Recall the situation from tutorial, in which light of frequency
The cross−sectional side view diagram at right extends the ray diagram that you drew in tutorial. It shows the incident ray and several sets of rays resulting from transmission and reflection at the first (left) and second (right) boundaries. The ray that results from the second reflection from the second (right) boundary is not shown.
For the remainder of this problem, assume that the light is incident from the left side of the film at essentially normal incidence.
- For the two rays that pass through the second boundary and into the air, what are the three smallest film thicknesses for which these rays would:
- Constructively interfere? Explain.
- Destructively interfere? Explain.
Want to see the full answer?
Check out a sample textbook solutionChapter 25 Solutions
Tutorials in Introductory Physics
Additional Science Textbook Solutions
Introduction to Electrodynamics
College Physics (10th Edition)
University Physics Volume 1
Essential University Physics: Volume 1 (3rd Edition)
University Physics (14th Edition)
The Cosmic Perspective Fundamentals (2nd Edition)
- A light is to be placed above the center of a circular area of radius a. What height gives the best illumination on a circular walk surrounding the area? (When light from a point source strikes a surface obliquely, the intensity of illumination is I = (k sinA)/d^2 where A is the angle of incidence and d the distance from the source.) [Show your answer on the nearest hundredths]arrow_forwardA thin beam of white light is directed at a flat sheet of silicate flint glass at an angle of 20° to the surface of the sheet. Due to dispersion in the glass, the beam is spread out in a spectrum as shown in the figure. The refractive index of silicate flint glass versus wavelength is graphed in figure to the right. (a) The rays (A and B) shown in the figure correspond to the extreme wavelengths. Which corresponds to red and which to violet? Explain your reasoning. (b) For what thickness of the glass sheet will the spectrum be 1.0 mm wide, as shown (see Problem 7)? Hint: you must first solve Problem 7 first before doing Problem 8). Answer: 93.5 mmarrow_forwardA ray of sunlight is incident from the left (shown in blue in the upper left) upon a spherical water droplet as shown in figure below. The ray, shown making an angle at incident i undergoes a refraction with angle r at the first interface, a reflection at the rear interface, and finally emerging from a second refraction at the lower front interface. find an expression for the total deviation angle for the returned light ray (lower left in blue) from the incident direction of the light ray, as shown in the figure above. Write your expression in terms of radiansarrow_forward
- Discuss the two cases, constructive and destructive interferences, as a result of thin-film interference. (Provide figure/s to support your statement.)arrow_forwardRefer to the photo below. a. What happened to the white light when it reflected out in the air? Why the light reflected out in such manner when it is white?arrow_forwardIf you shine an ultraviolet light on the metal ball of a negatively charged electroscope (shown in Exercises 1 and 2), it will discharge. But if the electroscope is positively charged, it won’t discharge. Can you venture an explanation? 1. An electroscope is a simple device consisting of a metal ball that is attached by a conductor to two thin leaves of metal foil protected from air disturbances in a jar, as shown. When the ball is touched by a charged body, the leaves that normally hang straight down spread apart. Why? (Electroscopes ate useful not only as charge detectors but also for measuring the quantity of charge: the more charge transferred to the ball, the more the leaves diverge.)arrow_forward
- Using a ruler or any straight edge and a scale of your choice and applying the steps in ray diagramming, complete the ray diagramming for Cases 2 to 5 in order to prove the correctness of the image characteristics of the objects in the specified positions as indicated in Table 1.arrow_forwardGiven the light fixture on the picture. In this device you will be able to change the beam angle from 5 to 60 degrees. Assume an isometric distribution of the light on the illuminated surface 1) If the distance to the floor is 3 meters, what will be the beam angle that will produce an Illuminated surface Diameter of 2 meters?arrow_forwardTwo radio antennas separated by d = 270 m, as shown in the figure below, simultaneously broadcast identical signals at the same wavelength. A car travels due north along a straight line at position x = 1,030 m from the center point between the antennas, and its radio receives the signals. Hint: Do not use the small-angle approximation in this problem. (a) If the car is at the position of the second maximum after that at point O when it has traveled a distance of y = 400 m northward, what is the wavelength of the signals? m(b) How much farther must the car travel from this position to encounter the next minimum in reception? marrow_forward
- What happens to the diffraction patters when the following are changed? Thoroughly describe each. a. The width of a single slit, w b. The width w and separation d of double slit c. The number of multiple slits N d. The distance from the slit plate to the sensor L e. The experimental y value collected from your data.arrow_forwardPARTS (a), (b), AND (c) ALREADY HAVE CORRET ANSWER. PLEASE PROVIDE FORMULA FOR PARD (d) A ray of monochromatic light is incident on the face of a prism in the shape of an equilateral triangle (that is, the apex angle of the prism is 60.0°). The incidence angle of the light ray is 76.6°. The prism is made of a transparent material with an index of refraction of 1.492 (at the light ray's wavelength). (a) Calculate the angle of refraction at the first surface (in degrees). (Round your answer to at least one decimal place.) 40.69° (b) Calculate the angle of incidence at the second surface (in degrees). (Round your answer to at least one decimal place.) 19.31° (c) Calculate the angle of refraction at the second surface (in degrees). (Round your answer to at least one decimal place.) 29.56° (d) Calculate the angle between the incident and emerging rays (in degrees). (Round your answer to at least one decimal place.) ?????°arrow_forwardTwo motorcycles separated laterally by 2.30 m are approaching an observer wearing night-vision goggles sensitive to infrared light of wavelength 885 nm. (a) Assume the light propagates through perfectly steady and uniform air. What aperture diameter is required if the motorcycles’ headlights are to be resolved at a distance of 12.0 km? (b) Comment on how realistic the assumption in part (a) is.arrow_forward
- Glencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill