4. A Normally-Open Pushbutton is used in the Micro850 PLC control system to control Lamp 1 and Lamp 2 through the PLC program as shown below. When the Pushbutton is initially not touched, the logic function that the PLC program implements can be described as Pushbutton (N.O.) Lamp 1 Rung 1 HH DIO DO1 Pushbutton (N.O.) Lamp 2 Rung 2 H DIO DO2 (a) Lamp 1 is always ON until Lamp 2 is ON (b) Lamp 2 is always ON until Lamp 1 is ON

4. A Normally-Open Pushbutton is used in the Micro850 PLC control system to control Lamp 1 and Lamp 2 through the PLC program as shown below. When the Pushbutton is initially not touched, the logic function that the PLC program implements can be described as Pushbutton (N.O.) Lamp 1 Rung 1 HH DIO DO1 Pushbutton (N.O.) Lamp 2 Rung 2 H DIO DO2 (a) Lamp 1 is always ON until Lamp 2 is ON (b) Lamp 2 is always ON until Lamp 1 is ON

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Draw plc ladder diagram in digital gates circuit
Write atleast 3 advantages of PLC.
2-A) What's the name of the opamp circuit below? Briefly explain the logic. 2-B) Why is there a DC 1 volt offset in Vs sine signal?
Which of the following is an example of a PLC output section? Solenoid valves O Sensors Switches O signal processing elements
Familiarized and understand the PLC Basic Operation and draw an illustration that explains its process
1. When replace a relay control logic by a PLC the cost saving is C. Meduim A. Very segnificant B. Very low D.High for Large power application
Write atleast 3 application of PLC in industries.
Explain the architecture of a PLC system by exploring on I/O modules, CPU,power Supply and programming devices.
Q1)A)What is PLC? What are the components of PLC? Explain different components of PLC with neat sketch
Q2: Level and Temperature Control of a Tank The figure below shows a sketch of an open tank that is installed in the plant of which liquid level and temperature are to be controlled. Design a typical PLC program for this control process. The sequence of operations for this system is as follow: 1. Master start/stop is also provided to shut down or start the entire process 2. To detect high and low level of liquid in the tank, two level switches are used which gives output in digital terms, that is when corresponding levels are detected, it gives output high otherwise remain low. 3. Inlet valve to control inlet process flow and outlet valve to control outlet process flow. 4. When level reaches the Level Low, Outlet flow is blocked, and inlet flow is allowed until high level is achieved. 5. A temperature sensor (NO) is used for measuring the temperature of the tanks. 6. Heating process is used to heat the material in the tank. 7. The heater is switched on when the tank is full, and the…
A burglar alarm rings if the door switch or the window switch is activated. However, a key operated switch silences the alarm. 1. Write the equivalent equation that satisfies the above statement 2. Design the equivalent logic circuit using diodes that best describes the condition stated.
Sketch and explain the block diagram of the program scan algorithm in a Programmable LogicController (PLC). Define the basic timing parameters. What languages are used for PLCprogramming?