Question

Why a capacitor of capacitance C is considered open circuit for dc?

Expert Answer

1 Rating

Want to see the step-by-step answer?

Check out a sample Q&A here.

Want to see this answer and more?

Experts are waiting 24/7 to provide step-by-step solutions in as fast as 30 minutes!*

*Response times may vary by subject and question complexity. Median response time is 34 minutes for paid subscribers and may be longer for promotional offers.
Tagged in
Engineering
Electrical Engineering

Related Electrical Engineering Q&A

Find answers to questions asked by students like you.

Q: Hi, for electric circuits with both current and voltage sources present what is the fastest way to d...

A: Hello,The fastest way to do the analysis with both current and voltage sources present,  depends on ...

Q: P1

A: Draw the schematic diagram of the shaft and show all action and the reaction torques that are acting...

Q: 7. If your company has just purchased a new machine which has a nameplate rating of 23 Amps at 240 v...

A: As given that machine have rating of 240 volt and 23 amp.Therefore, power generated by machine=V×IPo...

Q: The circuit below has values: VT = 120 Vac, f = 24.595 kHz, L1 = 130 mH, L2 = 132 mH, and L3 = 214 m...

A: Redrawing the circuit by marking the current and the known values from the given points:

Q: In the circuit below:  VA = 45 Vac,  f = 3.183 kHz, R = 2.4 kΩ, and L = 220 mH. Calculate the induc...

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

Q: Solve all part plz or don't attempt.

A: (a) LDR R11, [R1,R2]1110 01 1 1100 1 0001 1011 00000000 0010

Q: Exercise 17.3-1 (Companion Problem 1) Consider this two - port network: 53 Q ww + 41 63 Q Determine ...

A: Companion Problem 1:-Apply Kirchoff’s current law at the nodes of the given circuit.

Q: An analog baseband signal of maximum frequency component of 4 KHz is transmitted using a pcm system ...

A: The transmission bandwidth of a pulse code modulated system primarily depends on two parameters:1. T...

Q: In a full wave rectifier circuit involving double diodes, a sinusoidal input signal of the following...

A: A full-wave rectifier is a circuit that converts the alternating voltage into direct voltage.

Q: Solve the following problem:

A: According to the initial and final value theorem of Laplace transform, given a function Y(s), the in...

Q: Directivity of antenna radiating at 15 MHz is 2.5 dB. What will be effective aperture of the antenna...

A: Write the expression for effective aperture of the antenna.

Q: A series resonant circuit consists of a resistor of 2 kohm resistance, indicator of inductance 50 mH...

A: For a series resonant circuit comprising of a resistor of resistance R, a capacitor of capacitance C...

Q: Example 17.3-1 (Companion Problem 1) (See Example 17.3-1 in the textbook for the solution to a simil...

A: Companion problem 1 Relation between Voltage and current for Z-parameter is given by

Q: Calculate the inductive reactance XL of a 100 mH inductor at a frequency f of 18 kHz.   Calculate th...

A: The inductance is the property of inductor, which opposes the change in flowing of the electric curr...

Q: Establish the relation between dB and dBm while measuring the power of an antenna.

A: The dBm is a logarithmic unit of power and it stands for power in decibels when the reference power ...

Q: Infinite seires is a very important topic in signal processing. Determine the value of the following...

A: A geometric progression (G.P.) series is expressed as

Q: In a series RLC circuit, an inductor of inductance 5 mH and a capacitor of capacitance 4 mF is prese...

A: In series RLC circuit the inductive impedance is,

Q: If the expression of the voltage across a capacitor of capacitance C=10 mF is v(t)=5 sin(10t) mV, th...

A: If v(t) represents the voltage applied across a capacitor of capacitance C, then the expression of t...

Q: An analog signal x(t) has frequency components ranging from 300 Hz to 4 kHz. If the signal is to be ...

A: Sampling is the process of converting a continuous time signal into a discrete time signal.According...

Q: Which of the following is/are true of a synchronous counter? The sameclock signal is sent to all fli...

A: I. True, In synchronous counters all the flip flops are connected to the same clock signal. There is...

Q: Give me the reactance of inductor of inductance 500 mH and frequency of 10 MHz?

A: The given values of inductance and frequency are:

Q: Can anyone help? This is an old exam and is answered (wrong might I add) and I need help.

A: For the circuit to achieve unity power factor, it must be at resonant.From the circuit,

Q: Find |V2| , 82, and Sgifor the system shown in Pig 1. .In the transmission system all the shunt elem...

A: Calculate the shunt admittance,

Q: What will be the Nyquist's sampling frequency for a signal x(t)=6sin(400t)+8sin(800t)?

A: Sampling is the process of converting a continuous time signal into a discrete time signal.According...

Q: Basically, ______receptacles are required to be installed if an equipment grounding conductor is ava...

A: Article 406 of NEC covers the installation of receptacles of both grounded type and non-grounded typ...

Q: EMT by sadiku-chapter 13-antenna problem no 20.-ASAP

A: The given magnetic field intensity is,

Q: From your understanding, what is the differnece between a grounding wire and a grounded wire? I answ...

A: The name grounding and grounded are very similar to each other, which arises confusion in understand...

Q: Directivity of an antenna is given as 20 dB. If the antenna is transmitting at 300 MHz, then what wi...

A: The directivity (D) of an antenna depends on the effective aperture (Ae) of the antenna and their re...

Q: A silicon bar is doped with donor impurities ND =2.25x1015 atoms/cm. Given the intrinsic carrier con...

A: If n0 and p0 are the equilibrium electron and hole concentration respectively, then the law of mass ...

Q: For a Silicon diode, if the value of the forward current is 10 mA and the reverse saturation current...

A: Write the expression for the diode current,

Q: There was basically no electricity 150 years ago. Tesla, Edison and Faraday were experimenting and i...

A: There is various type of resources are present in the present scenario to continue production of ele...

Q: Draw vector diagrams for that circuit and from the table

A: Let AC source voltage as a reference and its value is defined as given below,

Q: Hi, the attached image shows a question and its answer but still, I couldn't understand it please si...

A: I will explain the convolution using a simpler method called as the tabular method. Tabular convolut...

Q: The reflection coefficient for a device is found to be 0.75. What will be the corresponding return l...

A: The return loss (RL) of a device can be computed from the reflection coefficient using the following...

Q: Hi, Why is my answer different?

A: Hi !!! The mistake is marked in the image below:You forgot to multiply the resistance with the curr....

Q: For an npn transistor operating in the common emitter configuration, the value of the DC current gai...

A: As given that value of the DC current gain is 120.Base current is 10 nAleakage current is 0.1 nAalth...

Q: Consider the following amplitude modulated signal: x(t)=cos(1000t)+3sin(3500t)+sin(1222t). If this s...

A: The Nyquist’s sampling frequency is twice the frequency of the modulated signal.

Q: See attached.

A: Drawing the equivalent circuit using the given points:

Q: Hi, what is the fastest way to solve for the current in the 23-Ω resistor in the attached circuit?

A: In order to find out the current in 23 Ω resistor apply nodal analysis on the given circuit.Let the ...

Q: Find out the electric field strength at 60 km away from a transmitting station of 35 kW power.

A: If P W is the power transmitted by a transmitting station, then the rms value of the electric field ...

Q: A Si pn junction diode is operating under forward bias conduction. If the forward current is 4 mA an...

A: Using Shockley’s equation, the current (I) flowing through a p-n junction diode can be expressed as

Q: PROBLEM: A unity feedback system with the forward transfer function K G(s) s(s7) is operating with a...

A: The closed-loop transfer function of the given system is:-

Q: A transistor has a collector current of 10 mA and a base current of 40 microA. Whatis the value of ...

A: The dc current gain of a transistor is defined as the ratio of the dc collector current to the dc ba...

Q: What will be the Z transform of the signal u(n)?

A: The z-transform of u[n] is shown below:

Q: For an operation amplifier, the differential gain and the common mode gain are 105 and 102 respectiv...

A: Click to see the answer

Q: Convert the following decimal number into its equivalent Octal number: (123)10

A: Steps to convert Decimal number into octal number:Writing the decimal number.The octal number will b...

Q: Solve the following problem in detail.

A: If W is the thickness of the depletion region or space charge region for a p-n junction diode and if...

Q: Please solve for (a) and (b)

A: (a).The discrete time Fourier transform of the given function is determined as follows:

Q: 5) Drive the state table and the state diagram of the sequential circuit shown below: Т A A' Clk -В ...

A: For T­-flipflop, whenever the input is high, it toggles and if the low input is provided, flip-flop ...

Q: Consider the parallel RLC circuit of Figure 2 with the source a 1-kHz sinusoid having an amplitude o...

A: Redraw the given circuit as shown in Figure 1.