An 18.0 g piece of Styrofoam carries a net charge of −9.70 ?C and floats above the center of a large horizontal sheet of plastic that has a uniform charge density on its surface. What is the charge per unit area (in C/m2) on the plastic sheet? (Include the sign of the value in your answer.)

An 18.0 g piece of Styrofoam carries a net charge of −9.70 ?C and floats above the center of a large horizontal sheet of plastic that has a uniform charge density on its surface. What is the charge per unit area (in C/m2) on the plastic sheet? (Include the sign of the value in your answer.)

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter15: Electric Forces And Electric Fields

Section: Chapter Questions

Problem 18P: (a) Determine the electric field strength at a point 1.00 cm to the left of the middle charge shown...

See similar textbooks

Similar questions

Is it possible for a conducting sphere of radius 0.10 m to hold a charge of 4.0 C in air? The minimum field required to break down air and turn it into a conductor is 3.0 106 N/C.
Two solid spheres, both of radius 5 cm, carry identical total charges of 2 C. Sphere A is a good conductor. Sphere B is an insulator, and its charge is distributed uniformly throughout its volume. (i) How do the magnitudes of the electric fields they separately create at a radial distance of 6 cm compare? (a) EA EB = 0 (b) EA EB 0 (c) EA = EB 0 (d) 0 EA EB (e) 0 = EA EB (ii) How do the magnitudes of the electric fields they separately create at radius 4 cm compare? Choose from the same possibilities as in part (i).
A uniformly charged insulating rod of length 14.0 cm is bent into the shape of a semicircle as shown in Figure P 19.21. The rod has a total charge of 7.50 C. Find (a) the magnitude and (b) the direction of the electric field at O, the center of the semicircle.
Why is the following situation impossible? A solid copper sphere of radius 15.0 cm is in electrostatic equilibrium and carries a charge of 40.0 nC. Figure P24.30 shows the magnitude of the electric field as a function of radial position r measured from the center of the sphere. Figure P24.30
A charge of q = 2.00 109 G is spread evenly on a thin metal disk of radius 0.200 m. (a) Calculate the charge density on the disk. (b) Find the magnitude of the electric field just above the center of the disk, neglecting edge effects and assuming a uniform distribution of charge.
A solid, insulating sphere of radius a has a uniform charge density throughout its volume and a total charge Q. Concentric with this sphere is an uncharged, conducting, hollow sphere whose inner and outer radii are b and c as shown in Figure P19.75. We wish to understand completely the charges and electric fields at all locations. (a) Find the charge contained within a sphere of radius r a. (b) From this value, find the magnitude of the electric field for r a. (c) What charge is contained within a sphere of radius r when a r b? (d) From this value, find the magnitude of the electric field for r when a r b. (e) Now consider r when b r c. What is the magnitude of the electric field for this range of values of r? (f) From this value, what must be the charge on the inner surface of the hollow sphere? (g) From part (f), what must be the charge on the outer surface of the hollow sphere? (h) Consider the three spherical surfaces of radii a, b, and c. Which of these surfaces has the largest magnitude of surface charge density?
Assume the magnitude of the electric field on each face of the cube of edge L = 1.00 m in Figure P23.32 is uniform and the directions of the fields on each face are as indicated. Find (a) the net electric flux through the cube and (b) the net charge inside the cube. (c) Could the net charge he a single point charge? Figure P23.32
a. Figure 24.22A shows a rod of length L and radius R with excess positive charge Q. The excess charge is uniformly distributed over the entire outside surface of the rod. Write an expression for the surface charge density . Write an expression in terms of for the amount of charge dq contained in a small segment of the rod of length dx. b. Figure 24.22B shows a very narrow rod of length L with excess positive charge Q. The rod is so narrow compared to its length that its radius is negligible and the rod is essentially one-dimensional. The excess charge is uniformly distributed over the length of the rod. Write an expression for the linear charge density . Write an expression in terms of for the amount of charge dq contained in a small segment of the rod of length dx. Compare your answers with those for part (a). Explain the similarities and differences.
Two solid spheres, both of radius 5 cm. carry identical total charges of 2 C. Sphere A is a good conductor. Sphere B is an insulator, and its charge is distributed uniformly throughout its volume, (i) How do the magnitudes of the electric fields they separately create at a radial distance of 6 cm compare? (a) EA EB= 0 (b) EA EB 0 (c) EA = EB 0 (d) 0EAEB (e) 0 = Ea EB (ii) How do the magnitudes of the electric fields they separately create at radius 4 cm compare? choose from the same possibilities as in part (i).
A thin, square, conducting plate 50.0 cm on a side lies in the xy plane. A total charge of 4.00 108 C is placed on the plate. Find (a) the charge density on each face of the plate, (b) the electric field just above the plate, and (c) the electric field just below the plate. You may assume the charge density is uniform.
A solid insulating sphere of radius a = 5.00 cm carries a net positive charge of Q = 3.00 C uniformly distributed throughout its volume. Concentric with this sphere is a conducting spherical shell with inner radius b = 10.0 cm and outer radius c = 15.0 cm as shown in Figure P24.54, having net charge q = 1.00 C Prepare a graph of the magnitude of the electric field due to this configuration versus r for O r 25.0 cm.
(a) Determine the electric field strength at a point 1.00 cm to the left of the middle charge shown in Figure P15.10. (b) If a charge of 2.00 C is placed at this point, what are the magnitude and direction of the force on it?