You prepare a solution of calcium bromide by dissolving 131.6g of CaBr, in 93mL of distilled water. CaBr2 molar mass = 199.9g/mol. Determine the molarity of the solution. On work upload: 1. Show calculation for molarity. 2. Extra Credit: If the solubility of CaBr2 is about 7M, would you define your solution as unsaturated, saturated, or supersaturated. 3. Extra Credit: What would happen if you added more CaBr solid to your solution?

You prepare a solution of calcium bromide by dissolving 131.6g of CaBr, in 93mL of distilled water. CaBr2 molar mass = 199.9g/mol. Determine the molarity of the solution. On work upload: 1. Show calculation for molarity. 2. Extra Credit: If the solubility of CaBr2 is about 7M, would you define your solution as unsaturated, saturated, or supersaturated. 3. Extra Credit: What would happen if you added more CaBr solid to your solution?

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter79: Solubility

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Cyclonite, also known as RDX (Research Department Explosive), is used to make Semtex, a plastic explosive, when mixed with PETN. Semtex was used in the bomb that brought down PanAm flight 103 over Lockerbie, Scotland in 1988 killing 270 people. RDX is typically recrystallized from acetone. 1 gram of RDX is soluble in 100 mL of cold acetone (0 0C) and in 25.0 mL of boiling acetone. A student performed recrystallization starting with using 5.0 mL of acetone. a. What is the maximum amount of crude RDX the student can purify given this volume of acetone in order to maximize the % recovery? b. A student reported 65% recovery from the process of recrystallization after using 5.0 mL of acetone and the mass that can be used with that volume (part a). Is 65% the maximum % recovery of RDX using the volume you calculated in part a? Show your work.
Prepare 0.1 M solutions of NaOH and 0.1 M ethyl acetate using high-purity distilled water. So, weight desired amount of NaOH and ethyl acetate and dissolved in dH2O to prepare stock solution in equal molarity. Mw (NaOH) = 40.0 g/mol , Mw (EtOAc)= 88.1 g/mol, Density(EtOAc): 0.898 g/cm3
Estimate the solubility of salt and sugar in water and your isopropyl alcohol solution in units of grams per liter and moles per liter. Note that 1 level teaspoon of salt (NaCI) is approximately 5.7 g, and 1 level teaspoon of sugar (CH22O6) is approximately 4.2 g. 30 teaspoon of sugar water, 16 teaspoon of salt, isopropyl salt one, isopropyl sugar 1
1.0 GRAMS of an electrolyte was dissolved in 29 grams of water, the resulting solution was found to have a molarity of 0.437 mol / L. The freezing point of the solution was determined to be -4.96°C. The freezing point depression constant for water is -1.86°C and pure water may be assumed to freeze at 0°C. If the molecular weight of the electrolyte is 179.7 g/mol and it takes 15 minutes to perform the experiment, how much water was used (grams) ?
Ben prepared a salicylic acid in pentanol solution by adding 4.77 g of salicylic acid to 91.88 mL of pentanol. Calculate the mole fraction of salicylic acid in this solution. MW of salicylic acid= 138.12 g/mol MW of pentanol= 88.15 g/mol Density of pentanol= 0.8144 g/mL
Calculate how many grams of phthalic acid remained in the chilled water (the “mother liquor”) based on the solubility data given (show your work). You will recrystallize phthalic acid, a compound that is used to manufacture synthetic polymers and perfumes. Phthalic acid is very soluble in boiling water, 18 g/100 mL, and is much less soluble in chilled (14°C) water, 0.54 g/100 mL. Thus, water is a very good recrystallization solvent for phthalic acid. 54.8% percent recovery was calculated
Remember that the boiling point elevation constant for water is Kb = 0.512 C/kg, and the freezing point depression constant for water is Kf = 1.86 C/kg Use the table provided to answer the question. 1.00 g of Lead (II) Sulfate is mixed into 5.75 L of water. a) How many moles of the Lead (III) Sulfate will actually dissolve into the water? b) How many grams of Lead (III) Sulfate will be left un-dissolved? c) At what temperature will the solution now boil and freeze?
How much 6.00% sucrose solution must be added to 5.00 Liters of 60.0% sucrose solution to dilute it to 20.0%? What will be the difference in the final colume of 20.0% sucrose solution if pure water is used instead? Note: All concentration is in w/v and assume volumes are additive
The Henry’s law constant for CO2 in water at 25 °C is3.1x 10-2 M atm-1. (a) What is the solubility of CO2 inwater at this temperature if the solution is in contact withair at normal atmospheric pressure? (b) Assume that all ofthis CO2 is in the form of H2CO3 produced by the reactionbetween CO2 and H2O:CO2(aq) + H2O(l)------>H2CO3(aq)What is the pH of this solution?
50.0 mL of a 0.60 M solution of pyridine in ethanol is to be prepared by measuring out a known volume of pure liquid pyridine and diluting to 500 mL with ethanol. The molar mass of pyridine is 79.1 g/mol, and its density at room temperature is 0.982 g/mL. What volume of pyridine is required for this solution?
Which of the following compounds will be the MOST soluble in pure water at 25 ˚C? A. Lead (II) carbonate, PbCO3 Ksp = 7.4×10–14 B. Cobalt (II) carbonate, CoCO3 Ksp = 1.4×10–13 C. Manganese (II) carbonate, MnCO3 Ksp = 1.8×10–11 D. Cadmium carbonate, CdCO3 Ksp = 5.2×10–12 E. Barium carbonate, BaCO3 Ksp = 5.1×10–9
A) A saturated solution of CaCl2 in 100 gram of water at 20 0C is cooled to 5 0C. How much CaCl2 will precipitate out of solution? B) 50 gram NaCl is dissolved in 100 gram of water at 30 0C. The solution is