Comptia A+ Core 1 Exam: Guide To Computing Infrastructure (mindtap Course List)
10th Edition
ISBN: 9780357108376
Author: Jean Andrews, Joy Dark, Jill West
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Expert Solution & Answer
Chapter 3, Problem 11TC
Explanation of Solution
Given:
A DIMM memory which displays the ad of 5-5-5-15.
To find:The CAS latency rate of the DIMM which displays the ad of 5-5-5-15...
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
You have DDR2 memory with a CAS latency of 6 and DDR3 memory with a CAS latency of 7. What can you tell about the relative speed of the two memory modules?
When it comes to storage, do hard drives in computers fall under the category of primary or secondary devices? Please elaborate on your answer in the next sentence.- Explain why a sound card could stop working correctly due to a conflict with the interrupt request queue (IRQ), as well as how such an IRQ issue can be fixed.
IN VERILOGÂ
Â
If tWbus is a tri-stated output, it must be declared as _____.
Â
In a buffer register, when the LOAD control signal is disabled or inactive, what is the content of the register?"
Â
Â
all the bits are zero
Â
Â
all the bits are one
Â
Â
retain the previous content
Â
Â
high impedance
Â
What is the correct arrangement of parameters for bufif1?
Â
Â
"(output, control, input)"
Â
Â
"(control, output, input)"
Â
Â
"(output, input, control)"
Â
Â
"(input, output, control)"
Â
The keyword that represents an active low tri-state buffer is _____.
Â
A tri-state buffer is needed for all data going to the W bus.
 True
 False
Â
The keyword used for procedural blocks that are executed many times or loop continuously is
Chapter 3 Solutions
Comptia A+ Core 1 Exam: Guide To Computing Infrastructure (mindtap Course List)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.Similar questions
- A DIMM memory ad displays 5-5-5-15. What is the CAS Latency value of this DIMM?arrow_forwardThe timing of Direct Memory Access (DMA) with the clock?arrow_forwardFor the circuit shown below; 1-What are the addresses for each port, what is the type of decoding and interfacing technique. . 2- What is the range of addresses for memory chip, what is the type of decoding. Is there any foldback space exists? 3- Write a program to transfer the content of the last ROM location to the 7 ?segment display ,what will be displayedarrow_forward
- A time diagram for Direct Memory Access (DMA) that synchronizes with the clock?arrow_forwardUse the Internet to gather information on three different commercial hardware RAIDcontrollers that perform RAID level 5, and write a short report that compares and contraststheir features and cost. In what situations would you use each one?arrow_forwardIn memory ads for DIMMs, you notice DDR 2400 CL15 in one ad and PC4 21300 CL9 in another.Which ad is advertising the faster memory?arrow_forward
- How many external address lines are required for a 16M x 4 DRAM chip not counting RAS and CAS? Â give detalsarrow_forwardWhen the ROM sends data to the microprocessor, which of these conditions are true? a. Both (RD)' and M/(IO)' signals should be low b. (WR)' signal should be low c. (RD)' signal should be low d. M/(IO)' signal should be high e. Both (WR)' and M/(IO)' signals should be low f. (RD)' signal should be active and M/(IO)' signal should be higharrow_forwardWhat are the advantages of using "non-volatile RAM" (NVRAM) in certain system designs?arrow_forward
- Let's pretend you're programming an embedded system, and that you want P2.1 to operate at a 70% duty cycle and a 30% off cycle, respectively, using timer 0 and timer 1. Data is being read from P1 and sent to a serial device concurrently. Give your reasons for or against using a real-time OS in this scenario.arrow_forwardExplain True/False. Statement - The data transfer between memory and I/O devices using programmed I/O is faster than interrupt driven I/O.arrow_forward"In a buffer register, when the LOAD control signal is enabled or active, the input from W bus is loaded into the register. "  True  False The keyword _______ is the used to end a module in Verilog. The keyword _______ is used to declare an output port in Verilog. Assuming that your FPGA is connected to a 10MHz clock, what should be the maximum counter to set if you need a blinking interval of half second? A _________ is used to declare a constant value in Verilog. What is the minimum size of a register named 'counter' if you need to set it to 50,0000,000 count? The left-hand side of a non-blocking procedural assignment must be a valid ______ only.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Comptia A+ Core 1 Exam: Guide To Computing Infras...Computer ScienceISBN:9780357108376Author:Jean Andrews, Joy Dark, Jill WestPublisher:Cengage Learning
A+ Guide to Hardware (Standalone Book) (MindTap C...Computer ScienceISBN:9781305266452Author:Jean AndrewsPublisher:Cengage Learning
A+ Guide To It Technical SupportComputer ScienceISBN:9780357108291Author:ANDREWS, Jean.Publisher:Cengage,
Comptia A+ Core 1 Exam: Guide To Computing Infras...
Computer Science
ISBN:9780357108376
Author:Jean Andrews, Joy Dark, Jill West
Publisher:Cengage Learning
A+ Guide to Hardware (Standalone Book) (MindTap C...
Computer Science
ISBN:9781305266452
Author:Jean Andrews
Publisher:Cengage Learning
A+ Guide To It Technical Support
Computer Science
ISBN:9780357108291
Author:ANDREWS, Jean.
Publisher:Cengage,