The “rough-in” stage of residential wiring installation.
Explanation of Solution
The rough-in" stage in building or remodeling of a home is defined as the stage of the construction project which begins after the completion of basic framing. The initial wiring and plumbing installations, installation of circuit conduct and mounting of electrical boxes are done during this phase.
This stage always starts with a plan by the engineer of the architect outlining everything and its estimates. The National electrical code (NEC) and other local electrical codes are required to be followed during this stage.
It is the responsibility of the electrician to select the correct type of conductor, type of hardware, suitable material and wiring method as per the guidelines of the National electrical code.
The manufacturers will provide equipment and instructions for installing equipment to the electrical contractor. These instructions should be strictly followed for installation during this stage of wiring.
Want to see more full solutions like this?
Chapter 9 Solutions
Residential Construction Academy: House Wiring (MindTap Course List)
- Calculate the minimum copper conductor size needed for a 120/240-volt electric range branch circuit. The electric range has a nameplate rating of 12 kW. Show all work. (Objective 6-2)arrow_forwardDescribe when an electrician would use a new work box and an old work box. (Objective 2-3)arrow_forwardThe minimum amount of free conductor required at an electrical box used in residential wiring for termination purposes is______________ inches. As long as the box has no dimension Larger than 8 Inches (200 mm), there must be at Least ______ inches of free conductor extending out from the box opening. Name the NEC section that covers this wiring practice. (Objective 9-3)arrow_forward
- Describe how a white Insulated conductor in a cable assembly is reidentified as an ungrounded hot conductor. Name the NEC section that covers this wiring situation. (Objective 9-4)arrow_forwardSmall-appliance branch circuits and laundry branch circuits installed in a dwelling must have a rating of at least__________ amperes. This information is found in NEC Section __________. (Objective 6-2)arrow_forwardThe most often used category-rated UTP cable for voice and data wiring from various outlets back to the service center or other distribution device in a residential application is______. (Objective 16-3)arrow_forward
- Explain the difference between new-work and old-work electrical boxes. (Objective 10-1)arrow_forwardWhen wiring a split-wired receptacle, it is recommended that the part of the duplex receptacle controlled by a switch be the _______half and the part that is hot at all times is the ______ half. (Objective 18-3)arrow_forwardAlthough it is not a specific requirement, most electricians feel that the best place to start a cable run for a branch circuit is at the service panel or subpanel. Explain why this is so. (Objective 11-3)arrow_forward
Residential Construction Academy: House Wiring (M...Civil EngineeringISBN:9781337402415Author:Gregory W FletcherPublisher:Cengage Learning