3. A flotation plant processes 3,000 tons/day of CuFeS₂ (chalcopyrite). It produces 80 tons Cu concentrate assaying 25 % Cu. If ore analyzes 0.7% Cu, the percent recovery is a. 90.5% b. 98% c. 92.54% d. 95.24%

Q: Calculate the pH of buffers that contain the acid and conjugate base concentrations listed below. a.…

A:

Q: 4.2 Write the equations to be solved for the reaction set B → D ↓ E → F A → ↓ с assuming all…

A: Given reaction: A→k1B→k2DA→k3CB→k4E→k5F Also, all the reactions are of the first order.

Q: Propene is burned to form carbon dioxide and water in a batch reactor: 2C3H6+9026CO2 + 6H₂0 The feed…

A: As per bartleby multiple question or subpart question guidelines, we are supposed to answer only…

Q: A chemical company propose to build an ammonia production plant using Haber process method to…

A: Introduction: Haber's Process: In the Haber process, the atmospheric nitrogen (N2) is converted to…

Q: Catalyst Deactivation

A:

Q: a) A distillation column with a partial reboiler and a total condenser is being used to separate a…

A:

Q: Calculate the molar percentage of ethane in the fuel gas and the percentage excess air fed to the…

A:

Q: For a binary liquid mixture at 301 K and 2.9 bar, we've measured the laboratory molar volume to be…

A:

Q: composition of the overflow V₁ Schuah

A:

Q: A gaseous ammonia (MW = 17 g/mol) is stored in a 30-L tank at 320K. The pressure is kept at 12 atm…

A: WE HAVE,  n = PVRT

Q: H₂ + C₂H2CH₂ (a) Determine the rate law parameters from the data in the table below. There are four…

A: The given data and the given reaction are used to obtain another data table. The new table has data…

Q: Explain the three (3) differences between catalytic cracking and catalytic reforming.

A: Difference Between Catalytic Cracking and Catalytic Reforming Definition CATALYTIC CRACKING…

Q: In a desert chemical plant, the operator wishes to store chilled water underground in a spherical…

A:

Q: A 2-L beaker contains 1.3 L of a volatile solvent solution. The concentration of solvent in the…

A: Given data: Concentration of volatile solvent in the liquid = 1.2 mM Henry’s constant of the solvent…

Q: phase Which obeys the following rate law: Cao = 1 mol₁ L A+S →P→ Derive the expression to calculate…

A: Given data: CAO=1 mol/Litk1=0.25 k2=0.10Da=10

Q: r increase in the enthalpy of the working fluid.

A:

Q: 1. A bubble of pure CO₂ (0.8cm diameter) is injected into a pool of excess liquid at 25°C. The…

A: Given Bubble of CO2 ,d=0.8cm T=25C P=1atm Diameter of the shrunk bubble=0.2cm after 80 sec…

Q: A reaction of H₂ + Cl₂ → HCl occured in a constant temperature and constant pressure flow reactor at…

A: Given data: Temperature = 573.15 K Pressure = 2 atm Composition of feed gas is H2 = 0.8 Inerts = 0.2…

Q: Iculate the steady-state substrate and biomass concentrations in a continuous menter that has an…

A:

Q: Calculate the molar density of the saturated liquid and saturated vapor by the soave/redlich/kwong…

A: Given that- Temperature, T=1100C = 383 K Pressure, P=18.66 bar = 18.66 x 105 bar Molar mass of…

Q: Q2: Producer gas was mixed in a (Y) shaped mixer with air prior to combustion. Assume 3:1 air: fuel…

A: Given that producer gas is mixed with air prior to combustion for which- Air:Fuel ratio =3:1 Air is…

Q: overall rate of reaction, -A.

A:

Q: 2. Dust particles are to be separated from an air stream at 40 °C and 1 atm. The dust particles…

A:

Q: be done in practice. Focus on (1) choice of solvent (II) choice of sample cuvette material (III)…

A:

Q: 4. What is the terminal velocity of a cubic steel particle, 0.40 mm in each side, settling in an oil…

A: Write the expression for terminal velocity as follows: vt = 2mgρACd     ......1   Here, vt is the…

Q: A Newtonian fluid with constant density flows in a parallel-plate apparatus that separated by a…

A:

Q: Redlich-Kwong (RKS)

A:

Q: maximum conversion of A.

A:

Q: 3. Hot water with a temperature of 330 K is flowing through a pipe. Heat loss per unit pipe length…

A:

Q: 16. What is the pH of a solution of 0.7500 M H₂A? Ka2=0.005

A: Given data: Concentration of H2A;[H2A]=0.75 MKa2=0.005

Q: A chemical processing plant is designed to produce 90 mole % pure ethanol. The plant operates in two…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: A discharge of 30 liter/s of water is flowing in the pipeline shown in the figure, what pressure…

A:

Q: Topic: Catalyst Deactivation PROVIDE HANDWRITTEN SOLUTION PLEASE After some time, a catalyst…

A: Given Data  The catalyst sintering happens due to decreased catalyst activity given by the equation…

Q: The given rxn below is conducted in an isochoric batch reactor: k = -1 A+B=C The data for "k"…

A:

Q: The following reaction occurs in a constant - volume batch reactor as follows: A+B=C A → D The…

A:

Q: Please explain, thank you so much

A: EGL refers to the energy grade line, and HGL refers to the hydraulic grade line. For a steady-state…

Q: ing te 2(g) 2(g) 3(g) feed contains 72.23% H2, 18.38% N2, and the balance being argon (inert).…

A:

Q: isothermal CSTR.

A:

Q: In regard of bunker oil, what are the crucial parameters that need to be assessed? Discuss the…

A: Introduction Bunker fuel is the colloquial term for fuel oil used by marine vessels. It is a…

Q: The following liquid-phase irreversible series reaction occurs in an isothermal PFR: K₁ K₂ A B C mol…

A: for given series-reaction , we need to find the optimum space-time to achieve a maximum…

Q: expression for the overall rate

A: Given, A + B↔ C Rate limiting Step - Desorption Step

Q: The general Ksp expression in terms of "S" (molar solubility) of FePO4 is: Select one: a. 10885 O b.…

A: Write the reaction for the dissociation of FePO4 as follows: FePO4  → Fe3+ + PO43- One mole of FePO4…

Q: The specific volume of superheated water vapor at 0.6 MPa and 900°C is 0.90179 m³/kg in the steam…

A: Answer: a)  we know that,  Molecular weight of water = 18 g/mol  we have,  V = RT/P

Q: A column has to separate a mixture of A and B to yield a top product of xD = 0.97 and a bottom…

A: Given data: xD=0.97xW=0.04For bottom section; αAB1=1.8For top section; αAB2=2

Q: Identification of nickel ion

A: Nickel is silvery-gray metal in appearance whos ion mostly exists in +2 oxidation state as Ni+2. It…

Q: The diffusivity of a molecule inside a pore of a catalyst (D in m²s-1) is given by, T D=9.7x10³r, MW…

A:

Q: A stream of 220kmol/h of a binary mixture containing benzene and toluene (45 mol% benzene) needs to…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: yield coefficients

A:

Q: Sulfur dioxide reacts with oxygen to form sulfur trioxide. This reaction is carried out isothermally…

A:

Q: Do a  five problem set about humidification

A: Given data Do a  five problem set about humidification.