3. (40) For the soil system presented below, calculate and draw diagrams of distributions of the total and effective stresses and pore water pressure. Assume an upward water flow with a velocity of 0.000,001 cm/s. SAND e=0.45 8 m Y17.0 kN/m3 S=24% SILTY CLAY = 18.4 kN/m3 W = 18% Y S = 40% 4 m k=0.0002 cm/s 3 m CLAY Y = 19.2 kN/m3 sat k=0.000,004 cm/s 6 m

For the same line loads given in Problem 10.8, determine the vertical stress increase, z, at a point located 4 m below the line load, q2. Refer to Figure 10.41. Determine the vertical stress increase, z, at point A with the following values: q1 = 110 kN/m, q2 = 440 kN/m, x1 = 6 m, x2 = 3 m, and z = 4 m. Figure 10.41

Redo Problem 6.12 using Figure 6.15. 6.12 Refer to Problem 6.1. Using Eqs. (6.3) and (6.29), estimate the average stress increase (av) below the center of the loaded area between depths of 3 m and 6 m. 6.1 A flexible circular area is subjected to a uniformly distributed load of 150 kN/m2 (Figure 6.2). The diameter of the load area is 2 m. Determine the stress increase in a soil mass at points located 3 m below the loaded area at r = 0, 0.4 m, 0.8 m, and 1 m. Use Boussinesqs solution. Figure 6.2 Increase in pressure under a uniformly loaded flexible circular area

For a soil, given: D10 = 0.08 mm D30 = 0.22 mm D60 = 0.41 mm Calculate the uniformity coefficient and the coefficient of gradation of the soil. 2.4 Repeat Problem 2.3 for the following: D10 = 0.24 mm D30 = 0.82 mm D60 = 1.81 mm