Answered: Why can a null measurement be more…

Why can a null measurement be more accurate than one using standard voltmeters and ammeters? What factors limit the accuracy of null measurements?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 63PE: The timing device in an automobile’s intermittent wiper system is based on an RC time constant and...

See similar textbooks

Related questions

Q: What is the total resistance provided by five identical resistors of value 5 ohms?

Q: When applying Kirchhoff’s loop rule, does the sign (or direction) of a battery’s emf depend on the…

A: When applying Kirchhoff’s loop rule, does the sign (or direction) of a battery’s emf depend on the…

Q: You need a 45 W resistor, but the stockroom has only 20 W and 50 W How can the desired resistance be…

Q: A 15.5 V battery is connected to a 102 Ω resistor. Neglecting the internal resistance of the…

Q: A galvanometer has a coil resistance of Rgalv V = 275.0 V. If the galvanometer deflects full scale…

Q: If E = 7.50V and r=0.45Ω, find the minimum value of the voltmeter resistance RV for which the…

A: The voltmeter reading is found to be,

Q: Determine the reading on the ammeter shown in the circuit. R3 = 8 0. R3 = 30 V, = 12V R = 40 1 A 5 A…

A: Given that:- R1=4 ohm R2=8 ohm R3=3ohm

Q: If the resistance of wires is taken into concideration, what will happen to the readings of the…

A: The resistance of wires are taking into consideration. Generally in the circuit the external…

Q: Should the resistance of an ammeter be high or low, why? Should the resistance of a voltmeter be…

A: Required Should the resistance of an ammeter be high or low, why? Should the resistance of a…

Q: If you try and measure the voltage of a battery with a voltmeter connected in series, you won't get…

Q: What are the expected readings of (a) the ideal ammeter and (b) the ideal voltmeter in Figure?

A: A voltmeter is used to measure voltage between two points and will be connected parallelly between…

Q: suppose that each headlight of your car uses a 3 A and that you accidentally left the headlights on.…

Q: Ideal voltmeters are set to read five effective values and connected as shown. Let R = 200 N, L =…

A: Step 1: In RLC circuit, Impedance is given by: Z = sqrt (R^2 + (XL - Xc)^2) XL = w*L, and Xc =…

Q: During open-heart surgery, a defibrillator can be used to bring a patient out of cardiac arrest.…

A: According to Ohm's law, potential difference(v) = Current (I) × Resistance (R) Here , current = 11.5…

Q: Can a copper wire and an aluminum wire of the samelength have the same resistance? Explain

A: The expression for resistance is, R=ρLA (I) L=length of wire,A=area of…

Q: Suppose that you have a 580ohms, and 790ohms and a 1.20kOhms resistor. What is the maximum and the…

Q: Consider three voltmeters A, B, and C with resistance R, 1.51 across the points X and Y, the…

A: Consider three voltmeters A, B., and C with resistance R, 1.5R, and 3R as drawn below:- Potential…

Q: When a voltmeter is connected across the terminals of a resistor, what usually happens to the…

A: The voltmeter is a device which is used to measure the potential difference between two points.

Q: Calculate the power dissipated in each resistor. (series-parallel circuit) V =V, R, 382 E =V +V, E…

A: As we see in the circuit, R2 and R3 are in parallel and their combination Rp is in series with R1.…

Q: One electrical appliance operates with a voltage of 120 V, while another operates with 240 V. Based…

A: The power is defined as P = V2/R This shows that power dwpends on voltage as well as resistance of…

Q: Compute for the voltage Vab in the circuit shown below. 10.0167 V b r1 5 Ohms V1 믐 15 V r2 3 Ohms…

Q: Q.1. Calculate the node voltages V1 and V2. (40 P) 20V V2 wwww 4 ohm 5 ohm 12A °10 ohm 5 ohm 5 ohm -…

Q: Es-8V Q9.8 In the circuit shown, if the length of the potentiometer LAB=54 cm and the current in the…

A: Length of potentiometer (LAB) = 54 cm LAC (balancing length) = 25 cm Potential of known battery…

Q: In view of the small currents that cause shock hazards and the larger currents that circuit breakers…

A: Fuses and circuit breakers work on the principle of heating of electric current.

Q: You are asked to measure e.m.f of a cell. Which instrument will you use? A high resistance Voltmeter…

A: The potentiometer is used to measure the e.m.f of cell.

Q: In the circuit shown, Deter A. Magnitude and directio B. Potential differences Vac C. Power…

A: Let’s assume the current I to be in the counter-clockwise direction.

Q: The timing device in an automobile's intermittent wiper system is based on an RC time constant and…

A: Given that, C = 0.400 μF =0.4 x 10-6 F Time constant, T =from 9 to 2 sec

Q: Power P0 = I0 ∆V0 is delivered to a resistor of resistance R0.If the resistance is doubled (Rnew =…

A: Given,

Q: The timing device in an automobile’s intermittent wiper system is based on an RC time constant and…

A: Given Data The capacitance of the capacitor is C = 0.500 μF. The time constant is given as ∆t = 2.00…

Q: A uniform 2-wire d.c. distributor 600 meters long is loaded with 0.1 ampere/ meter and is fed at one…

Q: The unit of energy in MKS system is: A) Joule B) Ohm C) Erg D) Volt

A: The MKS system stands for meter kilogram seconds. Joules in the base units is kg m2s-2. It can be…

Q: +4.75 4.141, determine the value of For the circuit in Fig. Rsuch that the maximum power delivered…

A: Given : (Load) PMax = 3mW Now, firstly we will find out RTH As per the figure, 1RTH=1R+1R+1R…

Q: What possible changes can be made to the circuit so that the capacitor will charge faster to its…

A: Given : What are the changes to be done to charge a capacitor faster to its maximum voltage value ?

Q: Calculate the terminal voltage for a battery with an internal resistance of 0.9002 and an emf of…

A: The terminal potential difference is given by V = E - I r Where, E is the emf, I is the current…

Q: How can you convert a galvanometer into a voltmeter?

A: A galvanometer can be converted in to a voltmeter by connecting a high resistance in series…

Q: Homework 3.1: Using Kirchhoff's voltage law and Fig. 3.9, verify that RT = R1 + R2 + R3 + V, - R1 +…

Q: A galvanometer has a coil resistance of Rgalv = 37.9 22. It is to be made into a voltmeter with a…

A: The coil resistance of the galvanometer is Rgalv=37.9Ω The voltmeter must have a full-scale voltage…

Q: What is true in general about the voltage (potential) supplied by the battery compared with the drop…

Q: A galvanometer has a coil resistance of Realy = 41.4 Q. It is to be made into a voltmeter with a…

A: Given Data: The resistance of galvanometer is, RG =41.4 Ω. The full scale voltage of voltmeter is,…

Question

Why can a null measurement be more accurate than one using standard voltmeters and ammeters? What factors limit the accuracy of null measurements?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The timing device in an automobile’s intermittent wiper system is based on an RC time constant and utilizes 0.5.00F capacitor and available resistor. Over what range must R be made to vary to achieve time constants from 2.00 to 15.0 s?
The timing device in an automobile's intermittent wiper system is based on an RC rime constant and utilizes a 0.500F capacitor and a variable resistor. Over whatrange must R be made to vary to achieve time constants from 2.00 to 15.0 s?
The ignition circuit of an automobile is powered by a 12-V battery. How are we able generate large voltages with this power source?
The severity of a shock depends on die magnitude of the current through your body. Would you prefer to be in series or in parallel with a resistance, such as the heating element of a toaster, if you were shocked by it? Explain.
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
If the resistance of wires is taken into concideration, what will happen to the readings of the ammeter and voltmeter? and why ?
What is true in general about the voltage (potential) supplied by the battery compared with the drop in potential across the resistor? What can you conclude about the drop in potential because of the wires, switch and ammeter?
An astronaut uses a small motor, rated at 93% efficient, that is connected to a 12-volt [V] power supply on Mars. The motor has a resistance rating of 2.3 kiloohms [kΩ]. How long will it take to produce 3.4 calories [cal] of energy in units of minutes [min]?
How can you convert a galvanometer into a voltmeter?
The compressor on an air conditioner draws89.1 A when it starts up. The start-up time isabout 0.243 s.How much charge passes a cross-sectionalarea of the circuit in this time?Answer in units of C.
When wiring a natural gas furnace that has nameplate stating that a 20 amp, dedicatedcircuit is required., #12 AWG conductors would supply power to the furnace. TRUE OR FALSE
The unit of energy in MKS system is: A) Joule B) Ohm C) Erg D) Volt