Concept explainers
A particulate-level illustration of the reaction
a) Identify the reactants and products in this reaction.
b) Is the change shown chemical or physical?
c) Is the mass of the product particles less than, equal to, or greater than the mass of the reactant particles?
d) If the reaction takes place in a container that allows no energy to enter or leave, how does the total energy in the container after the reaction compare with the total energy in the container before the reaction?
Trending nowThis is a popular solution!
Chapter 2 Solutions
Bundle: Introductory Chemistry: An Active Learning Approach, 6th + LMS Integrated for OWLv2, 4 terms (24 months) Printed Access Card
- Particles in the illustration below undergo a chemical change. Which among the remaining boxes, a through d, can represent the products of the chemical change? If a box cannot represent the products of the chemical change, explain why. a b c darrow_forward1-86 The specific heats of some elements at 25oC are as follows: aluminum = 0.215 cal/g · oC; carbon (graphite) = 0.170 caI/g oC; iron = 0.107 cal/g mercury = 0.033 1 caI/g oC. (a) Which element would require the smallest amount of heat to raise the temperature of 100 g of the element by 10oC? (b) If the same amount of heat needed to raise the temperature of 1 g of aluminum by 25oC were applied to 1 g of mercury, by how many degrees would its temperature be raised? (c) If a certain amount of heat is used to raise the temperature of 1.6 g of iron by 10oC, the temperature of 1 g of which element would also be raised by 10oC, using the same amount of heat?arrow_forwardA book is held 6 feet above the floor and then dropped. Which statement is true? a.The potential energy of the book is converted to kinetic energy. b.The potential energy of the book is destroyed. c.Kinetic energy is created. d.The total energy of the system will not be conserved.arrow_forward
- friend of yours reads that the process of water freezing is exothermic. This friend tells you that this can’t be true because exothermic implies “hot,” and ice is cold. Is the process of water freezing exothermic? If so, explain this process so your friend can understand it. If not, explain why not.arrow_forward3.83 For the reaction of nitrogen, N2, and hydrogen, H2, to form ammonia, NH3, a student is attempting to draw a particulate diagram, as shown below. Did the student draw a correct representation of the reaction? If not, what was the error the student made?arrow_forwardExplain the economic importance of conversions between different forms of energy and the inevitability of losses in this process.arrow_forward
- How do you distinguish (a) chemical properties from physical properties? (b) distillation from filtration? (c) a solute from a solution?arrow_forwardDuring a recent winter month in Sheboygan, Wisconsin, it was necessary to obtain 3500 kWh of heat provided by a natural gas furnace with 89% efficiency to keep a small house warm (the efficiency of a gas furnace is the percent of the heat produced by combustion that is transferred into the house). (a) Assume that natural gas is pure methane and determine the volume of natural gas in cubic feet that was required to heat the house. The average temperature of the natural gas was 56 F; at this temperature and a pressure of 1 atm, natural gas has a density of 0.68 1 g/L. (b) How many gallons of LPG (liquefied petroleum gas) would be required to replace the natural gas used? Assume the LPG is liquid propane [ C3H8 : density, 0.5318 g/mL; enthalpy of combustion, 2219 Id/mo for the formation of CO2(g) and H2O(l) ] and the furnace used to burn the LPG has the same efficiency as the gas furnace. (c) What mass of carbon dioxide is produced by combustion of the methane used to heat the house? (d) What mass of water is produced by combustion of the methane used to heat the house? (e) What volume of air is required to provide the oxygen for the combustion of the methane used to heat the house? Air contains 23% oxygen by mass. The average density of air during the month was 1.22 g/L. (f) How many kilowatt—hours ( 1kWh=3.6106 J) of electricity would be required to provide the heat necessary to heat the house? Note electricity is 100% efficient in producing heat inside a house. (g) Although electricity is 100% efficient in producing heat inside a house, production and distribution of electricity is not 100% efficient. The efficiency of production and distribution of electricity produced in a coal-fired power plant is about 40%. A certain type of coal provides 2.26 kWh per pound upon combustion. What mass of this coal in kilograms will be required to produce the electrical energy necessary to heat the house if the efficiency of generation and distribution is 40%?arrow_forwardYou want to cook some raw noodles to make a pasta dish for supper. So, you turn on the gas stovetop (which uses a flame), place a large pot of water over the flame, wait for the water to boil, place the noodles ¡n the boiling water for 11 minutes, and then drain the water from the noodles. Identify one example of a physical change and one example of a chemical change in this process. Explain your answer for each.arrow_forward
- Introductory Chemistry: An Active Learning Approa...ChemistryISBN:9781305079250Author:Mark S. Cracolice, Ed PetersPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningChemistry for Today: General, Organic, and Bioche...ChemistryISBN:9781305960060Author:Spencer L. Seager, Michael R. Slabaugh, Maren S. HansenPublisher:Cengage LearningIntroductory Chemistry: A FoundationChemistryISBN:9781337399425Author:Steven S. Zumdahl, Donald J. DeCostePublisher:Cengage Learning