While the pressure remains constant at 100 psia the volume of a system of air changes from 20ft^3 to 10ft^3. What are (a) the internal energy in Btu, (b)the heat transferred in Btu, (c) Non-flow work, Btu. Problems: Draw the p-V and T-s diagrams in each problems.1.) While the pressure remains constant at 100 psia the volume of a system of air changes from20 ft' to 10 ft'. What are (a) AU in Btu, (b) Q in Btu, (c) Wn, Btu

Answered: Image /qna-images/answer/169190d4-25e4-4e9e-86d1-bb3e72f71774.jpg

While the pressure remains constant at 100 psia the volume of a system of air changes from 20ft^3 to 10ft^3. What are (a) the internal energy in Btu, (b)the heat transferred in Btu, (c) Non-flow work, Btu.

While the pressure remains constant at 100 psia the volume of a system of air changes from 20ft^3 to 10ft^3. What are (a) the internal energy in Btu, (b)the heat transferred in Btu, (c) Non-flow work, Btu.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 29RQ: If 3000 ft3 of air is crossing an evaporator coil and iscooled from 75F to 55F, what would be the...

See similar textbooks

Related questions

Q: Consider the flow of air through a wind turbine whose blades sweep an area of diameter D (in m). The…

Q: 1) Between two sections in a vessel, a fluid moves in a steady flow manner. At entrance: A1=20 m²,…

A: Answer: (a) The mass flow rate at inlet is 24000 kg/min. (b) The velocity of fluid at inlet is…

Q: Identify whether the given property is a state or path function: Work Heat Volume Pressure…

A: Given :- Work Heat Volume Pressure Temperature To Do :- Identify State and Path function from…

Q: It is the total energy of a flowing fluid on a unit-mass basis.

Q: Assume 9.84 lb/sec of fluid enter a steady-state, steady-flow system with P₁ = 107.18 psia, p₁ =…

Q: 3. An air compressor which operates at 900 rpm has a piston displacement of 4500cm3. Determine the…

Q: Helium expands polytropically through a gas turbine according to the process PV1.42 = C. If the…

Q: Air Undergoes a cycle consisting of a series of non-flow process listed below: 1 – 2 Constant Volume…

Q: A fluid moves in a steady flow manner between two sections in a flow line. At section 1, the area is…

A: Given data: A1=10 ft2A2=2 ft2V1=100 ft/minρ=0.2 lb/ft3v1=4 ft3/lb Need to determine the mass flow…

Q: Air with mass of 12 kg expands polytropically (m=1.50) in a closed system from 720 °C to 20 °C.…

Q: Air (density 1.2 kg/m³) flows through a horizontal pipe with negligible energy loss due to friction.…

Q: 3. Sketch a pressure-volume diagram for steam and mark on it the following points, labelling clearly…

A: (a) To find: The internal energy at the state: Given: The temperature is T=212.4°C. The specific…

Q: For ideal gases, .... is a function of temperature only a) pressure b) specific volume c) density…

Q: If a pump discharges 75 gallons per minute(gpm) of water whose specific weight is 61.5 lb/ft^3(g =…

Q: When air expands adiabatically (without gaining or losing heat), it's pressure P and volume V are…

Q: Pipeline Pumping of Oil. A pipeline laid cross-country carries oil at the rate of 795 m3/d. The…

Q: 0.25 kg of air at a pressure of 21 bar occupies a volume of 0.03 m' in a cylinder behind a piston.…

A: Given data: mass of air = 0.25 kgPressure= P1 = 21 bar = 21 x 101325 Pa =2127825 PaVolume = V1 =…

Q: 3 2 Mwww 1 UBC Engineering A modern art sculpture consists of a collar, a spring, and a circular…

A: Given: mass of the collar, m=7 kg; radius of the track, r=0.5 m; the distance, d=0.3 m; and spring…

Q: Assume 2.30 lb/sec of fluid enter a steady-state, steady-flow system with P₁ = 105.73 psia, P1 =…

Q: Brine enters a cooler at the rate of 50 m3/hr at 15°C and leaves at 1°C. Specific heat and specific…

A: Given Data: Specific gravity, SG=1.1 Specific heat, c=1.07 kJ/kg-K

Q: Air expands polytropically in a piston-cylinder arrangement from an initial pressure and volume of…

Q: Radial hydraulic thrust is the summation of unbalanced impeller forces acting in the axial direction

A: according to the given questions

Q: 54. 4.16. Oxygen with Tn 1000R, pi = 100 psia, and M1 = 0.2 enters a device with a cross-sectional…

A: Compressible flow is the branch of fluid mechanics that deals with fluids whose density changes…

Q: Two gaseous streams enter a combining tube and leave as a single mixture. These data apply at the…

Q: Develop the general energy balance applied to closed systems

A: The general energy balance for a closed system can be developed by using the conservation of energy.…

Q: A certain gas with Cp= 0.529 BTU/lbmole-Rankine and Cv= 0.4053 BTU/lbmole-Rankine expands from…

Q: Derive an expression for the change in entropy of the universe

A: To determine: ∆Suniverse

Q: diameter tank at atmospheric pressure contains two inlets and one outlet port. The first inlet port…

Q: A duplex, double acting reciprocating pump, has the following specifications: 30 cm x 20 cm x 30…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: Helium expands polytropically through a gas turbine according to the process PV^1.327=C. If the…

A: For solution refer below images.

Q: Water flows through a horizontal pipe of cross sectional of 20 cm2. Atone section, the cross…

Q: Steam enters a turbine under conditions of 80 bar, 440 ° C and 49 m / s. At the outlet, the…

A: Specific volume of a substance is defined as the volume of the substance per unit mass. The…

Q: In an undisturbed airstream, where pressure is 14.7 lb/in² and temperature is 59F, the velocity is…

Q: one pound of air with an initial temperature pf 200F is allowed to expand without flow between…

A: Thus the initial and final states are the same. For the same initial and final states ufinal –…

Q: compressor works with air at 20 degrees Celsius compressing the air from 1 bar absolute (10^5 N/m^2…

Q: If a pump discharges 75 GPM of water whose specific weight is 61.5 lb/ft^3 (g=31.95 fps^2 ), find…

A: GivenFlow rate Q=75GPMspecific weight γ=61.5lb/ft3g=31.95fps2

Q: at depth 2 m using P = ρgh. p= (pressure) 19.855 kPa p= (density of the liqui

Q: the differences, at least ten, between thermal and hydroelectric power plants. Explain the "mode of…

A: Hydroelectric power plant, first the potential energy of water is convert into kinetic energy and…

Q: Pressure, velocity and height at a section are 1 bar, 1 m/s and 1m respectively. Determine pressure…

Q: The following table lists temperatures and specific volumes of water vapor at two pressures: Data…

A: Step.1 given Data P = 1.0 Mpa P=1.5 Mpa T (°c)…

Q: river 60 m wide 2 m deep flow at 2 m/s. A hydro-plant develop a pressure of 300 kpa gage just before…

A: For solution refer below images. For maximum power take turbine efficiency = 100%. For solution…

Q: Describe the heat and work are energy transfer mechanisms between a system and its surroundings, and…

A: Heat and work are boundary phenomenon When we add heat system to the surrounding it taken as +ve…

Q: The Figure shows a solar collector panel embedded in a roof. The panel, which has a surface area of…

A: GIVEN: surface area: A= 24 ft2 Q= 200 Btu/h per ft2 T1=90°FT2=120°F SOLUTION: FINDIND TOTAL HEAT…

Q: flow between pressure of 90 and 15 psia. if the air is undergoing a process that follows pVn=C,…

A: given:P1=90psiP2=15psiT1=2000Fn=1.5

Q: The pressure from water mains located at street level may be insufficient for delivering water to…

A: Given Data Patm=14.7 lbf/in² H=20 ft=240 in

Q: 1. Discuss the concepts of Archimedes principle. 2. Discuss the three forms of energy: Potential…

A: given; (a) discuss the principal of archimedes principal. (b) discuss the three form of energy…

Q: An object is hovering (neutral buoyancy state) in water. The weight of the object is w=80.0kN . The…

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

Problems: Draw the p-V and T-s diagrams in each problems.
1.) While the pressure remains constant at 100 psia the volume of a system of air changes from
20 ft' to 10 ft'. What are (a) AU in Btu, (b) Q in Btu, (c) Wn, Btu

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given Data

VIEW

P-V ,T-s Diagram, and work

VIEW

Heat Transferred

VIEW

Internal Energy

VIEW

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

show complete solution please. thank you 3 kg of steam with quality of 30% has a pressure of 12.056 bar. At that pressure, the specific volume of a saturated fluid is vf= 1.5289 cm^3/g. The specific volume of a standard vaporis vg= 14.1889 cm^3/g. What is the specific volume of the steam?
10.) A vacuum gauge connected to a steam condenser shows that the pressure inside the condenser is 0.762 bar below the atmospheric pressure. If the atmospheric pressure is 1.094 bar, what is the absolute pressure of the steam inside the condenser in kPa?
1. What is the mass of the air inside the classroom, which is 15m * 8m * 1.5m? The classroom conditions are 25℃. Find the mass of air inside (kg) at a pressure of 1 bar Compare the weight of the air in the classroom with the weight of a person.
A 120-litre pressure vessel in a laboratory contains 1.587 kg of air. If the room temperature is 22 C and the atmospheric pressure is 101 kPa. What would be the reading on a pressure gauge? Note any assumptions you have made.
The pressure 10 ft below the free surface of a liquid is 6.51 inHg. What is the specific gravity of the liquid?
The atmospheric pressure in a location is measured by a mercury (? = 13,600 kg/m3) barometer. If the height of the mercury column is 740 mm, the atmospheric pressure at that location is (a) 88.5 kPa (b) 93.9 kPa (c) 96.2 kPa (d ) 98.7 kPa (e) 101 kPa
The gage pressure in a pipe is measured by a manometer containing mercury (? = 13,600 kg/m3). The top of the mercury is open to the atmosphere and the atmospheric pressure is 100 kPa. If the mercury column height is 24 cm, the gage pressure in the pipe is (a) 32 kPa (b) 24 kPa (c) 76 kPa (d ) 124 kPa (e) 68 kPa
If you rent a car, you can (1) return it with a full gas tank, (2) return it without filling it and pay $5.75/gallon, or (3) accept a fixed price of $60 for gas. The local price is $3.50/gallon for gasoline, and you expect this car to get 25 miles per gallon. The car has a 16-gallon tank. What choice should you make if you expect to drive: (a) 150 miles? (b) 300 miles? (c) 450 miles? (d) How do your answers change if stopping at the filling station takes 20 minutes and your time is worth $15/hr?
In general term, ______________ is the tendency of one fluid to spread on to a solid surface in the presence of other fluid a. Relative Density b. Porosity c. Permeability d. Viscosity e. Wettabilty
What is the resulting gage pressure when one pound of air at a gage pressure of 15 torr and 95°C is heated at constant volume to 800°F? Choices: 28.49 psi 13.79 psi 0.55 psi 15.25 ps
How high does a mercury barometer stands on a day when atmospheric pressure is 98.6 kPa considering that the specific gravity of mercury is 13.6 a. 739 mm b. 400 mm c. 760 mm d. 540 mm
In a user’s manual accompanying an American-madeautomobile, a typical gauge pressure for optimal performance of automobile tires is What is thispressure in grams per square centimeter and kilograms per square meter?