Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 MΩ. (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?

Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 MΩ. (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter33: Inductors And Ac Circuits

Section: Chapter Questions

Problem 66PQ

See similar textbooks

Related questions

Q: An inductor with an inductance of 7.50 H and a resistance of 8.00 ohms is connected to the terminals…

A: a)The required rate of electrical energy just after circuit is completed is,

Q: If you want a characteristic RL time constant of 1.00 s, and you have a 500 Ω resistor, what value…

A: Given: t =1 s R =500 ohm

Q: An RLC circuit is used in a radio to tune into an FMstation broadcasting at f = 99.7 MHz. The…

A: The condition for the resonance frequency in an LCR circuit is

Q: A toroidal inductor with an inductance of 90.0 mH encloses a volume of 0.0200 m3. If the average…

Q: A wooden toroidal core with a square cross section has an inner radius of 13 cm and an outer radius…

A: Given : Inner radius (a) = 13 cm = 0.13 m Outer radius (b) = 16 cm = 0.16 m Diameter (d) = 0.90 mm =…

Q: A magnetron in a kitchen microwave oven resonates at 2.45 GHz in a manner analogous to an RLC…

A: At resonance, ω=1LC2πf=1LC

Q: Consider the RL circuit shown in the figure, where R = 12.3 Ω. The switch S is closed at t = 0. At…

A: Given Data The resistance given in the circuit is R = 12.3 Ω. At t = 3 ms the current has reached I…

Q: A series circuit contains a resistor and an inductor. as shown in figure 1.31. determine a…

Q: An RL circuit with a 1-2 resistor and a 0.01-H inductor carries a current of 1 A at t=0, at which…

Q: Can a circuit element have both capacitance and inductance?

A: No, it is not possible that a circuit element has both capacitance and inductance.

Q: What inductance do you need to produce a resonant frequency of 60.0 Hz, when using a 2.00 μF…

A: The equation for the LC circuit, the resonant frequency is,

Q: What is the self-inductance of a solenoid 30.0cm long having 100 turns of wire and a cross-sectional…

A: Length of the solenoid L=30 cm =0.3 m Number of turns in the solenoid N =100 turns Area of cross…

Q: 10 V = 10 mH 40. In the circuit shown above, the switch S is closed at t= 0. Which of the following…

A: The given configuration is a series RL circuit. The time constant (τ) of this circuit can be…

Q: A coiled telephone cord forms a spiral with 70.0 turns, a diameter of 1.30 cm, and an unstretched…

Q: A device is turned on and 3.00 A flows through it 0.100 ms later. What is the self-inductance of the…

A: Given: change in current, di = 3 A time taken, dt = 0.1 ms = 1 x 10-4 s induced emf, e = 150 V

Q: What inductance must be put in series with a 19.0 Ω resistor at 7 kHz to have a total impedance of…

A: The resistance is, R=19 Ω The frequency is, f=7 kHz=7×103 Hz The total impedance is, Z=81 Ω

Q: WER A 1. What is the value of the induced voltage of the self-inductance when the rate of current is…

A: Write the given values of this problem. i1=200 μAi2=20 μATotal time interval=5 μS

Q: Consider a 23 mH inductor that has a resistance of 4.15 Ω. Time constant is 0.00554. If the…

A: Given that L=23 mH R=4.15Ω Time constant τ=0.00554 s

Q: In an oscillating RLC circuit with L = 10 mH, C = 1.5 μF, and R = 2.0 Ω, how much time elapses…

A: The amplitude of the charge on the capacitor is equal to the half the initial charge.…

Q: If you want a characteristic RL time constant of 1.20 s, and you have a 490 N resistor, what value…

Q: Given is an LC circuit with an inductance of 40.0 mH and a capacitance of 10.0 mF. The capacitor was…

Q: For the RL circuit shown above, let the inductance be 3.00 H, the resistance 8.00 Ω, and the battery…

Q: The time for the current in the resistor of an RL circuit, in units of ms, to reach -63% of its…

A: Given:- The resistance R = 513 ohm The inductor L = 87.3 mH Find:- The time for the current in…

Q: When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time…

A: Given, Current, I=0.100 A, Inductor, L=2.00 mH=0.002 H, and Emf, E =500 V.

Q: An LC circuit contains a 20 mH inductor and a 50 µF capacitor with an initial charge of 10 mC. The…

Q: Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.

A: From Ampere’s law

Q: h y Calaulate the inductance of the very long conductive wire that carries currer and the conductive…

A: Mutual Inductance is the ratio of the magnetic flux through a body (due to the magnetic field…

Q: Describe briefly how the frequency of the source emf affectsthe impedance of (a) a pure resistance,…

A: Say angular frequency of source emf is ω Part A. Pure resistance is independent of frequency of…

Q: A 50.0 mH inductor is connected to an acgenerator with e=30.0 V.What is the amplitude of the…

A: a) The equation for the current amplitude is given by,

Q: 30.21(An inductor with an inductance of 2.50 H and a resistance of 8.00Ω is connected to the…

Q: A circuit has a resistor with resistance equal to 8 Ω and an inductor with inductance 8e-4 H. What…

A: Solution is as follows:

Q: Consider an RLC circuit with emf amplitude E, = 10 V, resistance R = 10 N, inductance L = 1.0 H, and…

Q: S. iz R2 R1 L 0.5 H and negli gible resistance is connected 50 and R2 An inductor with inductance L…

Q: An RLC circuit is used in a radio to tune into an FM station broadcasting at f = 99.7 MHz. The…

A: The radio is always tuned at the resonant frequency. The resonant frequency is the frequency at…

Q: 1, Consider the circuit shown in the figure. The battery has emf ɛ = 30 volts and negligible…

Q: Question 11: Find the equivalent inductance (Leq of the circuit given below. mH 59 mH 119 mH ll L4…

Q: If you want a characteristic RL time constant of 1.00 s, and you have a 500 Ω resistor, what value…

A: Expression for the time constant of an RL circuit - τ=LRWhere, L =Inductance R=Resistance…

Q: If you want a characteristic RL time constant of 1.20 s, and you have a 490 2 resistor, what value…

A: The time constant for an RL circuit is defined by τ=LR. L is the self-inductance of the inductor and…

Q: A wooden toroidal core with a square cross section has an inner radius of 10 cm and an outer radius…

A: a) The required value of inductance is,

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 MΩ.

(a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the ratio of its outer radius to its inner radius?
What resistance R must be connected in series with a 200-mH inductor of the resulting RLC oscillating circuit is to decay to 50% of its initial value of charge in 50 cycles? To 0.10% of its initial value in 50 cycles?
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
What is the self-inductance per meter of a coaxial cable whose inner radius is 0.50 mm and whose outer radius is 4.00 mm?
Can a circuit e1eent have both capacitance and inductance?
Show that N m /l and el(dl/dt), which are both expressions for se1f-inductance, have the same units.
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
Suppose that a cylindrical solenoid is wrapped around a core of iron whose magnetic susceptibility is x. Using Equation 14.9, show that the self-inductance of the solenoid is given by L=(l+x)+0n2Al where l is its length, A its cross-sectional area and N its total number of turns. Nm=U
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
A long, cylindrical solenoid with 100 turns per centimeter has a radius of 1.5 cm. (a) Neglecting end effects, that is the self-inductance per unit length of the solenoid? (b) If the current through the solenoid changes at the rate 5.0 AJs, what is the emf induced per unit length?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?