While discussing how to remove the piston from a brake caliper: Technician A says that the dust boot should be removed, then a large dull screwdriver should be inserted into the piston groove to pry the piston out. Technician B says that air pressure should be injected into the bleeder screw’s bore to force the piston out of the caliper. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B

While discussing how to remove the piston from a brake caliper: Technician A says that the dust boot should be removed, then a large dull screwdriver should be inserted into the piston groove to pry the piston out. Technician B says that air pressure should be injected into the bleeder screw’s bore to force the piston out of the caliper. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter50: Brake Systems

Section: Chapter Questions

Problem 4ASRQ: While discussing quick take-up master cylinders: Technician A says that this design allows for...

See similar textbooks

Similar questions

Explain how drum brakes create a self-multiplying brake force.
While discussing how to remove the piston from a brake caliper: Technician A says that the dust boot should be removed, then a large dull screw-driver should be inserted into the piston groove to pry the piston out. Technician B says that air pressure should be injected into the bleeder screw’s bore to force the piston out of the caliper. Who is correct?
Describe the procedure for using compressed air to remove a piston from a brake caliper.
it has been determined that chatter and brake pull are being caused by hard spots on the brake drum: Technician A say that the problem can be solved by grinding off the hard spots. Technician B says that the drum must be replaced. who is correct?
What is the difference between block brakes with short and long shoes?
Which of the following is not a factor in determiningthe effectiveness of a brake system?a. Heat dissipationb. Lubricantc. Pressured. Frictional contact area
Technician A says that an out-of-round drum can cause a pulsating brake pedal. Technician B says that an out-of-round drum can cause the brakes to grab. Who is correct?
Which of the following is not likely to cause a pulsating brake pedal? a. Loose wheel bearings b. Worn brake pad linings c. Excessive lateral runout d. Nonparallel rotors
find Torque Required to Apply Brake.
The basic frictional parts of a brake system are being discussed: Technician A says that the harder the frictional parts are pushed together, the higher the friction. Technician B says that the harder the frictional parts are pushed together, the more heat is developed. Who is correct? Technician A only Technician B only Both A and B Neither A nor B
Technician A says that a grinding noise from a drum brake when it is not applied can be caused by a bad wheel bearing. Technician B says that a grinding noise from a drum brake when it is not applied can be caused by worn brake hardware. Who is correct? Technician A only Technician B only Both A and B Neither A nor B
While discussing quick take-up master cylinders: Technician A says that this design allows for increased braking power. Technician B says that this design is only used on drum brake systems. Who is correct? Technician A only Technician B only Both A and B Neither A nor B