(a)
Interpretation:
The dew point line(s) from the given graphs is to be identified.
Concept introduction:
The formula to calculate the total pressure of the system with respect to the mole fraction in solution is,
Where,
•
•
•
The plot between the vapor mole fraction and total pressure give the dew point line.
(b)
Interpretation:
The bubble point line(s) from the given graphs is to be identified.
Concept introduction:
The formula to calculate the total pressure of the system with respect to the mole fraction in solution is,
Where,
•
•
•
The plot between the liquid mole fraction and total pressure give the bubble point line.
(c)
Interpretation:
The fractional distillation of a
Concept introduction:
The formula to calculate the total pressure of the system with respect to the mole fraction in solution is,
Where,
•
•
•
Want to see the full answer?
Check out a sample textbook solutionChapter 7 Solutions
Physical Chemistry
- During the formation of the n-butyl bromide, a washing is carried out with the NaHCO3 solution and 2 phases are formed again. What is the organic phase? Justifyarrow_forwardin fractional distillation, how do you tell which liquid is in which fraction and which fraction has a mix of liquids if you are trying to seperate cyclohexane and toluene?? what would the density and boiling point of the first fraction bearrow_forwardCan a mixture of trichloromethane and propanone be separated into the pure components by fractional distillation? Explainarrow_forward
- It is important to always minimize the amount of solvent used, allowing for evaporation. If we add a relatively large excess, we expect our recrystallization to produce lower percent recoveries. A common mistake is to misplace the decimal, resulting in addition of 11x the solvent instead of the recommended 1.1x. If a substance dissolves in a solvent at 1g/468 mL at room temperature and at 1g/13 mL at the solvent's boiling point, what would be the maximum expected amount recovered if using 11x the minimum amount of solvent in recrystallizing 10 g of the substance? Report your answer in grams to one decimal place.It is important to always minimize the amount of solvent used, allowing for evaporation. If we add a relatively large excess, we expect our recrystallization to produce lower percent recoveries. A common mistake is to misplace the decimal, resulting in addition of 11x the solvent instead of the recommended 1.1x. If a substance dissolves in a solvent at 1g/468 mL at room…arrow_forwardThere are two separate phases, one with a composition of 12% phenol and the other with a composition of 60% phenol, from a 210 gram phenol-water mixture at 60 °C with a composition of 35% phenol. Calculate the masses of these phases.arrow_forwardWhy is it important to perform a fractional distillation slowly? What happens if a fractional distillation is done very quickly by rapidly raising the temperature of the heat source?arrow_forward
- A solution of 5.00 g acetic acid in 100 g benzene freezes at 3.380C. A solution of 5.00 g acetic acid in 100 g water freezes at -1.490C. Find the molecular weight of acetic acid from each of these data. What can you conclude about the state of the acetic acid molecules dissolved in each of these solvents?arrow_forward1a. Use the given table to construct a temperature-composition diagram for cyclohexane Toluene mixture. Based on the plot, what is the composition of the distillate obtained by Simple distillation 20 mole percent cyclohexene and 80 mole percent toluene? Show your Work on the plot. 1b. Estimate the composition of the distillate of 20 mole percent of cyclohexane if the Distillation column had three theoretical plates.arrow_forwardIn fractional distillation, liquid can be seen running from the bottom of the distillation column back into the distilling flask. What effect does this returning condensate have on the fractional distillation?arrow_forward
- The blue line on the diagram illustrates the effect of using fractional distillation to separate a mixture of hexane (C6H14) and heptane (C7H16). If one starts a fractional distillation with a 0.20 mole fraction of hexane, what is the approximate mole fraction of hexane in the vapor phase after two evaporation condensation cycles? Figure B A temperaturecomposition diagram for hexane (C6H14)-heptane (C7H16) mixtures.arrow_forwardSodium chloride (NaCl) was isolated from SiO2 and CaCO3 by dissolving it in distilled water. Unmentioned is that CaCO3 is slightly soluble in water (0.001 g/100 mL). Describe the effect this fact will have on each component of the mixture: will the “isolated“ mass of each be greater than, equal to, or less than that in the sample?arrow_forwardWhat is the ratio of benzene and ethyl benzene based on a) molar fraction b) mass; They must be mixed together to maximize ∆_mix S.arrow_forward
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningMacroscale and Microscale Organic ExperimentsChemistryISBN:9781305577190Author:Kenneth L. Williamson, Katherine M. MastersPublisher:Brooks ColeEBK A SMALL SCALE APPROACH TO ORGANIC LChemistryISBN:9781305446021Author:LampmanPublisher:CENGAGE LEARNING - CONSIGNMENT
- Physical ChemistryChemistryISBN:9781133958437Author:Ball, David W. (david Warren), BAER, TomasPublisher:Wadsworth Cengage Learning,