Concept explainers
You are working for the summer at a research laboratory. Your research director has devised a scheme for holding small charged particles at fixed positions. The scheme is shown in Figure P23.35. A large insulating sphere of radius a carries a total positive charge Q with a uniform volume charge density. A very thin tunnel is drilled through a diameter of the sphere and two small spheres with charge q are placed in the tunnel. These spheres are represented by the blue dots in the figure. They find equilibrium positions at a distance of r on either side of the center of the sphere. Your research director has had great success with this scheme. (a) Determine the specific value of r at which equilibrium exists. (b) Your research director asks you to see if he can extend the system as follows. Determine if it is possible to add transparent plastic tubes as extensions of the tunnel and have the small spheres be in equilibrium at a position for which r > a.
Figure P23.35
Trending nowThis is a popular solution!
Chapter 23 Solutions
Physics for Scientists and Engineers with Modern Physics
Additional Science Textbook Solutions
EBK FUNDAMENTALS OF THERMODYNAMICS, ENH
Physical Science
Matter and Interactions
Glencoe Physics: Principles and Problems, Student Edition
Essential University Physics (3rd Edition)
An Introduction to Thermal Physics
- A very long, thin wire fixed along the x axis has a linear charge density of 3.2 C/m. a. Determine the electric field at point P a distance of 0.50 m from the wire. b. If there is a test charge q0 = 12.0 C at point P, what is the magnitude of the net force on this charge? In which direction will the test charge accelerate?arrow_forwardIn Figure P24.49, a charged particle of mass m = 4.00 g and charge q = 0.250 C is suspended in static equilibrium at the end of an insulating thread that hangs from a very long, charged, thin rod. The thread is 12.0 cm long and makes an angle of 35.0 with the vertical. Determine the linear charge density of the rod. FIGURE P24.49arrow_forwardA coaxial cable is formed by a long, straight wire and a hollow conducting cylinder with axes that coincide. The wire has charge per unit length = 20, and the hollow cylinder has net charge per unit length = 30. Use Gausss law to answer these questions: What are the charges per unit length on a. the inner surface and b. the outer surface of the hollow cylinder? c. What is the electric field a radial distance d from the axis of the coaxial cable?arrow_forward
- The infinite sheets in Figure P25.47 are both positively charged. The sheet on the left has a uniform surface charge density of 48.0 C/m2, and the one on the right has a uniform surface charge density of 24.0 C/m2. a. What are the magnitude and direction of the net electric field at points A, B, and C? b. What is the force exerted on an electron placed at points A, B, and C? FIGURE P25.47arrow_forwardA When we find the electric field due to a continuous charge distribution, we imagine slicing that source up into small pieces, finding the electric field produced by the pieces, and then integrating to find the electric field. Lets see what happens if we break a finite rod up into a small number of finite particles. Figure P24.77 shows a rod of length 2 carrying a uniform charge Q modeled as two particles of charge Q/2. The particles are at the ends of the rod. Find an expression for the electric field at point A located a distance above the midpoint of the rod using each of two methods: a. modeling the rod with just two particles and b. using the exact expression E=kQy12+y2 c. Compare your results to the exact expression for the rod by finding the ratio of the approximate expression to the exact expression. FIGURE P24.77 Problems 77 and 78.arrow_forwardA conducting rod carrying a total charge of +9.00 C is bent into a semicircle of radius R = 33.0 cm, with its center of curvature at the origin (Fig.P24.75). The charge density along the rod is given by = 0 sin , where is measured clockwise from the +x axis. What is the magnitude of the electric force on a 1.00-C charged particle placed at the origin?arrow_forward
- A sphere with a charge of 3.50 nC and a radius of 1.00 cm is located at the origin of a coordinate system. a. What is the electric field 1.75 cm away from the center of the sphere along the positive y axis? b. If a particle with a charge of 5.39 nC were placed at that location, what would be the electrostatic force on this charge?arrow_forwardA uniform electric field given by E=(2.655.35j)105N/C permeates a region of space in which a small negatively charged sphere of mass 1.30 g is suspended by a light cord (Fig. P24.53). The sphere is found to be in equilibrium when the string makes an angle = 23.0. a. What is the charge on the sphere? b. What is the magnitude of the tension in the cord? FIGURE P24.53arrow_forwardFigure P23.49 shows two identical small, charged spheres. One of mass 4.0 g is hanging by an insulating thread of length 20.0 cm. The other is held in place and has charge q1 = 3.6 C. The thread makes an angle of 18 with the vertical, resulting in the spheres being aligned horizontally, a distance r apart. Determine the charge q2 on the hanging sphere. Figure P23.49arrow_forward
- A positively charged disk of radius R = 0.0366 m and total charge 56.8 C lies in the xz plane, centered on the y axis (Fig. P24.35). Also centered on the y axis is a charged ring with the same radius as the disk and a total charge of 34.1 C. The ring is a distance d = 0.0050 m above the disk. Determine the electric field at the point P on the y axis, where P is y = 0.0100 m above the origin. FIGURE P24.35 Problems 35 and 36.arrow_forwardan electron (e) is to be released from rest on the central axis of a uniformly charged disk of radius R. The surface charge density on the disk is 4.00 mC/m2. What is the magnitude of the electron’s initial acceleration if it is released at a distance (a) R, (b) R/100, and (c) R/1000 from the center of the disk? (d) Why does the acceleration magnitude increase only slightly as the release point is moved closer to the disk?arrow_forward(a) What total (excess) charge q must the disk in the figure have for the electric field on the surface of the disk at its center to have the magnitude 3.0 × 106 N/C, the E value at which air breaks down electrically, producing sparks? Take the disk radius as 3.0 cm. (b) Suppose each surface atom has an effective cross-sectional area of 0.015 nm2. How many atoms are needed to make up the disk surface? (c) The charge calculated in (a) results from some of the surface atoms having one excess electron. What fraction of these atoms must be so charged?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning