College Physics
1st Edition
ISBN: 9781938168000
Author: Paul Peter Urone, Roger Hinrichs
Publisher: OpenStax College
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 9, Problem 3PE
Two children push on opposite sides of a door during play. Both push horizontally and perpendicular to the door. One child pushes with a force of 17.5 N at a distance of 0.600 m from the hinges, and the second child pushes at a distance of 0.450 m. What force must the second child exert to keep the door from moving? Assume friction is negligible.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Two children push on opposite sides of the door during play. Both push horizontally and perpendicular to the door. One pushes with the force of 185 N at a distance of 0.600 M from the hinges, and the second pushes at a distance of 0.450 M. What force must the second exert to keep the door from moving? Assume friction is negligible.
n?
As shown below, a sign weighing 434 N is hanging (via a wire) from a uniform 480 N beam of length L. Additionally, the beam is attached to a cable that makes an angle ? (? = 30°) with the beam.
WebAssign Plot Determine the tension in the cable and the magnitude & direction of the force the hinge (the orange circle) exerts on the beam.Cable tension = 653.6 N Incorrect: Your answer is incorrect.
Hinge force = 815.597 N
Direction of hinge force = 46.05 relative to the vertical in quadrant 1 (incorrect)
A person who weighs 775 N supports himself on the ball of one foot. The normal force N = 775 N pushes up on the ball of the foot on one side of the ankle joint, while the Achilles tendon pulls up on the foot on the other side of the joint. The center of gravity of the person is located right above the tibia.
What is the tension in the Achilles tendon? If the force acting is upward, enter a positive value and if the force acting is downward, enter a negative value.
Chapter 9 Solutions
College Physics
Ch. 9 - What can you say about the velocity of a moving...Ch. 9 - Under what conditions can a rotating body be in...Ch. 9 - What three factors affect the torque created by a...Ch. 9 - A wrecking ball is being used to knock down a...Ch. 9 - Mechanics put a length of Pipe over the handle of...Ch. 9 - A round pencil lying on its side as in Figure 9.13...Ch. 9 - Explain the need for tall towers on a suspension...Ch. 9 - When visiting some countries, you may see a person...Ch. 9 - Scissors are like a double-lever "Stem, Which of...Ch. 9 - Suppose you pull a nail at a constant rate using a...
Ch. 9 - Why are the forces exerted on the outside world by...Ch. 9 - Explain why the forces in our joints are several...Ch. 9 - Why are the forces exerted on the outside world by...Ch. 9 - Explain why the forces in our joints are several...Ch. 9 - Certain of dinosaurs were bipedal (walked on two...Ch. 9 - Swimmers and athletes during competition need to...Ch. 9 - If the maximum force the biceps muscle can exert...Ch. 9 - Suppose the biceps muscle was attached through...Ch. 9 - Explain one of the reasons why pregnant women...Ch. 9 - (a) When opening a door, you push on it...Ch. 9 - When tightening a bolt, you push perpendicularly...Ch. 9 - Two children push on opposite sides of a door...Ch. 9 - Use the second condition for equilibrium (net =0 )...Ch. 9 - Repeat the seesaw problem in Example 9.1 with the...Ch. 9 - Suppose a horse leans against a wall as in Figure...Ch. 9 - Two children of mass 20.0 kg and 30.0 kg sit...Ch. 9 - (a) Calculate the magnitude and direction of the...Ch. 9 - A person carries a plank of wood 2.00 m long with...Ch. 9 - A 17.0-m-high and 11.0-m-long wall under...Ch. 9 - (a) What force must be exerted by the wind to...Ch. 9 - Suppose the weight of the drawbridge in Figure...Ch. 9 - Suppose a 900-kg car is on the bridge in Figure...Ch. 9 - A sandwich board advertising sign is constructed...Ch. 9 - (a) What minimum coefficient of friction is needed...Ch. 9 - A gymnast is attempting to perform splits. From...Ch. 9 - To get up on the roof, a person (mass 70.0 kg)...Ch. 9 - In Figure 9.21, the cg of the pole held by the...Ch. 9 - What is the mechanical advantage of a nail puller...Ch. 9 - Suppose you needed to raise a 250-kg mower a...Ch. 9 - a) What is the mechanical advantage of a...Ch. 9 - A typical car has an axle with 1.10 cm radius...Ch. 9 - What force does the nail puller in Exercise 9.19...Ch. 9 - If you used an ideal pulley of the type shown in...Ch. 9 - Repeat Exercise 9.24 for the pulley shown in...Ch. 9 - Verity that the force in the elbow joint in...Ch. 9 - Two muscles in the back of the leg pull on the...Ch. 9 - The upper leg muscle (quadriceps) exerts a force...Ch. 9 - A device for exercising the upper leg muscle is...Ch. 9 - A person working at a drafting board may hold her...Ch. 9 - We analyzed the biceps muscle example with the...Ch. 9 - Even when the head is held erect, as in Figure...Ch. 9 - A 75-kg man stands on his toes by exerting an...Ch. 9 - A father lifts his child as shown in Figure 9.43....Ch. 9 - Unlike most of the other muscles in our bodies,...Ch. 9 - Integrated Concepts Suppose we replace the 4.0-kg...Ch. 9 - (a) What force should the woman in Figure 9.45...Ch. 9 - You have just planted a sturdy 2-m-tall palm tree...Ch. 9 - Unreasonable Results Suppose two children are...Ch. 9 - Construct Your Own Problem Consider a method for...
Additional Science Textbook Solutions
Find more solutions based on key concepts
By counting squares in the following figure, estimate the fraction of argon atoms at T = 300 K that have speeds...
University Physics Volume 2
Q8.1 In splitting logs with a hammer and wedge, is a heavy hammer more effective than a lighter hammer? Why?
University Physics with Modern Physics (14th Edition)
11. If you put your hand into boiling water at 212°F, you will immediately get a serious bum. Yet you readily r...
College Physics (10th Edition)
26. A 10 kg crate is placed on a horizontal conveyor belt. The materials are such that and .
a. Draw a free-...
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
1. If an object is not moving, does that mean that there are no forces acting on it? Explain.
College Physics: A Strategic Approach (3rd Edition)
1. When is energy most evident?
Conceptual Physics (12th Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A crane of mass m1 = 3 000 kg supports a load of mass m2 = 10 000 kg as shown in Figure P10.36. The crane is pivoted with a frictionless pin at A and rests against a smooth support at B. Find the reaction forces at (a) point A and (b) point B. Figure P10.36arrow_forwardA One end of a metal rod of weight Fg and length L presses against a corner between a wall and the floor (Fig. P14.64). A rope is attached to the other end of the rod. Find the magnitude of the tension in the rope if the angle between the rod and the rope is 90.arrow_forwardA wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.arrow_forward
- Problems 33 and 34 are paired. One end of a uniform beam that weighs 2.80 102 N is attached to a wall with a hinge pin. The other end is supported by a cable making the angles shown in Figure P14.33. Find the tension in the cable. FIGURE P14.33 Problems 33 and 34.arrow_forwardTo get up on the roof, a person (mass 70.0 kg) places a 6.00-m aluminum ladder (mass 10.0 kg) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The ladder rests against a plastic rain gutter, which we can assume to be frictionless. The center of mass of the ladder is 2 m from the bottom. The person is standing 3 m from the bottom. What are the magnitudes of the forces on the ladder at the top and bottom?arrow_forwardThe Iron Cross When a gymnast weighing 750 N executes the iron cross as in Figure lN.91a, the primary muscles involved in supporting this position are the latissimus dorsi (lats") and the pectoralis major (pecs"). The rings exert an upward force on the aims and support the weight of the gymnast. The force exerted by the shoulder joint on the arm is labeled Fs, while the two muscles exert a total force Fw on the arm. Estimate the magnitude of the force Fw. Note that one ring supports half the weight of the gymnast, which is 375 N as indicated in Figure P8.91b. Assume that the force Fw acts at an angle of 45 below the horizontal at a distance of 4.0 cm from the shoulder joint In your estimate, take the distance from the shoulder joint to the hand to be L = 70 cm and ignore the weight of the arm.arrow_forward
- How do you do this? A hungry bear weighing 700 N walks out on a beam in an attempt to retrieve a basket of goodies hanging at the end of the beam (see figure below). The beam is uniform, weighs 200 N, and is 6.00 m long, and it is supported by a wire at an angle of ? = 60.0°. The basket weighs 80.0 N. a) When the bear is at x = 1.00 m, find the tension (in N) in the wire supporting the beam and the components of the force exerted by the wall on the left end of the beam. b) If the wire can withstand a maximum tension of 875 N, what is the maximum distance (in m) the bear can walk before the wire breaks?arrow_forwardA hungry bear weighing 700 N walks out on a beam in an attempt to retrieve a basket of goodies hanging at the end of the beam (Fig. P8.22). The beam is uniform, weighs 200 N, and is 6.00 m long, and it is supported by a wire at an angle of 0 = 60.0°. The basket weighs 80.0 N. (a) Draw a force diagram for the beam. (b) When the bear is at x = 1.00 m, find the tension in the wire supporting the beam and the components of the force exerted by the wall on the left end of the beam. (c) If the wire can withstand a maximum tension of 900 N, what is the maximum distance the bear can walk before the wire breaks?arrow_forwardThe wheels, axle, and handles of a wheelbarrow weigh W = 58 N. The load chamber and its contents weigh WL = 580 N. The drawing shows these two forces in two different wheelbarrow designs. To support the wheelbarrow in equilibrium, the man’s hands apply a force to the handles that is directed vertically upward. Consider a rotational axis at the point where the tire contacts the ground, directed perpendicular to the plane of the paper. Find the magnitude of the man’s force for both designs.arrow_forward
- A 145 N sign is supported by two ropes. One rope pulls up and to the right ?1=29.5∘ above the horizontal with a tension T1 , and the other rope pulls up and to the left ?2=47.5∘ above the horizontal with a tension T2 , as shown in the figure. Find the tensions T1 and T2 respectivelyarrow_forwardTwo painters are carrying a uniform horizontal ladder that is 12 feet long and weighs 200 N. If one person applies an upward force equal to 85 N at one end, at what point does the other person lift?arrow_forwardA wooden plank with a mass of 50.968 kg is supprted by two cable at its ends. At what location should a box of mass 20.387 kg be placed for one cable to exert a force of 125 N more than the other cable? Note: the location is the distance from each cable please show full solution, figure and fbd.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781285737027
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781938168000
Author:Paul Peter Urone, Roger Hinrichs
Publisher:OpenStax College
What is Torque? | Physics | Extraclass.com; Author: Extraclass Official;https://www.youtube.com/watch?v=zXxrAJld9mo;License: Standard YouTube License, CC-BY