Fundamentals of Geotechnical Engineering (MindTap Course List)
5th Edition
ISBN: 9781305635180
Author: Braja M. Das, Nagaratnam Sivakugan
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 17, Problem 17.10P
To determine
Find the settlement of the foundation.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A 10 m x 6 m mat foundation is placed at 2.0 m depth in sand where the average value of N60 is 23. Determine the allowable net pressure that would limit the settlement to 75 mm, using the following equations.
A 1.5 m square footing carries a column with a service load of 105 kN. It is founded at a depthof 2 m on a medium stiff clay with an undrained shear strength of 42 kPa, an overconsolidationratio of 4, and a plasticity index of 35. The clay layer is 5 m thick and overlies a very stiff shale.Estimate the undrained settlement of the footing using the generalized elastic method withChristian and Carrier’s (1978) influence factors.
A square footing which carries an axial load of 13000 kg has its bottom resting on a ground water table at a depth of 2.5 m from the ground surface. Nc = 35, Nq = 22, Nγ = 19. Take PDRY = 1910 kg/m3 and PSAT = 1600 kg/m3, c = 1800 kg/m2. Compute the net soil pressure.
Chapter 17 Solutions
Fundamentals of Geotechnical Engineering (MindTap Course List)
Knowledge Booster
Similar questions
- Refer to the rectangular combined footing in Figure 10.1, with Q1 = 100 kip and Q2 = 150 kip. The distance between the two column loads L3 = 13.5 ft. The proximity of the property line at the left edge requires that L2 = 3.0 ft. The net allowable soil pressure is 2500 lb/ft2. Determine the breadth and length of a rectangular combined footing.arrow_forwardA 2 m 3 m spread footing placed at a depth of 2 m carries a vertical load of 3000 kN and a moment of 300 kN m, as shown in Figure P6.14. Determine the factor of safety using Meyerhofs effective area method. Figure P6.14arrow_forwardA 3 m 4 m footing, founded at 2 m depth in a clay, applies a net pressure of 200 kN/m2. The bed rock lies 10 m below the footing. The modulus of elasticity of the clay is 30 MN/m2. Using Janbus generalized relationship [Eq. (17.1)], assuming undrained conditions and flexible footing carrying uniform pressure, estimate the expected settlement.arrow_forward
- A 2.0 m wide continuous foundation carries a wall load of 350 kN/m in a clayey soil where = 19.0 kN/m3, c = 5.0 kN/m2, and = 23. The foundation depth is 1.5 m. Determine the factor of safety of this foundation using Eq. (6.28).arrow_forwardA square footing 2.8 m X 2.8 m is built on a homogeneous bed of sand of density 18 kN/m3 and ϕ = 36o. If the depth of foundation is 1.8 m, determine the safe load that can be applied on the footing.arrow_forwardTwo parallel strip footings 3m wide and 5m apart(measured from centre to centre), which transmit a compressive pressure of 200kN/m2 and 100kN/m2 respectively. Determine the increment of total vertical stress at point A and B, located 3m below the ground.arrow_forward
- Calculate the stress at the end of the clay stratum σ, and the increment Δσ that the footing produces a load P = 1200 KN, at points A and B Carrow_forwardA rectangular footing 6 x 3 m carries a uniform pressure of 300 kN/m2 on the surface of a soil mass. Determine the vertical stress at a depth of 4.5 m below the surface on the center line 1.0 m inside the long edge of the foundation.arrow_forwardA square footing of dimension 1.5m x 1.5m carries a load of 890 kN as shown in the image: Determine the following: (d) primary settlement for normally consolidated clay using exact equation for additional pressure at midpoint of clay. (e) primary settlement for normally consolidated clay using approximate equation for additional pressure at midpoint of clay.arrow_forward
- A 2-m by 2-m square footing is located 1.8 m below the ground surface and carries a load of 1000 kN. Determine the net vertical stress increment due to the uniform load at a depth of 4 m below the center of the footing.arrow_forwardConsider a continuous foundation of width B = 1.4 m on a sand deposit with c = 0, = 38, and = 17.5 kN/m3. The foundation is subjected to an eccentrically inclined load (see Figure 6.33). Given: load eccentricity e = 0.15 m, Df = 1 m, and load inclination = 18. Estimate the failure load Qu(ei) per unit length of the foundation a. for a partially compensated type of loading [Eq. (6.89)] b. for a reinforced type of loading [Eq. (6.90)]arrow_forwardA square footing 2.8 m X 2.8 m is constructed on a uniform bed of sand with a density of 18 kN/m3 and a slope of = 36o. Determine the safe load that may be applied to the footing if the foundation depth is 1.8 m.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Fundamentals of Geotechnical Engineering (MindTap...Civil EngineeringISBN:9781305635180Author:Braja M. Das, Nagaratnam SivakuganPublisher:Cengage Learning
Principles of Foundation Engineering (MindTap Cou...Civil EngineeringISBN:9781337705028Author:Braja M. Das, Nagaratnam SivakuganPublisher:Cengage Learning
Principles of Geotechnical Engineering (MindTap C...Civil EngineeringISBN:9781305970939Author:Braja M. Das, Khaled SobhanPublisher:Cengage Learning
Fundamentals of Geotechnical Engineering (MindTap...
Civil Engineering
ISBN:9781305635180
Author:Braja M. Das, Nagaratnam Sivakugan
Publisher:Cengage Learning
Principles of Foundation Engineering (MindTap Cou...
Civil Engineering
ISBN:9781337705028
Author:Braja M. Das, Nagaratnam Sivakugan
Publisher:Cengage Learning
Principles of Geotechnical Engineering (MindTap C...
Civil Engineering
ISBN:9781305970939
Author:Braja M. Das, Khaled Sobhan
Publisher:Cengage Learning