Automotive Technology: A Systems Approach (MindTap Course List)
6th Edition
ISBN: 9781133612315
Author: Jack Erjavec, Rob Thompson
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 19, Problem 13RQ
The alternating current produced by the AC generator is rectified into DC, or direct current, through the use of.
- transistors
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
The different descriptions for fluid power conductors (lines). The ___________ lines are connected to the output device
a. suction
b. return/exhaust
c. actuator
d. supply
Which of the following is a gas charged accumulator?
a.
spring loaded accumulator
b.
bladder type
c.
all of the mentioned
d.
weighted accumulator
A rotating magnetic field inside a set of conductingwires is a simple description of a __ .a. DC generatorb. AC generatorc. voltage regulatord. none of the above
Chapter 19 Solutions
Automotive Technology: A Systems Approach (MindTap Course List)
Ch. 19 - True or False? A faulty voltage regulator can only...Ch. 19 - To protect electronic circuits, some voltage...Ch. 19 - What is the purpose of the diodes in the...Ch. 19 - How does a voltage regulator regulate the voltage...Ch. 19 - Describe the differences between an overrunning...Ch. 19 - What would happen to the output of an AC generator...Ch. 19 - Describe the basic difference between a DC motor...Ch. 19 - Prob. 8RQCh. 19 - True or False? A generator that is not producing...Ch. 19 - What part of the AC generator is the rotating...
Ch. 19 - Which type of stator winding has two windings in...Ch. 19 - Slip rings and brushes. mount on the rotor shaft...Ch. 19 - The alternating current produced by the AC...Ch. 19 - Prob. 14RQCh. 19 - Prob. 15RQCh. 19 - Technician A says that the waveform produced by an...Ch. 19 - While discussing what is indicated by a vehicles...Ch. 19 - When checking the charging system on a late-model...Ch. 19 - Prob. 4ASRQCh. 19 - Technician A says generator output should be...Ch. 19 - Technician A says that many newer charging systems...Ch. 19 - While diagnosing rapid and severe belt wear after...Ch. 19 - Prob. 8ASRQCh. 19 - Prob. 9ASRQCh. 19 - Prob. 10ASRQ
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Which of the following is not made of semiconductor material? Zener diode Thermistor PM generator Hall-effect switcharrow_forwardThe converter A. changes the frequency of the power. B. changes AC to DC. C. is a switch. D. is used only with DC motors.arrow_forwardThree common controls used in central electric heat applications are thermostats, contactors (or relays), and A. capacitors. B. sequencers. C. cool anticipators.arrow_forward
- A PTC device is used A. to start a hermetic compressor. B. as a motor protector. C. to protect against low oil pressure. D. to protect against high oil temperature.arrow_forwardThere is a short circuit in an electric motor winding when A. there is an adverse weather condition. B. a winding conductor is worn bare and touches anotherpart of the conductor that is also bare. C. there is a defect in the centrifugal start switch. D. the motor will not start.arrow_forwardParallel circuits are used in the airconditioning industry to __________.a. supply the correct line voltage toseveral circuitsb. act as a safety circuitc. divide the voltage between twomajor loadsd. all of the abovearrow_forward
- To protect electronic circuits, some voltage regulators have a circuit built into them.arrow_forwardTechnician A says that a 12-volt light bulb that draws 12 amps has a power output of 1 watt. Technician B says that a motor that has 1 ohm of resistance has a power rating of 144 watts if it is connected to a 12-volt battery. Who is correct? Expert Answerarrow_forwardLarge transformers, when used for some time, become very hot and are cooled by circulating oil. The heating of the transformer is due to: A. the heating effect of current alone B. hysteresis loss alone C. both the heating effect of current and hysteresis loss D. intense sunlight at noonarrow_forward
- Which of the following is a device consisting of two unlike metals fastened at one end that, when heated on the fastened end, produces a DC current? A. Thermocouple B. Thermistor C. Diaphragm D. Bimetalarrow_forwardState the physical differences between a run and a start capacitor.arrow_forwardTrue or False? A generator that is not producing voltage or current may have an open stator winding.arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Understanding Motor ControlsMechanical EngineeringISBN:9781337798686Author:Stephen L. HermanPublisher:Delmar Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Understanding Motor Controls
Mechanical Engineering
ISBN:9781337798686
Author:Stephen L. Herman
Publisher:Delmar Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Stresses Due to Fluctuating Loads Introduction - Design Against Fluctuating Loads - Machine Design 1; Author: Ekeeda;https://www.youtube.com/watch?v=3FBmQXfP_eE;License: Standard Youtube License