5. A parallel-plate capacitor has a plate area of 0.2m² and a plate separation of 0.1 mm. If the charge on each plate has a magnitude of 4 x 106 C the potential difference across the plates is approximately: A. 0; B. 4 x 102 V; C. 1 x 10² V; D. 2 x 10 2 V; E. 4 x 10® v

5. A parallel-plate capacitor has a plate area of 0.2m² and a plate separation of 0.1 mm. If the charge on each plate has a magnitude of 4 x 106 C the potential difference across the plates is approximately: A. 0; B. 4 x 102 V; C. 1 x 10² V; D. 2 x 10 2 V; E. 4 x 10® v

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter25: Surge, Spike, And Lightning Protection

Section: Chapter Questions

Problem 10RQ: In reference to the load, how are capacitors connected to help prevent voltage spikes and surges?...

See similar textbooks

Related questions

Q: 1. Ifa field excitation of 10 A in a certain alternator gives a current of 150 A on short-circuit…

A: NOTE: As per our company guidelines we are supposed to answer only one question.kindly repost other…

Q: A 110-V, 50-Hz single phase induction motor (split -phase) has the following constants for the main…

A: In split phase induction motor main winding and auxiliary winding are connected in parallel. At the…

Q: The displacement vector is D= 6 âz+ 8 ây+ 8 â, in the region y>5 with the dielectric constant e = 7.…

Q: Determine the value of output voltage, Vo for the circuit in Figure Q3(a). Given the barrier…

Q: Do you think that a three – phase induction motor could be used to establish the phase sequence of a…

A: Yes, it is possible that a three- phase induction motor could be used to establish the phase…

Q: H.W.(9): Find the bandwidth and center frequency of the bandstop filter of Fig. 4 F 42 (Answer: B =…

A: The circuit diagram is shown below,

Q: Refer to the given circuit below. Determine the equivalent resistance across terminals a and c if R5…

Q: Construct a truth table for the following logical expressions: F (x, y, z) = x' + y z + y

A: Truth table of following logical expression. F(x,y,z)=x'+yz+y.

Q: Which of the following statements is true about a Moore sequential machine? A. The outputs of a…

A: In this question we need to choose a correct option

Q: Circutt A Circult B 3. Circuit is wired in parallel, and circuit is wired in series.

Q: Given, G2t G3 G5

Q: Consider the 2-bit carry-lookahead adder shown in the figure below. Which of the input and output…

A: In this question we need to choose a correct option

Q: Lab report: Series VS Parallel Circuits Which circuit? Look at the 2 circuits below. I a. In which…

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of a Question can be answered at a time,…

Q: 4) Function generator is a versatile instrument that delivers a choice of different waveforms whose…

A: In this question we will write about function generator and vector voltmeter.....

Q: Problem1. Find VO in the following circuit:

Q: A load of 10,000 kVA, 80% lagging is connected to a 13,200 volts line. How much capacitive reactive…

Q: Consider the choices.(w1)

Q: Determine and sketch: 1) x(t) * h(t) 2) x(t) * m(t) & 3) h(t) * m(t) x(t) h(t) 1 1 1 -1 m(t) 2.

A: In this question, We need to determine the y(t) and draw the sketch of the output y(t)?

Q: Which of the following statements is true about a Moore sequential machine? A. The outputs of a…

Q: Calculate the output voltage in V of an opamp circuit with Vd=2.7 V, Vc=0.3 V, Ad=101 and Ac=2.

Q: 14MA J=1A V 23 KQ

A: Resistance: Resistance opposed the flow of current in electric circuit. It is measured in Ohm's(Ω).…

Q: 8. Find V, for the circuit given below. RF is 10 μΑ, RF 1 ΜΩ V, ν, -?

Q: A magnetic circuit is made of mild steel arranged as shown below. The centre limb is wound with 500…

A: Given:Flux=1.3mWbTurns,N=500area of outer limb=500mm2area of cental limb=800mm2relative permeability…

Q: Both the Biot-Savart and Coulomb's laws exhibit an inverse-square relationship between field and…

A: magnetic field due to moving charge calculated using Biot savart law is B = (μo/4π) × idl(sinθ)/r^2…

Q: The analog signal xa (t) = e(120xt-) +e resulting discrete time signal æ[n]? -j(180nt- is sampled at…

Q: A Voltage Event Recorder (VER) is a device that records voltage fluctuations.

A: VER used for voltage fluctuations.

Q: Given in Figure la is an operational amplifier used as a summing amplifier that accepts three…

A: Summing amplifier is used to process analog signal.summing amplifier is used in a audio amplifier.…

Q: (d) An analog receiver system consists of an antenna and three cascaded Radio Frequency (RF)…

A: An analog receiver system consists of an antenna and three cascaded radio frequency amplifiers as…

Q: QUESTION S: 1. what would the voliage be at the tapped middie point? R,= 132 2. what is Vo (peak) if…

A: It is given that: Vppri=100 V

Q: G2 X. G G5 Transfor function y

Q: Use KVL, KCL, and Cramer's Rule to determine the second order equation for the inductive current…

Q: w.(2): Determine the cutoff frequency of the lowpass filter described by 4 H(@) = 2 + jw10 d the…

Q: Differentiate the two types of instruction in PLC. COUNT UP COUNTER, COUNT UP/DOWN COUNTER

A: We need to differentiate between the two types of instruction in PLC. COUNT UP COUNTER COUNT…

Q: What is the significance of a negative indication on a wattmeter? Explain in 3 to 5 sentences

A: Wattmer Connection:

Q: A very small resistance 100 m ohm is measured using kelvin double bridge. The standard resistor is…

A: The unknown resistance can be measured using various bridges and kelvin double bridge is one of…

Q: 1. The diagram below shows an the current is divided between the light bulbs. the same current flows…

A: We need to select correct option for given circuit

Q: ex for the Civouit Shown Comfute ų and nodal ateLysiS using 145 Yolt

Q: Find V, for the circuit given below. 10K 100K 20K goVee 10 V 30K b-Vcc O6 V 20K 12 V 40K

Q: I cannot understand it

Q: Q1: which of these statements are True and which one is False? 3. The phase margin is the change in…

A: The open loop and closed loop system have a little difference i.e., closed loop system has and…

Q: 1. A 30-kVA, 440-V. 50-Hz, 3-0, star-connected synchronous generator gave the following test data :…

A: Power: P=30 kVA Voltage, V=440 V Frequency, f= 50 Hz Table will be, Field Current 2 4 6 7 8 10 12…

Q: 3. A 3-0 star-connected alternator is rated at 1600 kVA, 13,500 V. The armature effecti resistance…

A: In this question we will find voltage regulation of alternator with given power factor.... Note :-…

Q: Given this transformer with load, what is the expected phase of the primary and secondary voltage?…

A: The solution is provided in the following section.

Q: Find Vo for the circuit given below.

A: The output voltage can be calculated by using the ideal opamp characteristics and by using the basic…

Q: device that selects one of many inputs and links it to a single output. a Display of seven segments…

A: This is the question regarding digital circuits thete are basically two types of digital circuits…

Q: for the

Q: Q2/ Draw the following data formats for the bit stream [1 10011 0] (i) (ii) (iii) (iv) Polar NRZ…

Q: The circuit and transistor parameters are given as follows: B= 130, lco 0.2 mA, VA= 80 V, V,-1 V,…

A: Given data, β=130ICQ=0.2mAVA=80VVi=1VV+=3.3VR1=150kΩR2=5kΩ

Q: Q5/ The bit sequence [1 01 11 01011] is to be transmitted using following formulas: (i) (ii) (iii)…

Q: Q2/Complete the following sentences: 1) If an A.C position is chosen of Input Coupling Selector in…

A: The oscilloscope is a instrument which can be used to monitor the electrical signals in a wire by…

Question

answer with clear and concise solution

5. A parallel-plate capacitor has a plate area of 0.2m² and a plate separation of 0.1
mm. If the charge on each plate has a magnitude of 4 x 106 C the potential
difference across the plates is approximately: A. 0; B. 4 x 102 V; C. 1 × 10² V; D. 2
x 10 2 V; E. 4 × 10® v

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
4. In what form is the energy of a capacitor stored?
Can current flow through a capacitor?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
C) A 25 A electrodynamic ammeter is controlled by a spring having a constant of 5.7295x 10-6 Nm/rad. The full scale deflection is 110°. Determine the inductance of the instrument while measuring a current of 20 A. The mutual inductance at 0° deflection is 4 u H and the change in mutual inductance is linear with the deflection.