(a)
Find the instantaneous power delivered to the
(a)
Answer to Problem 1E
The instantaneous power delivered to the
Explanation of Solution
Calculation:
Refer to the figure given in the question.
Consider the expression of instantaneous power delivered to the resistor.
Here,
Find the voltage across
Substitute 9 V for
Substitute
Since the power value is independent to the time. Hence, the instantaneous power delivered to the resistor is same (3.24 W) for all values of time.
Conclusion:
Thus, the instantaneous power delivered to the
(b)
Find the instantaneous power delivered to the
(b)
Answer to Problem 1E
The instantaneous power delivered to the
t in s | |
0 | |
1 | |
2 |
Explanation of Solution
Calculation:
Substitute
Substitute
The power values for various values of time are tabulated below.
Table 1
t in s | |
0 | |
1 | |
2 |
Conclusion:
Thus, the instantaneous power delivered to the
(c)
Find the instantaneous power delivered to the
(c)
Answer to Problem 1E
The instantaneous power delivered to the
t in s | |
0 | |
1 | |
2 |
Explanation of Solution
Calculation:
Substitute
Substitute
Convert
The power values for various values of time are tabulated below.
Table 2
t in s | |
0 | |
1 | |
2 |
Conclusion:
Thus, the instantaneous power delivered to the
(d)
Find the instantaneous power delivered to the
(d)
Answer to Problem 1E
The instantaneous power delivered to the
t in s | |
0 | |
1 | |
2 |
Explanation of Solution
Calculation:
Substitute
Substitute
The power values for various values of time are tabulated below.
Table 3
t in s | |
0 | |
1 | |
2 |
Conclusion:
Thus, the instantaneous power delivered to the
Want to see more full solutions like this?
Chapter 11 Solutions
Loose Leaf for Engineering Circuit Analysis Format: Loose-leaf
- Problem 11.34. At full load, a commercially available 106 hp, three-phase induction motor operates at an efficiency of 96% and a power factor of 0.87 lag. The motor is supplied from a three-phase outlet with a line-voltage rating of 208 V. 1. What is the magnitude of the line current in Ampere drawn from the 208 V outlet? (1 hp = 746 W). 2. Calculate the reactive power in kVAR supplied to the motor.arrow_forwardA 550-V feeder line supplies an industrial plant consisting of a motor drawing 60 kW at 0.75 pf (inductive), a capacitor with a rating of 20 kVAR, and lighting drawing 10 kW. (a) Calculate the total reactive power and apparent power absorbed by the plant. (b) Determine the overall pf. (c) Find the current in the feeder line.arrow_forwardWhen connected to a 120 V (rms), 60-Hz power line, a load absorbs 4kW at a lagging power factor of 0.8. Find the value of Capacitance, C, necessary to raise the power factor to 0.95 lagging.arrow_forward
- An alternating voltage given by v = 120 sin (240t + п / 4) V, is applied to a coil withnegligible resistance and inductance of 100 mH. Determine (a) the reactance of thecoil, and (b) the RMS current flowing through the circuit.arrow_forwardThe voltage applied to a coil having R = 200 ohms, L= 638 mH is represented by e= 20 sin 100 pi × t. Find a corresponding expression for the current and calculate the average value of the power taken by the coil.arrow_forwardAn investor own two large stores at Dubai. Both malls are connected in parallel and operating at an unknown voltage. The local utility system voltage is 13.8 kVrms and supplied power to the malls through a feeder line with impedance equal to 1+j2.5 ohms. Store 1 is consuming 400 kW at 0.8 pf lagging while Store 2 is consuming 300 kVAR at 0.75 pf lagging. Determine the following: a) The stores' operating rms voltages. b) The total real and reactive power of the ehole system. c) The overall pf of the whole system.arrow_forward
- Calculate the energy stored in the coupled coils at t = 10 ms if M = 0.2 H and vs = 12 cos 10t V.arrow_forwardThe amplitude of the voltage Vs (t) is 2 1/2 150 volts, the phase angle isQs = 0 degrees, its period is T = 200Pi microseconds.Since R = 300 ohms and C = 1 pico farad:a)If L0 = OH constant, find the value of R0 that enables the load to draw the maximum average power from the circuit.b) Calculate the complex power on the load.arrow_forwardA 100KVA, 220V, a star-connected alternator is loaded at full load and at 60% pf lagging.The effective AC resistance per phase is 0.01411Ω. If the synchronous reactance is 4.5times the effect of the armature leakage reactance wherein the later is 0.046 Ω perphase, find(a) the phase voltage that would be generated at the load if the circuit were operating normally(b) What no-load open-circuit phase voltage must be present in order to circulate full-load current in short-circuit state while maintaining the same speed and field current?(c) What is the terminal phase voltage of the alternator when it is under a shorted load condition? Give an explanation in support of your response using just one sentence. The IA phasor should be used as the reference one.arrow_forward
- An e.m.f. whose instantaneous value at time t is given by v(t) = 283 sin (314t + π/4) volts is applied to an inductive circuit and the current in the circuit is i(t) = 5.66 sin (314t - π/6) amperes. Determine: (iii) the active power absorbed (in W)the answer is not 207.286arrow_forwardThe impedance of an electrical circuit is (30 − j50) ohms. Determine (a) the resistance, (b) the capacitance, (c) the modulus of the impedance, and (d) the current flowing and its phase angle, when the circuit is connected to a 240V, 50 Hz supply.arrow_forwardAn e.m.f. whose instantaneous value at time t is given by v(t) = 283 sin (314t + π/4) volts is applied to an inductive circuit and the current in the circuit is i(t) = 5.66 sin (314t - π/6) amperes. Determine: (iii) the active power absorbed (in W)CHEGGarrow_forward
- Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSONDelmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningProgrammable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
- Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill EducationElectric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSONEngineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,