1. Undisturbed soil sample was collected from the field in steel Shelby tubes for laboratoryevaluation. The tube sample has a diameter of 2.8 in., length of 22 in., and a moist weightaof 9.56 lb. If the oven-dried weight was 8.51 lb, and Gs = 2.69, calculate the following:a. Moist unit weightb. Field moisture contentc. Dry unit weightd. Void ratioe. Degree of saturation

Given data- Diameter of the sample d=2.8 inch, Length l=22 inch, Moist weight wm=9.56 lb, Dry weight…

1. Undisturbed soil sample was collected from the field in steel Shelby tubes for laboratory evaluation. The tube sample has a diameter of 2.8 in., length of 22 in., and a moist weight of 9.56 lb. If the oven-dried weight was 8.51 lb, and Gs = 2.69, calculate the following: a. Moist unit weight b. Field moisture content c. Dry unit weight d. Void ratio e. Degree of saturation

1. Undisturbed soil sample was collected from the field in steel Shelby tubes for laboratory evaluation. The tube sample has a diameter of 2.8 in., length of 22 in., and a moist weight of 9.56 lb. If the oven-dried weight was 8.51 lb, and Gs = 2.69, calculate the following: a. Moist unit weight b. Field moisture content c. Dry unit weight d. Void ratio e. Degree of saturation

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter5: Soil Compaction

Section: Chapter Questions

Problem 5.17CTP

See similar textbooks

Similar questions

7 Undisturbed soil sample was collected from the field in steel Shelby tubes for Iaboratory evaluation. The tube sample has a diameter of 71 mm, length of 558 mm, and a moist weight of 42.5 x 10- kN. If the oven-dried weight was 37.85 x 10-3 kN, and G, = 2.69, calculate the following: a. Moist unit weight b. Field moisture content c. Dry unit weight d. Void ratio e. Degree of saturation 72% and
Q1. Undisturbed soil sample was collected from the filed in Melbourne in steel tube for laboratory evaluation. The tube has the diameter of 85 mm, length of 170 mm and the moisture weight of 1600 g. If the oven-dried weight was 1200 g and Gs = 2.69, calculate the followings:a) Bulk unit weight (?) in kN/m3b) Field moisture content (w)c) Void ratio & porosity (e and ⴄ) d) Degree of saturation (Sr)
A sample of field soil is tested in the laboratory. The results of Standard and Modified Proctor tests at optimum moisture content are given in the Table below: Standard Proctor test Modified Proctor test Mass of wet soil in the mold (g) 1800 2000 Volume of Proctor mold (cm2) 900 1000 Optimum moisture content (%) 12 10 At the field, a sample of 600 cm3 of this soil weighted 1200 g. The weight of water in this sample was 200 g. Find the following: 1- Degree of compaction (Relative compaction) (R%) at Standard Proctor test. 2- Degree of compaction (Relative compaction) (R%) at Modified Proctor test.
An undisturbed soil sample was prepared for a triaxial testing. The cylindrical soil sample is 50 mm in diameter and 100 mm long. It has a mass of 360 g. After finding the mass of the entire sample, a small portion was removed and a moisture content test was performed on it. The result of the moisture content test is shown in Table 3(a). Given the specific gravity, G, is 2.70. (i) Compute the moisture content (%) of the soil sample. (ii) By using the soil phase diagram, determine the bulk density (kg/m³), dry density (kg/m³), void ratio, porosity (%) and degree of saturation (%) of the soil sample.
A sample of field soil is tested in the laboratory. The results of Standard and Modified Proctor tests at optimum moisture content are given in the Table below: Standard Proctor test Modified Proctor test Mass of wet soil in the mold (g) 1800 2000 Volume of Proctor mold (cm?) 900 1000 Optimum moisture content (%) 12 10 At the field, a sample of 600 cm3 of this soil weighted 1200 g. The weight of water in this sample was 200 g. Find the following: 1- Degree of compaction (Relative compaction) (R%) at Standard Proctor test. 2- Degree of compaction (Relative compaction) (R%) at Modified Proctor test.
(detailed and clean solution please) large soil sample obtained from a borrow pit has a wet mass of 26.50kg. the in – place volume occupied by the sample is 0.013m3. A small portion of the sample is used to determine the water content; the wet mass is 135g, and after drying in an oven, the mass is 117g. a. Determine the soil’s water content. b. Determine the soil wet and dry density for conditions at the borrow pit.
Sand cone equipment is used to perform Field density test on a compacted arth fil. Soil sample dug from the test hole = 19.88 N Dry weight of soil sample = 17.92 N Ottawa sand used to fill the hole weighs 16.05 N and is known to have a density of 15.74 HN/m. Which of the following gives the water content of the tested soil? O a. 15.45% O b. 12.08% O c. 14.96% O d. 10.94% e. 11.12%
Afalling-head permeability test is performed on a fine-grained soil. The soil sample has a length of 120 mm and a cross-sectional area of 600 mm2. The water in the standpipe flowing into the soil is 0.60 m above the top of the sample at the start of the test. It falls 50 mm in 30 minutes. The standpipe has a cross-sectional area of 200 mm2. (a) Make a sketch of the described conditions. (b) What is the coefficient of permeability in millimeters per second? (c) What is the coefficient of permeability in feet per minute? (d) On the basis of the calculated value for khyd, what is the probable soil type?
Don't attempt wrong i will downvote.....A cylindrical soil sample, 7.3 cm in diameter and 16.8 cm in height, is tested in a constant-head permeability apparatus. A constant head of 75 cm is maintained during the test. After 1 minute of testing, a total of 945.7 gm of water was collected. The temperature was 20 oC. The void ratio of the soil was 0.43. Calculate the following: 1. The hydraulic gradient 2. The flow rate 3. The discharge velocity 4. The seepage force per unit volume 5. The coefficient of permeability
Undisturbed soil sample was collected from the field in steel Shelby tubes for laboratory evaluation. The tube sample has a diameter of 71 mm, length of 558 mm, and a moist weight of 42.5 x 10-3 If the oven-dried weight was 37.85 x 10-3 kN, and Gs = 2.69, calculate the following: Moist unit weight Field moisture content Dry unit weight Void ratio Degree of saturation
Let us assume that a soil sample taken in the field is taken and it must be identified by the SUCS Method and AASHTO Method. Moisture content = 5.75% Limit liquid = 53.5 Plastic limit = 31.6 Granulometry Sieve % Pass No. 4 100 # 40 68 # 200 54.3 Do you select the best answer? a) Inorganic silt and sand, with low plasticity b) Inorganic clay with low plasticity c) Clay silt, traces of gravel, dark Brown
2) A moist sample was found to have a volume of 22.3 cubic centimeters and to weigh 29.7 grams. The dry weight of the sample was determined to be 23 grams. Take the specific gravity of the soil solids to be 2.70. Determine the following: a) void ratio b) water content, % c) porosity,% d) degree of saturation of the sample, %