Physics for Scientists and Engineers with Modern Physics
10th Edition
ISBN: 9781337553292
Author: Raymond A. Serway, John W. Jewett
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 10, Problem 36AP
(a)
To determine
The advice that should give to the attorney for handle the case on the side of the factory owner.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Sally wants to hang up some decorations on the side of her house, so she props up a ladder of length L = 3m against a wall at an angle of θ = 50° with respect to the horizontal. The ground is somewhat icy, where the coefficient of static friction between the ground and the ladder’s feet is µ = 0.55; while the wall of her house can be considered frictionless. If Sally has a mass of 60kg and the ladder has a mass of 80kg, what is the max distance that she can climb up the length of the ladder without it slipping? You may assume the ground is perfectly flat, and the wall is perpendicular to the ground.
A homogenous ladder 10m long and weighing 3.5 kg/m leans against a vertical wall. The angle between it and the floor is 60 degrees. The coefficient of friction of the ladder against the ground as well as the wall is 0.35.
1. How far up the ladder measured from the ground can a 65-kg man climb before it starts to slide?
a. 4.5 m
b. 6.3 m
c. 5.4 m
d. 7.3 m
2. Compute the reaction at the wall when it starts to slide, in N.
a. 324.07
b. 390.15
c. 410.32
d. 465.67
3. Compute the reaction between the ground and the ladder when it starts to slide, in N.
a. 780.06
b. 925.92
c. 598.18
d. 825.34
You and your friend Peter are putting new shingles on a roof pitched at 23 ∘ . You're sitting on the very top of the roof when Peter, who is on the edge of the roof, 5.2 m away, asks you for the box of nails. Rather than carry the 2.3 kg box of nails down to Peter, you decide to give the box a push and have it slide down to him.
If the coefficient of kinetic friction between the box and the roof is 0.52, with what speed should you push the box to have it gently come to rest right at the edge of the roof?
Chapter 10 Solutions
Physics for Scientists and Engineers with Modern Physics
Ch. 10.1 - A rigid object rotates in a counterclockwise sense...Ch. 10.2 - Consider again the pairs of angular positions for...Ch. 10.3 - Ethan and Rebecca are riding on a merry-go-round....Ch. 10.4 - If you are trying to loosen a stubborn screw from...Ch. 10.5 - You turn off your electric drill and find that the...Ch. 10.7 - A section of hollow pipe and a solid cylinder have...Ch. 10.9 - A ball rolls without slipping down incline A,...Ch. 10 - (a) Find the angular speed of the Earths rotation...Ch. 10 - A bar on a hinge starts from rest and rotates with...Ch. 10 - A wheel starts from rest and rotates with constant...
Ch. 10 - A machine part rotates at an angular speed of...Ch. 10 - A dentists drill starts from rest. After 3.20 s of...Ch. 10 - Why is the following situation impossible?...Ch. 10 - Review. Consider a tall building located on the...Ch. 10 - Prob. 8PCh. 10 - A discus thrower (Fig. P10.9) accelerates a discus...Ch. 10 - Prob. 10PCh. 10 - A car accelerates uniformly from rest and reaches...Ch. 10 - Review. A small object with mass 4.00 kg moves...Ch. 10 - Prob. 13PCh. 10 - Find the net torque on the wheel in Figure P10.14...Ch. 10 - A grinding wheel is in the form of a uniform solid...Ch. 10 - Review. A block of mass m1 = 2.00 kg and a block...Ch. 10 - Prob. 17PCh. 10 - Prob. 18PCh. 10 - Your grandmother enjoys creating pottery as a...Ch. 10 - Prob. 20PCh. 10 - You have just bought a new bicycle. On your first...Ch. 10 - Imagine that you stand tall and turn about a...Ch. 10 - Following the procedure used in Example 10.7,...Ch. 10 - Two balls with masses M and m are connected by a...Ch. 10 - Rigid rods of negligible mass lying along the y...Ch. 10 - A war-wolf or trebuchet is a device used during...Ch. 10 - Big Ben, the nickname for the clock in Elizabeth...Ch. 10 - Consider two objects with m1 m2 connected by a...Ch. 10 - Review. An object with a mass of m = 5.10 kg is...Ch. 10 - Prob. 30PCh. 10 - A uniform solid disk of radius R and mass M is...Ch. 10 - This problem describes one experimental method for...Ch. 10 - A tennis ball is a hollow sphere with a thin wall....Ch. 10 - A smooth cube of mass m and edge length r slides...Ch. 10 - Prob. 35PCh. 10 - Prob. 36APCh. 10 - Prob. 37APCh. 10 - Prob. 38APCh. 10 - Prob. 39APCh. 10 - Prob. 40APCh. 10 - Review. A string is wound around a uniform disk of...Ch. 10 - Review. A spool of wire of mass M and radius R is...Ch. 10 - Review. A clown balances a small spherical grape...Ch. 10 - Prob. 44CPCh. 10 - A spool of thread consists of a cylinder of radius...Ch. 10 - Prob. 46CPCh. 10 - A uniform, hollow, cylindrical spool has inside...Ch. 10 - A cord is wrapped around a pulley that is shaped...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A makeshift sign hangs by a wire that is extended over an ideal pulley and is wrapped around a large potted plant on the roof as shown in Figure P6.10. When first set up by the shopkeeper on a sunny and dry day, the sign and the pot are in equilibrium. Is it possible that the sign falls to the ground during a rainstorm while still remaining connected to the pot? What would have to be true for that to be possible? FIGURE P6.10 Problems 10 and 11.arrow_forwardA wood block weighing 44.75 N rests on a rough horizontal plane, the coefficient of friction being 0.40.If a bullet weighing 0.25 N is fired horizontally into the block with a velocity of 600 m/s, how far will theblock be displaced from its initial position ? Assume that the bullet remains inside the block. A.1.41m B.0.89m C.2.06m D.1.98marrow_forwardMultiple-choice question: As shown in the figure, both the vertical wall and the fixed slope are smooth, then the magnitude of the force acting on the slope by a ball with mass marrow_forward
- A 15 kg monkey climbs a uniform ladder with weight 1.2 *10^2 N and length L=3.00 m. The ladder rests against the wall and makes an angle of theta= 60.0 degrees with the ground. The upper and lower ends of the ladder rest on frictionless surfaces. The lower end is connected to the wall by a horizontal rope. HInt : Draw a force diagram for the ladder and the normal forces from the ground and wall acting on the ladder. A) find the tension in the rope when the monkey is two-thirds of the way up the ladder. B) The rope is frayed and can support a maximum tension of only 80N. Find the maximum distance that the monkey can climb up the ladder before the rope breaks. C) If the horizontal surface were rough and the rope were removed, how would your analysis of the problem change? What other information would you need to answer parts (a) and (b)arrow_forwardIn the figure, a climber leans out against a vertical ice wall that has negligible friction. Distance a is 0.975 m and distance L is 1.90 m. His center of mass is distance d = 0.91 m from the feet-ground contact point. If he is on the verge of sliding, what is the coefficient of static friction between feet and ground?arrow_forwardIn the figure a 57 kg rock climber is in a lie-back climb along a fissure, with hands pulling on one side of the fissure and feet pressed against the opposite side. The fissure has width w = 0.15 m, and the center of mass of the climber is a horizontal distance d = 0.30 m from the fissure. The coefficient of static friction between hands and rock is μ1 = 0.35, and between boots and rock it is μ2 = 1.30. The climber adjusts the vertical distance h between hands and feet until the (identical) pull by the hands and push by the feet is the least that keeps him from slipping down the fissure. (He is on the verge of sliding.) (a) What is the least horizontal pull by the hands and push by the feet that will keep the climber stable? (b) What is the value of h?arrow_forward
- To get up on the roof, a person with a mass m = 71 kg leans an aluminum ladder (mass 10.5 kg and length 6.0 m) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The ladder just overhangs a plastic rain gutter, which we can assume to be frictionless, so the force from the gutter on the ladder acts perpendicularly to the ladder. As a result, the top of the ladder experiences a normal force at an angle, while the bottom of the ladder experiences both a vertical normal force and a horizontal friction force. The center of mass of the ladder is 2 m from the bottom. The person is standing 3 m from the bottom. a.) What is the magnitude of the net force on the ladder at the top? Give your answer in newtons b.) What is the magnitude of the net force on the ladder at the bottom? Give your answer in newtonsarrow_forwardFour bricks of length L, identical and uniform, are stacked on top of one another in such a way that part of each extends beyond the one beneath. Find, in terms of L, the maximum values of (a) a1, (b) a2, (c) a3, (d) a4, and (e) h, such that the stack is in equilibrium, on the verge of falling.arrow_forwardWhich one of the following statement is true: a. The center of mass of an object must lie within the object. b. The center of mass of an object cannot move if the net force exerted on the object is zero. c. All the mass of an object is actually concentrated at its center of mass. d. The center of mass of an object must lie outside the object. e. None of the above. ANS: e Can someone please explain why they're false. I know that the CofM can be outside the object or inside so I know a and d are false. I know, for instance, with a baseball bat that the hitting end is more massive and that the CofM is more towards the more massive object so I can assume that c is false. I'm not sure about b. Thanksarrow_forward
- A ladder of mass M and length L = 4 m on a level floor leaning against a vertical . The coefficient static friction between the ladder and floor is mus = .6 , while the friction between the ladder and the wall is negligible. The ladder is at an angle of 50 degrees above the horizontal . A man of mass 3M starts to climb the ladder. To what distance up the ladder can the man climb before the ladder starts to slip on the floor ? x= _______arrow_forward2.A non-uniform, 2.0 m long ladder weighing 400 N leans against a smooth vertical wall (no friction). The ladder makes an angle of 30º with the vertical to the ground. The coefficient of static friction at the ground is 0.3. A child with weight of 300 N can climb the ladder of 1.2 m before it starts to slide down. (a) The distance of the center of mass of the ladder from the contact point in the ground is _________ (b) The normal force coming from the smooth vertical wall is _________ 3.Starting from rest, a uniform cylindrical wheel (I=M R2) with 1.0 m diameter is rotating under a constant angular acceleration of 3.0 rad/s2. (a) The magnitude of the centripetal acceleration of a point on the rim of the wheel at t = 4.0 s is ________ (b) If the mass of the wheel is 40.0 kg, its angular momentum at t = 4.0 s is ________ 4.A 4.0 kg block, lying on a smooth table, is connected to another5.0 kg block by means of a weightless cord passing over, without slipping, a…arrow_forwarda thin horizontal bar AB of negligible weight and length L is hinged to a vertical wall at A and supported at B by a thin wire BC that makes an angle u with the horizontal. A block of weight W can be moved anywhere along the bar; its position is defined by the distance x from the wall to its center of mass. As a function of x, find (a) the tension in the wire, and the (b) horizontal and (c) vertical components of the force on the bar from the hinge at A.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Conservative and Non Conservative Forces; Author: AK LECTURES;https://www.youtube.com/watch?v=vFVCluvSrFc;License: Standard YouTube License, CC-BY