You are trying to come up with a drug to inhibit the activity of an enzyme thought to have a role in liver disease. In the laboratory the enzyme was shown to have a Km of 1.0 x 10-6 M and Vmax of 0.1 micromoles/min.mg measured at room temperature. You developed an uncompetitive inhibitor. In the presence of 5.0 x 10-5 M inhibitor, the apparent Vmax was determined to be 0.02 micromoles/min.mg. What is the Ki of the inhibitor?

You are trying to come up with a drug to inhibit the activity of an enzyme thought to have a role in liver disease. In the laboratory the enzyme was shown to have a Km of 1.0 x 10-6 M and Vmax of 0.1 micromoles/min.mg measured at room temperature. You developed an uncompetitive inhibitor. In the presence of 5.0 x 10-5 M inhibitor, the apparent Vmax was determined to be 0.02 micromoles/min.mg. What is the Ki of the inhibitor?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter30: Kinetic Methods Of Analysis

Section: Chapter Questions

Problem 30.1QAP

See similar textbooks

Similar questions

You are trying to come up with a drug to inhibit the activity of an enzyme thought to have a role in liver disease. In the laboratory the enzyme was shown to have a Km of 1.0 x 10-6 M and Vmax of 0.1 micromoles/min.mg measured at room temperature. You developed a competitive inhibitor. In the presence of 5.0 x 10-5 M inhibitor, the apparent Km of the enzyme was found to be 1.5 x 10-5 M. What is the Ki of the inhibitor?
An enzyme-catalyzed reaction has a Km of 1.4 mM and a Vmax of 7 nM/s. What is the initial velocity when the substrate concentration is 0.6 mM?
Chemistry The levels of an organic pollutant (P) in the groundwater at the perimeter of a plant were a cause for concern. A 10 mL sample of the water was taken and the pollutant was extracted with 95% efficiency using 25 mL of diethyl ether. GC was used to analyse the concentration of P in diethyl ether. A calibration curve was plotted for a series of standards of P which yielded the following results: Peak Area Toluene Conc. (µg/ml) 12,000 2.6 23,700 5.0 35,500 7.7 46,800 9.9 31,250 Sample Determine the concentration of P in ppb in the initial groundwater sample.
Calculate the estimated O2 cost of horizontal treadmill running (ml · kg−1 · min−1) for a 70-kg subject at 150, 200, and 235 m · min−1.
The Ksp value of magnesium fluoride is 5.16 X 10^-11 at 25 Celcius. MgF2 (s ) -> Mg^2+ (aq) +2F^- (aq)
An exposure assessment study was conducted in a nail salon. Previous studies have indicated that airborne concentrations of methyl methacrylate are approximately 1 ppm. If the LOD of the analytical method is 0.25 ug and sampling should be conducted at a flowrate of 0.01 LPM, what is the minimum amount of time the sample should be collected to achieve a detectable concentration? Note: Methyl Methacrylate MW=100.1 g/mol A. 11.2 Minutes B. 2.7 Minutes C. 8.5 Minutes D. 6.1 Minutes
A spectrophotometric method for the quantitative analysis of Pb2+ in blood has a normal calibration curve for which Sstd=(0.296 ppb−1)×Cstd+0.003. What is the concentration of Pb2+ in a sample of blood if Ssamp is 0.397?
A volumetric calcium analysis on triplicate samples of the blood serum of a patient believed to be suffering from a hyperparathyroid condition produced the following data: mmol Ca/L = 3.15, 3.25, 3.26. What is the 95% confidence interval for the mean of the data, assuming no prior information about the precision of the analysis?
A method for the detection of morphine is used to generate a calibration curve in which the assay response (y) is plotted versus morphine concentration (x, in mg/L). This gives a straight line with a slope (m) of 0.241 and a y-intercept (b) of 0.011, where y = mx + b. The slope of this line has a standard deviation of ±0.007, and the standard deviation of the intercept is ±0.006. If the sample from an athlete gives a response of 0.506 ± 0.013 in this method, what is the concentration of morphine in the sample and estimated precision of this concentration?
Chemistry 0.1237 (±0.0001) g of sodium carbonate (Na2CO3) required 22.46 (±0.02) cm3 of aqueous HCl for complete neutralisation. Determine the concentration of the HCl in mol dm–3 together with its uncertainty in mol dm–3 to an appropriate number of digits. You may assume the error in the molar mass of Na2CO3 is negligible.
What are the advantages and disadvantages of using external standards in instrumental analysis?
A volumetric calcium analysis on samples of the blood serum of a patient believed to be suffering from a hyperparathyroid condition produced the following data: mmol Ca/L = 3.10, 3.08, 3.28, 3.15, 3.26, 3.12, 3.14, 3.18, 3.25, 3.11, 2.95. Calculate: Mean Standard deviation Coefficient of variation What is the 95% confidence interval for the mean of the data, assuming no prior information about the precision of the analysis? Apply the Q test to the following data sets to determine whether the outlying result should be retained or rejected at the 95% confidence level. ( work on the first measurements according to your case)