Which of the following is NOT a component of a typical dual master cylinder? a. primary piston b. piston stop bolt c. pressure relief valve d. secondary cup Brake hoses are typically rigid steel lines used to transmit brake fluid pressure. True or False? A master cylinder that has a bulge at the rear, near the mounting flange, is a _____type master cylinder.

Which of the following is NOT a component of a typical dual master cylinder? a. primary piston b. piston stop bolt c. pressure relief valve d. secondary cup Brake hoses are typically rigid steel lines used to transmit brake fluid pressure. True or False? A master cylinder that has a bulge at the rear, near the mounting flange, is a _____type master cylinder.

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter50: Brake Systems

Section: Chapter Questions

Problem 4ASRQ: While discussing quick take-up master cylinders: Technician A says that this design allows for...

See similar textbooks

Similar questions

Duo-servo drum brakes are also known as what type of brake assembly?
Which of the following statements about drum brakeshoes is not true?a. Web thickness varies only with changes in shoesize.b. Many shoes have indented places along the edgeof the rim.c. The shoe rim is welded to the web.d. The primary/leading shoe is typically the one thatis positioned toward the front of the vehicle
Which of the following statements about drum brake shoes is not true? a. Linings may be riveted or bonded to the shoes. b. Shoe indentions hold the shoe in place against the backing plate. c. The shoe rim supports the shoe lining. d. The primary/leading shoe is typically the one that is positioned toward the front of the vehicle.
While discussing quick take-up master cylinders: Technician A says that this design allows for increased braking power. Technician B says that this design is only used on drum brake systems. Who is correct? Technician A only Technician B only Both A and B Neither A nor B
Which type of brake requires greater application force and is commonly used with power-boost units? Drum Disc Parking None of the above
True or False? Disc brakes are not as likely to fade during heavy braking as are drum brakes.
True or False? Backing plates, struts, levers, and other metal brake parts should be cleaned with a wet-cleaned using water or a water-based solution.
Which of the following is not a factor in determiningthe effectiveness of a brake system?a. Heat dissipationb. Lubricantc. Pressured. Frictional contact area
find Torque Required to Apply Brake.
why is brake fluid removed from the master cylinder prior to working on disc brakes
Which of the following is not measured when inspecting the brake rotors and pads? Out of round Rotor thickness Runout Pad thickness
Asbestos has not been used in brake linings or pads since 2003. a. True b. False Technician A says low-drag calipers retract the pistons and pads farther from the rotor than traditional calipers. Technician B says systems that use low-drag calipers cannot use quick take-up master cylinders. Who is correct? a. A only b. B only c. both A and B d. neither A nor B A brake line must be single-flared to provide a good seal at a joint or junction block. a. True b. False Vehicles use brake pedal position sensors. a. True b. False