The depth of water in a lake is 4 m. The soil at the bottom of thelake consists of sandy clay. The water content of the soil wasdetermined to be 25.0%. The specific gravity of the soil grainsis 2.70. Determine the void ratio and the unit weight of the soil.What would be the total stress, effective stress, and pore waterpressure at the 5 m depth into the bottom of the lake?

The depth of water in a lake is 4 m. The soil at the bottom of thelake consists of sandy clay. The water content of the soil wasdetermined to be 25.0%. The specific gravity of the soil grainsis 2.70. Determine the void ratio and the unit weight of the soil.What would be the total stress, effective stress, and pore waterpressure at the 5 m depth into the bottom of the lake?

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.11P

See similar textbooks

Similar questions

Solve the following problems. Provide complete solutions and summary of answers. The water table in soil deposit is 2 meters below the ground surface. The soil above the water table has a dry unit weight of 14.85 kN/cu. Meter. The saturated unit weight of the soil is 20.58 kN/cu.meter. Determine the following: a. Total Stress at a point 4.80 meters below the ground b. Total Pore pressure 4.80 meters below the ground c. Total effective stress at a point 4.80 meters below the ground.
My soil has the following profile with depth: 0-10 ft gammat = 115 pcf 10-30 ft gammasat = 98 pcf 30-55 ft gammasat = 110 pcf where gamma is the unit weight The water table is at a depth of 10 ft. Plot the total stress, effective stresses, and pore pressure versus depth. Show the calculations, and assume there is no capillarity.
Caculate the total, neutral and effective stress (kPa) at the base of each soil layer listed below. Assume the water table rest 4 m below ground surface and that there is a capillary rise of 1 m above the water table. Provide your answers in kPa to 1 decimal place. Use 9.81 kN/m3 as the unit weight of water. Total Neutral Effective Silty Sand: 5m thick, γt = 17.5 kN/m3, γsat = 18.5 kN/m3, Blank 1 Blank 2 Blank 3 Clay: 4m thick, γt = 16.5 kN/m3, γsat = 17.8 kN/m3, Blank 4 Blank 5 Blank 6 Sand: 6m thick, γt = 17.3 kN/m3, γsat = 18.1 kN/m3, Blank 7 Blank 8 Blank 9
need fast please A soil profile consists of sand (6-m thick) which overlies a layer of clay (6-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.88, Specific gravity = 2.75, Degree of Saturation = 0.79 For clay layer: Void Ratio = 0.99, Specific gravity = 2.86 Round off to two decimal places.
A soil profile as shown below, the saturated unit weight of clay and sand are 19kN/m^3 and 17kN/m^3 respectively. A moist unit weight of clay is 18.5kN/m^3. If the clay above water table is being saturated by capillarity, what is the effective stress at point A and effective stress at point B?
Consider the upward flow of water through a layer of sand in a tank as shown in the figure below. The void ratio of the sand is e=0.52 and the specific gravity of solids is 2.67. Calculate the total stress, pore water pressure, and effective stress at points A and B. What is the upward seepage force per unit volume of soil?
A layer of soil has the following properties: void ratio = 0.44, effective diameter = 12 μm, capillary constant C = 0.18 cm2 . Groundwater table is 10 m below the ground surface. (a) Find the height of capillary rise in the soil in mm. (b) What is the effective stress in kPa at 7 m depth if unit weight of solids is 25.55 kN/m3 and soil above the capillary zone is 40 % saturated? (c) What is the effective stress in kPa at 14 m depth?
A uniform soil deposit has a dry unit weight of 15.6 kN/m³ and a saturated unit weight of 17.2 kN/m³. The groundwater table is at a distance of 4 m below the ground surface. Point A is at a depth of 6 m below the ground surface. If the water table rises by 3.5 m, determine the change in effective stress at A. Indicate if it is maintained, increased or decreased.
The soil profile consists of 5m sand underlain by 13 m layer of clay. The ground water table is at a depth 2.8 m below the surface. The sand has a unit weight of 19 kN per cu. Meter above the ground water table and the saturated unit weight below was 20 kN per cu. meter. The saturated unit weight of the clay is 15.7 kN per cu. meter. At a depth of 11 m determine the following:a. Total stressb. Pore water pressurec. Effective stress.....
Calculate the value of the effetive stress at the bottom of the given soil.
For the silty soil shown, the water table is located 8 m below the soil surface. The sieve analysis indicates the diameter corresponding to 10% finer in the particle-distribution curve is 25 cm. Due to capillary action the layer at the zone of capillary rise is of 50% saturated. Saturated unit weight of soil is 21.6 kN/m3. Void ratio = 0.40. C = 0.2 sq. cm. Compute the capillary rise. Compute the effective stress at depth of 7.5 m. Compute the effective stress at depth of 10 m.
For the layered soil shown in the figure, H1 = 5 m, H2 = 5 m, and H3 = 20 m. The soil densities are ρ1=2040kg/m3, ρ2=1940kg/m3, and ρ3′=1020kg/m3. What is the effective stress at the bottom of soil 3 when h' = 15 meters? CHOICES A. 142.7 kPa B. 150.1 kPa C. 163.8 kPa D. 136.8 kPa What value of h' will cause quick condition at the bottom of soil 3? CHOICES A. 30.3 m B. 25.4 m C. 20.8 m D. 33.3 m