Which of the following is not a Gen2 plasma ignition system?Dual frequency driveCapacitive Magnetron dischargeHelicon wave dischargeInductively coupled plasma discharge

ignition system: The ignition system create an electric spark in the engine combustion chamber,…

Answered: Which of the following is not a Gen2…

Which of the following is not a Gen2 plasma ignition system? O Dual frequency drive O Capacitive Magnetron discharge O Helicon wave discharge O Inductively coupled plasma discharge

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter48: Restraint Systems: Theory, Diagnosis, And Service

Section: Chapter Questions

Problem 11RQ: Which of the following is false? The air bag igniter assembly is a spark plug-type device with two...

See similar textbooks

Related questions

Q: When a hermetic motor burns while in use,_______ are produced.

A: Given: When a hermetic motor burns while in use,_______ are produced.

Q: List the procedures used when setting up, igniting, andusing an air-acetylene unit.

A: The procedures used when setting up, igniting, and using an air-acetylene unit are given as under,

Q: How spark advance mechanisms works in mechanical ignition system and what are its shortcomings?

A: The purpose of the spark advance mechanism is to assure that under every condition of engine…

Q: 5) Which gas is most popularly used as a plasma? O Ar OXe O CO2 ON2

A: In plasma arc welding mainly noble gases are used because they are chemically inert which means they…

Q: Describe types of d.c. generator and their characteristics.

A: given; describe types of D.C generator and their characteristics.

Q: Describe the differences between an overrunningalternator pulley and an alternator decoupler pulley

A: The overrunning alternator pulley is an evolution of the alternator's fixed belt pulley. It…

Q: Who is correct?

A: 1. As par Faraday's Law Of Induction "The megnitude of emf induced into the conducting loop is…

Q: The alternating current produced by the AC generatoris rectified into DC, or direct current, through…

A: As rectifiers, transmission limiters, power supplies, switches, signal modulators, signal mixers,…

Q: Which of the following electronic switchingdevices has a reluctor with wide shutters ratherthan…

A: The Hall-effect Sensor can tell the difference between positive and negative charges that are…

Q: In compression ignition engines the heat rejection takes place at Isentropic process O bsathermal…

A: Basics of Ideal Diesel cycle. ( Thermodynamic cycle used for Compression ignition engines)

Q: (c) Describe, using fewer than 50 words each what is meant by the following terms describing diesel…

A: The following terms related to diesel engine are described as below: i) Delay Period : Delay period…

Q: 1. A temperature drop in the coolant entering the primary loop can be dangerous because, (a)…

A: Solution:

Q: l angle will lead to the burning of condenser and contact points. 2. Too small a dwell angle wil

A: Because the self-ignition temperature of the fuel (Petrol) in a Spark Ignition Engine is very high…

Q: Which of the following directly affects the efficiency of a car engine?: * A) Octane of the gas B)…

A: we jhave to discuss which factor directy influences the efficiency of car engine

Q: The two types of relays used to start hermetic compressorsare the _________ relay and the _________.

A: The hermetic compressor are the special type of compressors. These compressor are very big in size.…

Q: Which of the following will be used to control the rotational speed of the generator?

A: Correct Answer is option c)

Q: All changes Wires (electrical energy) Turbine (mechanical energy) Fire (heat energy) Coal (chemical…

Q: What is the Btu/hour output of an electric heater rated at 15 kilowatts?a. 51.15 Btu/hourb. 51,150…

A: As we know that 1kW = 3412 BTU/hr The. We need to convert 15 kW to BTU/hr

Q: While discussing the reasons the use of R-134a is being discontinued in some countries: Technician A…

A: Solution:

Q: Different types of IC engines

A: Given:

Q: The A/C compressor cycles rapidly, and air coming from the vents is only slightly cool. Technician A…

A: The technician A is right.

Q: Which of the following is the purpose of fail-safe circuits? O Fail-safe circuits are designed to…

A: A hydraulic circuit is a device that moves liquid via a network of separate components. This…

Q: Which of the following is used as starter for a gas turbine O a. Low pressure turbine Ob. An…

A: Fro starting Gas turbine engines

Q: . Explain how the plugs fire in a two-plug-per-coilDIS system.

A: A coil pack is a coil that simultaneously burns two spark plugs (cylinders). Instead of only one…

Q: Why does a turbine blade which breaks during the operation of an aeroengine need to be contained…

A: During the operation of aerodynamics there is very high speed in very very high altitude. If the…

Q: QUESTION 13 The symbol shown below represents a component which can fully control: Single Acting…

A: The symbol shown below shows the

Q: With the aid of a schematic diagram, show how a liquid-dominated double flash system works.

Q: Arc discharge method for making nanoparticles uses plasma (ionized gas). This ionized gas is from:…

A: Interpretation In Arc discharge method for making nanoparticles uses plasma (ionized gas). This…

Q: Explain the functions of a steam generator

A: steam generators steam genrators are heat exchangers use to convert water in to steam fromheat…

Q: What is the purpose of the internal overload protector inthe compressor motor?

A: Relays that detect overloads shield the motor, motor branch circuit, as well as motor branch circuit…

Q: The required gap in ignition system between---- O -0.4 to 5 O .-4 to 5 O 0.4 to 0.5 O .-4 to 0.5 O…

A: Required gap in ignition system in automobile generally 0.6 to 1.8 mm. M15 is used for high…

Q: What is indicated by a LTFT reading of 24 percent?

A: Given Data : LTFT

Q: While discussing the reaction by a refrigerant to heat: Technician A says that to absorb heat, the…

A: The refrigerant being at a low temperature and pressure absorb the heat to deliver a cool…

Q: Why is the procedure for checking the resistance of awaste spark ignition coil different from the…

A: A typical ignition coil is a pulse-type transformer with a soft iron core and two coil windings on…

Q: 19. Small electrical resistance heater mounted inside the combustion chamber of many CI engines,…

A: Heater : it is an electrical device that converts an electric current into heat. Induction coil:…

Q: Di ignition systems are capable of producing higher electrical energy than the DIS ignit

A: given: Di ignition systems are capable of producing higher electrical energy than the DIS ignition…

Q: Discuss why Inverter type generator is more fuel efficiency.

A: Introduction : An inverter based generator is a type of generator which is used to produced a more…

Q: he different descriptions for fluid power conductors (lines). The ___________ lines are connected to…

A: The actuator is a device that is used to convert control signal to mechanism motion. Actuators are…

Q: 2. Why do you keep the alternator speed constant in this experim

A: Since, F=NSP120F∞NS P is constant and frequency is proportional to NS

Q: 13)LVDT is a type of electrochemical transducer electromechanical transducer O electromagnetic…

Q: NOF 20 N N 09 NOS

Q: O valve O storage tank O motor conditioning device

A: Option c is correct.

Q: The two types of motors used for hermetic compressorsare _________ and _________.

A: There are basically four types of single-phase motors in use in hermetic assemblies: the permanent…

Q: 3- To compare the relative ozone definition of various refrigerants uv index called ...

A: given = compare between ozone definition of various refrigerant uv index is called

Q: Technician A says that many newer charging systems do not have a separate voltage regulator.…

A: in charge system are voltage regulator are preinstalled ,and for feed back control are programed…

Q: this picture refers to blast furnace O open hearth furnace crucible furnace O cupola furnace O…

A: Picture is shown contains combustion chamber of white cylindrical shape (3 cylindrical shapes ) and…

Concept explainers

Clutches, Brakes, Couplings, and Flywheels

The clutch is described as a machine element used to connect or disconnect two shafts together to transmit torque or power. The clutch works on the principles of friction. The clutch is commonly used in automobiles to transfer power from the driving shaft to the driven shaft.

Question

Which of the following is not a Gen2 plasma ignition system?
Dual frequency drive
Capacitive Magnetron discharge
Helicon wave discharge
Inductively coupled plasma discharge

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Clutches, Brakes, Couplings and Flywheels

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How do most electronic ignition systems differ? number of spark plugs the use of CMP and CKP sensors number of transistors the use of a distributor
Di ignition systems are capable of producing higher electrical energy than the DIS ignition systems. true or false
Which one of the below is not the source of UV radiation? Sunlight Electric arc UV lamp Torchlight
Reach, heat range, and air gap are all characteristics that affect the performance of which ignition system component? a. Ignition coils b. Ignition cables c. Spark plugs d. Ignition modules
List the advantages of having one ignition coil percylinder.
Consider the following statements relevant to the ignition system of SI engine: 1. Too small a dwell angle will lead to the burning of condenser and contact points. 2. Too small a dwell angle will result in misfiring. 3. Too large a dwell angle will result in burning of condenser and contact points. 4. Too large a dwell will result in mistiring. Which of these statements are correct?
Describe a gas ignition system
Which of the following is a gas charged accumulator? a. spring loaded accumulator b. bladder type c. all of the mentioned d. weighted accumulator
Title True or False? A spark plug with two ground electrodes will provide two separate sparks when fired.. Description True or False? A spark plug with two ground electrodes will provide two separate sparks when fired. Why is high voltage needed to establish a spark across the gap of a spark plug? List the advantages of having one ignition coil per cylinder. Which of the following is a function of all ignition systems? a. To generate sufficient voltage to force a spark across the spark plug gap b. To time the arrival of the spark to coincide with the movement of the engine’s pistons c. To vary the spark arrival time based on varying operating conditions d. All of the above
True or False? HID lamps produce more heat and white light than a halogen bulb.
What is the difference between the welding current produced by alternators and by generators?
Which of the following is false? The air bag igniter assembly is a spark plug-type device with two pins that current must jump across. The air bag igniter assembly creates a spark that ignites a canister of gas generating zerconic potassium perchlorate. The air bag igniter assembly is housed in the module assembly. None of the above.