Automotive Technology: A Systems Approach (MindTap Course List)
6th Edition
ISBN: 9781133612315
Author: Jack Erjavec, Rob Thompson
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 34, Problem 3ASRQ
While discussing catalytic converter diagnosis: Technician A says that Mode $06 data should be checked. Technician B says that a good converter is evident by low amounts of CO2 in the exhaust. Who is correct?
a. Technician A only
b. Technician B only
c. Both A and B
d. Neither A nor B
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
technician A says lean ratio of 15:1 to 16:1 provide the best fuel economy. technician B says rich mixture have a ratio below 14.7:1 and provide more power from the engine but greater fuel combustion. who is correct?
Explain steps involved in disconnecting a fuel line on a vehicle with multiport fuel injaction and gasoline direct injection ?
the goverment mandated warranty that specifically covers the catalytic converter and engine control module is the
Chapter 34 Solutions
Automotive Technology: A Systems Approach (MindTap Course List)
Ch. 34 - A rich air-fuel ratio causes HC emissions to...Ch. 34 - What will result from too little EGR flow? And...Ch. 34 - What can result from a charcoal canister that is...Ch. 34 - What happens if a PCV valve is stuck in the open...Ch. 34 - Explain why the I/M 240 and similar tests are...Ch. 34 - How do you test the efficiency of a secondary AIR...Ch. 34 - True or False? No-start, surging, or stalling can...Ch. 34 - List five common causes for high HC emissions.Ch. 34 - Describe carbon monoxide (CO) emissions in...Ch. 34 - A restricted catalytic converter can cause all of...
Ch. 34 - Which of the following statements about EVAP...Ch. 34 - As a catalytic converter begins to deteriorate,...Ch. 34 - How much pressure does a typical EVAP pressure...Ch. 34 - Which of the following exhaust gases is typically...Ch. 34 - Prob. 15RQCh. 34 - While discussing the proper way to test a...Ch. 34 - Prob. 2ASRQCh. 34 - While discussing catalytic converter diagnosis:...Ch. 34 - While discussing EGR valve diagnosis: Technician A...Ch. 34 - While discussing EGR valve diagnosis: Technician A...Ch. 34 - When discussing the diagnosis of a positive back...Ch. 34 - While diagnosing a PCV problem: Technician A says...Ch. 34 - Technician A says that the AIR system should pump...Ch. 34 - While discussing PCV system diagnosis: Technician...Ch. 34 - While discussing EVAP testing: Technician A says...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Technician A says that the catalytic converter is used only to quiet the noise of the exhaust. Technician B says that the catalytic converter is used to alter the contents of the engines exhaust. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardTrue or False? Engine misfires can cause a catalytic converter to overheat.arrow_forwardfuel additive are being discussed. technician A says adding oxygenates to gasoline increases fuel economy. technician B says adding 10 percent ethanol to gasoline may boost the octane rating 2.5 to 3 points. who is correct?arrow_forward
- While discussing electronic fuel injection principles: Technician A says that the PCM always adjusts the air-fuel ratio in response to the O2S signals. Technician B says that cold air is dense, which is why the PCM enriches the mixture when the engine is cold. Who is correct?arrow_forwardExplain how the computer controls the air-fuel ratio on an EFI system.arrow_forwardDescribe carbon monoxide (CO) emissions in relation to air-fuel ratio.arrow_forward
- While discussing the proper way to test a catalytic converter: Technician A says that a pressure gauge can be inserted into the oxygen sensor bore and the backpressure caused by the converter measured. Technician B says that restrictions in the converter can be checked with a vacuum gauge while the engine is being quickly accelerated. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor Barrow_forwardA restricted catalytic converter can cause all of the following except. a. stalling after the engine starts b. popping or backfiring through the intake manifold c. a drop in engine vacuum d. increased power at high speedsarrow_forwardWhile discussing the catalyst efficiency monitor: Technician A says that if the catalytic converter is not reducing emissions properly, the voltage frequency increases on the downstream HO2S. Technician B says that if a fault occurs in the catalyst monitor system on three drive cycles, the MIL will be illuminated. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- Name the three types of emissions being controlled in gasoline engines.arrow_forwardTechnician A says that dedicated vehicles are those designed to use one particular type of fuel. Technician B says that bi-fuel vehicles can operate solely on an alcohol-based fuel or unleaded gasoline, or a mixture of the two, which gives the driver flexibility and convenience when refilling the fuel tank. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardWhile discussing air-fuel ratios: Technician A says that a stoichiometric mixture is theoretically the best combination of fuel and air to provide for total combustion. Technician B says that a stoichiometric mixture always results in complete combustion. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Extent of Reaction; Author: LearnChemE;https://www.youtube.com/watch?v=__stMf3OLP4;License: Standard Youtube License