BuyFindarrow_forward

Automotive Technology: A Systems A...

6th Edition
Jack Erjavec + 1 other
ISBN: 9781133612315

Solutions

Chapter
Section
BuyFindarrow_forward

Automotive Technology: A Systems A...

6th Edition
Jack Erjavec + 1 other
ISBN: 9781133612315
Textbook Problem

While discussing a clutch alignment tool. Technician A says that the part of the tool that fits into the clutch plate must have a slightly larger OD (outside diameter) than the bore in the disc. Technician B says that the OD of the part of the tool that goes into the pilot must be slightly smaller than the ID (inside diameter) of the pilot bushing. Who is correct?

  1. Technician A

  • Both A and B
  • Technician B
  • Neither A nor B
  • To determine

    The technician with correct approach while discussing a clutch alignment tool.

    Explanation

    Given information:

    Technician A says that the part of the tool that fits into the clutch plate must have a slightly larger OD (outside diameter) than the bore in the disc.

    Technician B says that the OD of the part of the tool that goes into the pilot must be slightly smaller than the ID (inside diameter) of the pilot bushing.

    A clutch alignment tool is used so that the clutch disc is maintained at the center on the flywheel.

    The alignment tool is allowed to pass through the shaft input and the clutch disc...

    Still sussing out bartleby?

    Check out a sample textbook solution.

    See a sample solution

    The Solution to Your Study Problems

    Bartleby provides explanations to thousands of textbook problems written by our experts, many with advanced degrees!

    Get Started

    Additional Engineering Solutions

    Find more solutions based on key concepts

    Show solutions add

    The standard taper in most lathe tailstocks is the _______ taper.

    Precision Machining Technology (MindTap Course List)

    Describe two different methods that you can use to approximate an area of something.

    Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

    What e the main principles of source document design?

    Systems Analysis and Design (Shelly Cashman Series) (MindTap Course List)

    Define the Service Point. ______________

    EBK ELECTRICAL WIRING RESIDENTIAL