Question

Which one is true for D flip flop? 

a) It has 2 inputs 1 output

b) It has always the output 1.

c) The output of it will be equal to its' input.

d) It can not be used in logic circuit designs.

Expert Answer

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Digital Electronics

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Using thevenine's theorm in electric circute find v0

A: Let us take the outer 4kΩ resistor as the load resistor. Short-circuit the independent voltage sourc...

Q: The full-load copper loss of a transformer is 1600 W. At half-load, the copper loss will be Select o...

A: Given information, At half load,

Q: Calculate the dynamic range and resolution of a 14 bit, 6-volt ac ADC

A: It is given that ADC is of 14 bit and 6 volt. Therefore n = 14  

Q: Consider the following integer. −64 Find the 8-bit two's complements for the integer.

A: For any positive numbers, binary representation of that number is itself the 2’s complement. But for...

Q: 4. Let's say the transmission power of the mobile phone is 10 [mW]. What is the size of the electric...

A: Note: Here unit of power will be  . Power transmission by mobile phone is given by, Here,  is intr...

Q: Given circuit shown below, assume ideal components. Find the value of IA and resistor, R. What is t...

A: The circuit diagram is shown below:  

Q: Compare the distribution of charges, electric field and potential of an abrupt junction, one sided j...

A: Part 1: Abrupt Junction: When an N-type semiconductor and a P-type semiconductor comes in contact, t...

Q: It is easy to demonstrate that amplitude modulation satisfies the superposition principle, whereas a...

A: Click to see the answer

Q: A discrete-time signal is given as: a(n) = 10 cos (0.24Tn -) = 10 cos ( 0.24n This sequence was obta...

A: Write the expression for the given signal.

Q: 4. a. For the waveform shown in figure5, determine (i) Peak value (ii) (iii) (iv) the peak-to-peak v...

A: Click to see the answer

Q: Draw the output waveform for the given circuit if input to the circuit is 10sinWt

A: The mentioned supply voltage is 10sin(ωt), observe the given circuit. Divide the circuit in the foll...

Q: A three-phase motor is connected to 480 V and has a starting current of 522 A. The motor is located ...

A: Given values are =

Q: Find the Z transform of the following discrete-time signal

A: Click to see the answer

Q: A network connected between terminals a and b consists of two parallel combinations that are in seri...

A: A network connected between terminals a and b consists of two parallel combinations that are in seri...

Q: What is the charge in coulombs of 5*10^22 protons?

A: Click to see the answer

Q: What does a full adder consist of ? -two half adders and an AND gate -two half adders -two half adde...

A: Click to see the answer

Q: If a MOSFET with W = 6.4 µm and L = 1.7 µm is biased in triode, what is the gate-to-source capacitan...

A: Click to see the answer

Q: V0/V2-V1 What's the voltage gain?

A: The above-shown circuit is the instrumentation amplifier. Assume the op-amps are ideal. Hence, the v...

Q: What are typical uses for control relays

A: Relays are sensing devices in nature. Control relays enable a low current circuit to control a high ...

Q: A non-inductive load takes a current of 15 A at 125 V. An inductor is then connected in seriesin ord...

A: Click to see the answer

Q: What are the three main signal noises and their SI units?

A: From an electrical point of view, the noise is defined as the unwanted form of energy which leads to...

Q: Find F.T of function x(t)cos (250t)

A: Click to see the answer

Q: Find the current I.

A: Referring to the given figure, applying the Kirchhoff’s current law at the node where all three curr...

Q: A sinusoidal voltage of 50 V (Vrms) and frequency 50 Hz is applied to ahalf wave rectifier. RL = 200...

A: Dear student please find the attachment.

Q: Electric field intensity vector in free space is given as (@gKR² _for R b R² Obtain the general exp...

A: The electric field intensity vector in free space is given as, Part (A):- The electric flux for a s...

Q: Suppose the current flowing through a wire is givenby the curve shown in Figure P2.9.a. Find the amo...

A: Click to see the answer

Q: For Q(a,b,c)= ∏M(0,2,4,6) what is the reduced form of the logic function in POS form? A) (B’+C’) .(...

A: Click to see the answer

Q: When is necessary to privide automatic control of the voltage output at constant speed, the generato...

A: When is necessary to provide automatic control of the voltage output at constant speed, the generato...

Q: 1: An example of MISD system is_____ Select one: a. Array Processor b. SMP system c Vector Processor...

A: As you have not mentioned which question has to solve so i am solving only 1 question. MISD is known...

Q: 1-Convert the Boolean expression to SOP form: AB +B(CD+EF) 2-Convert the Boolean expression to stand...

A: Since you have asked multiple questions in a single request, we will be answering only the 1st quest...

Q: Obtain the equivalent resistance at the terminals a-b for each of the circuits using delta to y or s...

A: Click to see the answer

Q: Kindly solve the following please

A: Click to see the answer

Q: Determine the energy stored in the 6μc capacitor in the capacitor circuit in the figure.

A: Note :Here it is given we have to find energy across which will be From the given circuit capacito...

Q: QUESTION 21 lightening Could travel     from cloud to cloud     cloud to ground     ...

A: Lightning is a phenomenon of the natural electrostatic discharge due to which two charge regions are...

Q: 2.a: An LTI system has an impulse response described in figure. Is the system causal and stable? (Th...

A: Evaluating the Z-transform of the given system:

Q: With a counter 10 lights will be controlled. At the first clock pulse all lights will be ON (1). at ...

A: Here the output is controlling 10 lights, that is, the counter is mod-10 counter. The number of flip...

Q: Determine the voltage between nodes A and B inthe circuit shown in Figure P2.67.VS = 12 VR1 = 11 k ...

A: The circuit diagram is,  

Q: Q.4: Choose the suitable choice for the following sentences. 1. At any resonant circuit the input im...

A: Since you have asked multiple subparts in a single request, we will be answering only the first thre...

Q: Describe the basic principle of operation of a bipolar junction transistor. Include explanation for ...

A: A BJT consist of two p-n junctions. The two outer regions are called collector and emitter and the m...

Q: In the circuits of Figure P2.18, the directions ofcurrent and polarities of voltage have already bee...

A: Considering First circuit diagram (a) ; Applying nodal analysis;

Q: 6 kl 12 k 4 kl 2 kn 12 V 600 µF 4V Use mesh analysis method in the s- domain to find vo(t), for t > ...

A: To calculate the V0 (t) for t>0 across the resistor 4Ω. First, draw the circuit for t<0-. When...

Q: QUESTION 15 "How much power is consumed by a 10 ohm resistor, if connected across a 20 volt batt...

A: The resistance is connected across the voltage source; the power dissipated is given by the expressi...

Q: An NMOS transistor has the following values: Vto = 1V, KP = 50  x10-6A/V2, L= 5 x10-6m, and W= 50 x1...

A: Click to see the answer

Q: 4. The switch shown in Figure has been open for a long time before closing at t = 0. Write the expre...

A: Click to see the answer

Q: 5 An inverting amplifier uses two 10 percent tolerance resistors: Rp = 33 k2 and Rs = 1.2 k2. a. Wha...

A: Given information: The forward resistance of the inverting amplifier is, The source resistance of t...

Q: A signal r's graph is given below. 2 Part (a) Express x as a super-position of shifted step signals....

A: Given graph is =

Q: The MOSFET drain current with velocity saturation is given as follows:  

A: According to the question If then 

Q: Given circuit, assume op-amp is ideal. What is the input resistance of the circuit, RIN? What are t...

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you. ...

Q: 2. Consider an open-loop transfer function of a negative unity feedback system 4 G(s) = s² (0.2s+1) ...

A: Part (1): Consider the given open-loop transfer function,

Q: Current and voltage for each resistor using the superposition theorem in the circuit in Figure 1 Fin...

A: The circuit diagram is shown below: Applying K.V.L in the loop 1 of the given circuit, Applying K....