipe at a rate of 80 kg/min. The velocity at the…

A: Consider the diagram shown below for the pipe flow.

Q: Underground water is to be pumped by a 78 percent efficient 5-kW submerged pump to a pool whose free…

A: (a) On using Bernoulli’s equation at point of intake and discharge, Now, it is written as

Q: A pump draws 20 kW of electrical power while pumping oil with a density of 780 kg/m^3 at a flow rate…

A: electric power = 20 kW Density = 780 kg/m^3  Flow rate = 0.3 m3/s Inlet diameter = 7 cm Outlet…

Q: a compressor draws in 0.25m^3/s of air whose density is 1.26kg/m^3 and discharges it with a density…

A:

Q: A fan with a capacity of 1.5 m³/s draws air at a static pressure of 3.0 cm of water through a duct.…

A:

Q: Water is pumped from a lake to a storage tank 25 m above at a rate of 70 L's while consuming 22.4 kW…

A: Given data Water is pumped from a lake to a storage tank 25 m above at a rate of 70 L/s while…

Q: Water with a specific volume of 0.001 m3×kg-1 flows through a centrifugal pump that operates under…

A:

Q: An air-conditioning system requires airflow at the main supply duct at a rate of 130 m3 /min. The…

A: Given: The airflow rate is V=130 m3/min. The average velocity of the air in the duct is v=8 m/s. The…

Q: A 2-kW pump is used to pump kerosene (ρ = 0.820 kg/L) from a tank on the ground to a tank at a…

A: We know that,  P=ρgQH                                     (where P=Head Power ,H=head difference and…

Q: Well water is pumped into a tank that is 25 meters high through a pipe with an inner diameter of…

A: Given, head , h = 25 m inner diameter, d = 3.75 flow rate, q = 45 litres per min = 0.00075 m3/s…

Q: A water jet that leaves a nozzle at 50 m/s at a flow rate of 100 kg/s is to be used to generate…

A: Data given-  m• = 100 kg / s  V = 50 m/s

Q: The diameters of an impeller of a centrifugal pump at inlet and outlet are 30 cm and 60 cm…

A: Inlet Diameter = 30 cm = 0.3 m Outlet diameter = 60 cm = 0.6 m Velocity of flow at outlet = 2 m/s…

Q: Q4:- Water is pumped from a lower reservoir to a higher reservoir by a pump that provides 20 kW of…

A: Given Data P=20 kW H=45 m Q=0.03 m3/s

Q: 2. Water is pumped from a lake to a storage tank 20 m above at a rate of 95 L/s while consuming 22.3…

A: Given data: (a) The power required to pump the water can be calculated as Substitute the known…

Q: Water is pumped from a lake to a storage tank 18 m above at a rate of 70 L/s while consuming 20.4 kW…

A: Density of water = 1000 kg/m3 Height of tank H = 18 m flow rate V = 70 L/s = 0.07 m3/s Pump Power =…

Q: A garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the…

A:

Q: When water is pumped into a water tank 20 m above a lake with a flow rate of 70 l/s, 20.4kW of…

A: Given data :- Flow rate = 70 l/sec Head = 20 m Electrical power = 20.4 kw

Q: A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges to…

A: In order to proceed with the given problem, the following assumptions need to be taken into…

Q: A fireboat is to fight fires at coastal areas by drawing seawater with a density of 1030 kg/m3…

A: To find the shaft power input to the pump and discharge velocity of water Firstly to find the…

Q: A fan delivers 283.2 m³ / min of air with a density of 1.2 kg/m³ through a duct 5.08 cm by 5.08 cm…

A: (a) To find : The air velocity. Given data : The flow rate of air Q=283.2 m3min1 min60 sec=4.72 m3s.…

Q: A centrifugal pump operating under steady-flow conditions 2.28 m/min of water with a specific volume…

A:

Q: Consider water flow through a horizontal, short garden hose at a rate of 40 kg/min. The velocity at…

A: Given data: The flow rate, ṁ = 40 kg/min. The velocity at inlet, Vin = 1.5 m/s. The velocity at…

Q: Water is pumped from a lower reservoir to a higher reservoir by a pump that provides 23 kW of useful…

A: Given; Mechanical power by a pump, Pm=23 kW Head difference between reservoirs, H=57 m The flow rate…

Q: Water is pumped from a lower chamber to a higher chamber by a pump driven by a 55 kW electric motor…

A: Given data pump driven power = 55 kW Pumps electric motor with an efficiency = 85%.…

Q: In a hydroelectric power plant, water flows from an elevation of 400 ft to a turbine, where electric…

A: Given: Total head = 400 ft Head loss = 36 ft Net head = 400 - 36 = 364 ft                 =110.95 m

Q: A dam with a hydraulic turbine- generator located 40 m below the water surface has a rate of 4600…

A: Given data: ◆ The head of water: H = 40 m ◆ The mass flow rate: ṁ= 4600 kg/sec ◆ The generator…

Q: The power output of an adiabatic steam turbine is 5 MW, and the inlet conditions are given as P₁ -2…

A:

Q: Water is pumped from a lake to a storage tank 15 m above at a rate of 70 L/s while consuming 15.4 kW…

A: Given data  water tank elevation (h) = 15 m density of water (ρ) =1000 kg/m3 volume flow rate (v˙)…

Q: Consider a river flowing toward a lake at an average velocity of 3 m/s at a rate of 500 m3 /s at a…

A: At the location of 90 m, the river is flowing with an average velocity of 3 m/s. So, the total…

Q: A Liquid fluid with a density of 1,750 kg/m3 from an elevated 2m open reservoir (P1=0 bars) flows…

A: If we want to calculate the power of pump then we just need 2 parameters. One is efficiency and…

Q: Electric power is to be generated by installing a hydraulic turbine—generator at a site 120 m below…

A: Given Data Electric power generation is 770 kW. Mechanical power output of the turbine is 850 kW.…

Q: A pump rated at 1800 W is used to transfer water from an open tank to another open tank. The…

A: To Find : The efficiency of the pump. Given :  The power input to the pump Pin=1800 W. The height…

Q: The brake horsepower and water horsepower of a pump are determined to be 15 kW and 12 kW,…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.