2. Technician A says that the purpose of the steering wheel holder is to make sure that the steering wheel is centered after the alignment. Technician B says that if the steering wheel is not centered after an alignment, it should be pulled off the column and positioned correctly. Who is correct? a. Technician A c. Both A and B b. Technician B d. Neither A nor B

2. Technician A says that the purpose of the steering wheel holder is to make sure that the steering wheel is centered after the alignment. Technician B says that if the steering wheel is not centered after an alignment, it should be pulled off the column and positioned correctly. Who is correct? a. Technician A c. Both A and B b. Technician B d. Neither A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter49: Wheel Alignment

Section: Chapter Questions

Problem 11RQ: Which of the following is a good definition of SAI? Forward tilt of the top of the steering knuckle...

See similar textbooks

Similar questions

Which of the following is a good definition of SAI?a. Forward tilt of the top of the steering knuckleb. Inward tilt of the spindle steering armc. Inward tilt of the top of the ball joint or strutd. Outward tilt of the top of the ball joint or strut
Define dynamic and static wheel balance.
Technician A says that on FWD vehicles, the front wheels toe-out while the rear wheels on an independent suspension try to toe-in as the vehicle moves ahead. Technician B says that on RWD vehicles, the front wheels tend to toe-in while the rear wheels toe-out in response to rolling resistance as suspension compliance. Who is correct?
Compare and contrast rear engine rear wheel drive lay out with front engine rear wheel drive.
Technician A says that play in the steering gear is the probable cause of a shimmy. Technician B says that it could be loose steering linkage. Who is correct?
While discussing steering problems: Technician A says that a “jerky” steering wheel and a “clunking” noise could indicate worn steering column U-joints. Technician B says that lack of assist and a “growling” noise in a fluid-filled steering pump could indicate a hose or pump internal restriction. Who is correct?
Technician A says that electronically controlled power-steering systems allow for power assistance even when an engine stalls. technician B says tha an electronic rack and pinion system provides power assistance even when the engine stalls. who is correct?
Technician A says that the front wheel bearings on atypical FWD car are pressed in and out of the steeringknuckle assembly. Technician B says that the frontwheel bearings on a typical FWD may be bolted intothe steering knuckle. Who is correct?a. Technician A onlyb. Technician B onlyc. Both A and Bd. Neither A nor B
In a two ram hydraulic steering gear the diameter of the rams is 280mm, diameter of the rudder stock is 350mm ...
Technician A says a wheel alignment rack should include rear slip plates. Technician B says a four wheel alignment can be performed on a 2 wheel alignment machine with some extra work. who is correct?
when discussing shift problems, technician A says that worn or broken engine and transaxle mounts can cause a transaxle to have shifting problems. technician b says that poor shift boot alignment can cause a transaxle to jump out of gear
32. Technician A says hypoid gearset are only used in RWD vehicle drivetrains. Technician B says hypoid gearset multiply torque. Which technician is correct? A- Technician A B- Technician B C- Both A and B D- Neither A nor B.