While discussing the MIL on OBD II systems: Technician A says that the MIL will flash if the PCM detects a fault that would damage the catalytic converter. Technician B says that whenever the PCM has detected a fault, it will turn on the MIL. Who is correct? a. Technician A • Technician B • Both A and B • Neither A nor B

While discussing the MIL on OBD II systems: Technician A says that the MIL will flash if the PCM detects a fault that would damage the catalytic converter. Technician B says that whenever the PCM has detected a fault, it will turn on the MIL. Who is correct? a. Technician A • Technician B • Both A and B • Neither A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter24: Engine Performance Systems

Section: Chapter Questions

Problem 6ASRQ

See similar textbooks

Similar questions

While discussing SCR systems: Technician A says that they are used in place of a conventional catalytic converter to reduce NOx, CO, and HC. Technician B says that the most common reductant used is SCR systems is an ammonia-like substance called urea. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
Technician A says that based on current conditions, a reference voltage sensor modifies a fixed voltage from the computer and sends that voltage back to the computer. Technician B says that most reference voltage sensors are variable resistors or potentiometers. Who is correct? Technician A Technician B Both A and B Neither A nor B
Which of the following is not a type of information stored in ROM? Strategy Look-up tables Sensor input None of the above
While discussing TP sensor diagnosis: Technician A says that a four-wire TP sensor contains an idle switch. Technician B says that in some applications, the TP sensor mounting bolts may be loosened and the TP sensor housing rotated to adjust the voltage signal with the throttle in the idle position. Who is correct? Technician A Technician B Both A and B Neither A nor B
What is the difference between an active and a passive sensor used in DDC control systems?
While diagnosing a network communication failure: Technician A checks for communication codes in the problem network. Technician B checks for DTCs in all networks and modules. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor B
While discussing a high idle speed problem: Technician A says that higher-than-normal idle speed may be caused by low electrical system voltage. Technician B says that higher-than-normal idle speed may be caused by a defective coolant temperature sensor. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor B
Technician A says that some types of voltage sensors provide input to the computer by modifying or controlling a constant, predetermined voltage signal. Technician B says that a coolant temperature sensor is a voltage-generating sensor. Who is correct?
Statics -mech
While diagnosing an electronic control system: Technician A turns the ignition off before disconnecting a connector or component. Technician B uses a jumper wire to bypass a potentially faulty sensor and then observes the scan tool. Who is correct? Technician A Technician B Both A and B Neither A nor B
True or False? In a high-speed CAN system, a serial data bus is used to allow communication between the various control modules in a vehicle.
MECT361 Mechatronics Components and Instrumentation Please solve the problem in keupord