Answered: 9, = 18 kPa H = 3 m Ysar = 18 kN/m3 %3D…

Engineering

Civil Engineering

9, = 18 kPa H = 3 m Ysar = 18 kN/m3 %3D O= 25° H2 =4.5 m Ysat = 19.5 kN/m3 %3D O' = 30° %3D

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Consider the retaming wall shown in the Figure below Calculate the Rankine pasSIve force per unit…

A: Lateral Rankine passive earth pressure is applied at each elevation. Pressure due to Gwt table is…

Q: %; Angle of internal Friction = 30°. Compute the location of the active force in meters from the…

Q: Q1/ The uniform ladder is 2-m long and makes an angle of = 60° with the floor. If the wall at B is…

Q: Consider the retaining wall shown in the Figure below. Calculate the Coulomb's active force per unit…

A: Calculate the Coulomb's active force per unit length of the wall and the location of the line of…

Q: 1.0 m wide cover articulated at Point B, as shown in the figure below it is attached to the base and…

Q: Examine the rotational stability of the wall below 3 m 32 y=20 kN/m' $ = 36° For the right side: 6 =…

A: Given: A retaining wall as shown below Required: To examine rotational stability

Q: A 3-m high cantilever retaining wall is acted on by an active force that varies uniformly from 3 KNm…

Q: The retaining wall shown has a height of 6m with its ground watertable located at a depth of 2m…

Q: An open horizontal tank, 1.5m high, 2m wide, and 5m long is full oil (sp gr=0.9. it is accelerated…

Q: A vertical rectangular gate 2m wide and 4m high is submerged in salt water with its top edge 1m…

A: Hydrostatic force (f) = ȣAy Where ȣ - unit weight of salt water ȣ = 10.045 kN/m A – Area of the gate…

Q: A long retaining wall is braced by wood shores set at an angle of 30° and supported by concrete…

Q: Consider the retaining wall shown in the Coulomb's active force per unit length of th line of action…

Q: Wind blows on the side of the fully enclosed hospital located on open flat terrain in Arizona.…

A: The given data is: Length of hospital=200 ft Height of hospital=30 ft

Q: Calculate the active and passive earth pressures AND. determine the distance at which the net active…

A: Given: Dry density Saturated density Cohesion Angle of friction To find: Active earth pressure

Q: A gate 5-m wide is hinged at point B and rests against a smooth wall at point A. A Seawater: 64 N/m3…

Q: The structure is worked up by El-Centro earthquake with zeta=five%. it's far required to investigate…

Q: Y=15 kN/m -28° c'-0 4m G.WT. Yu 20 kN/m 4-33° 4m IT

Q: 1) Which of the following most nearly gives the passive force per unit length of the wall using…

Q: A circular plate of 3 m diameter is under water with its plane making an angle of 30degree with the…

A: Hydrostatic Force will be Fp=pgx¯A p = density of fluid

Q: A 9 m cantilever retaining wall is subjected to active pressure increasing from 5 kN/m at the top…

A: given question is calculate reaction RA=1245+59=225KN

Q: Hydrostatic force acting on the wall. .The resisting moment of the dam to overturning in kN-m. -…

Q: A smooth backed vertical wall is 6.3m high and retains a soil with a bulk unit weight of 18 KN/m^3…

Q: "For the same problem in question 17, calculate the total active force (Pa) acting on the wall." Pw…

A: Given Data:γsat=17 Kn/m3Cu=23 Kpaϕu=0It is asked to calculate Total active force acting on the…

Q: A 0.50 m diameter window has its center three meters below the water surface, determine the force…

A: Given data in question Diameter 3 m below the water surface To find out Force acting on the…

Q: Determine the active force per unit length of the wall y = 16 kN/m 6' = 30° c' 0 3 m Groundwater…

A: To find active force per unit length of wall

Q: 9, = 22.5 kPa %3D H, = 2.5 m Yr = 17 kN/m3 O = 25° %3D H2 = 4.5 m Ysat = 18.5 kN/m3 O = 30° %3D a)…

Q: Determine the resultant force the water exerts on side AB and on side CD of the inclined wall. The…

Q: 2 m below the water surface. A is 2.92 m to the right of B and 2.2 m above B. ompute the force on…

Q: ...: The ladder in fig.(1), has a uniform weight of 100N and rests against the wall at B.If the…

Q: The wall shown in Q. 2 is 12-ft high and consists of 2 × 4 studs. On each side is acoustical…

Q: Determine the total active force per meter acting on the wall along with its point of application. q…

A: Consider the figure shown below.

Q: Location of the total earth thrust from the base of wall (in meter) ya = f. Minimum width B (in…

Q: 2. A rectangular gate 1.2 m wide rests against a smooth wall at A. It is hinged at B located at 5.2…

A: bjUgyuuuyhh

Q: ground surface y = 16.5 kN/m3 $ = 30° %3D 3m water table Ysat = 19 kN/m3 $ = 30° 3m

A: The answer of this problem is found to be Force=132.18KN per metre length For explanation please see…

Q: Determine the total active force per unit acting on the retaining wall along with its point of…

Q: Determine the active force per unit length of the wall y = 16 kN/m ' = 30 c' = 0 3 m Groundwater…

Q: If the wall can withstand a maximum lateral force of 200 kN, determine the maximum surcharge that…

Q: Q3: for the wall shown: 3m 4m ↓ -2. 20kpa #G..T c'. 5okpa $=15₁ Y= 19.8 11eN/m³ c'= lookpa 410°, Y.…

Q: 3. What is the difference in the position of the pressure center (h.) for the gate if it is…

Q: 0.50m Calculate the total lateral force in KN on the wall due to active pressure. Determine the…

A: Step 1: Retaining walls are used to support soil laterally to retain it at different levels or of…

Q: Practice Problems 4.16E The wall shown in Fig. 4.28 is 20 ft long. (a) Calculate the total force on…

Q: Kindly give me both right solutions with clear calculations. Note: Both questions are subbarts…

A: H= Height of the retaining wall = 4 m. Type of soil = loose sand ⇒ cohesion, C = 0 φ = Angle of…

Q: 2m WIDE PI 3m Find the magnitude of the hydrostatic force. a. 146.7 kN b. 199.3 kN Im 4m c. 294.3 KN…

Q: 1) Which of the following most nearly gives the passive force per unit length of the wall using…

Q: Calculate the resulting hydrostatic force and its position on the wall that is placed at an angle a…

A: From the given question it is required to calculate the Resultant hydrostatic force acting on the…

Q: 12.8 Refer to Figure 12.12a. Given: H = 4 m, y = 16.5 kN/m², ' = 30°, c' = 0, and 3= 85°. Determine…

A: Given :

Q: 2. A vertical gate in a tunnel 6 m in diameter has water on one side and air on the other side. The…

Q: Determine the hydrostatic force acting on the gate. b) Determine the tension in the cable…

A: Water at rest, is known to exert equal pressure in all directions, thus, the hydrostatic force…

Q: The ladder has a uniform weight of 80N and rests against the wall at B.If the coefficient of…

Question

Compute for the following:

a) The total active force on the wall in kN
b) The total active moment at the bottom of the wall in kN-m
c) Required passive force to maintain equilibrium in kN
d) Theoretical passive force in kN
e) total theoretical passive moment at the bottom of the wall in kN-m

below the top of the wall.
9, = 18 kPa
%3D
TTTTTT
H =3 m
Ysar = 18 kN/m3
%3D
O= 25°
H2 = 4.5 m
Ysar = 19.5 kN/m3
%3D
O' = 30°
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

What is the location of zero shear from A in %3D %3D meters? Given: w = 31, a = 5, b = 3, and c = 2. w kN/m D A Stomt В a m b m RD RA
The cantilever wall proven in under determine has the following properties: uniform mass,m=zero.seventy seven kN.s ^ 2 / (m ^ 2) uniform inertia,EI=0.4 * 10 ^ 6 * kN.m^ 2 In addition, the wall is sporting concentrated hundreds on the pinnacle and at midheight as shown within the same parent. The deflected shape of this structure is given as w(x) = 1 - cos(pi*x / 2 * H) The structure is worked up by El-Centro earthquake with zeta=five%. it's far required to investigate this wall below situations;( A) If the wall does not bring any concentrated loads. (B) The wall contains each concentrated hundreds M_{1} and M_{2} as shown within the equal figure.For each cases (A) and (B), determine:(1) The most pinnacle displacement, base second, and base shear. (2) The maximum displacement, moment, and shear at midheight.
-2 ft 10 kip 4 in. B B 1.5 ft-- 4 in. 6 in. ● 4 kip 0.5 ft 2 ft- - Change the magnitude of 10 kip to 7.9 kip - Change the outer width of the cross section from 6 in to 8 in - Keep the wall thickness 1 in (example, instead of 4 inches, the inner width of the cross section is equal to the outer width minus 2 inches). - Determine the maximum in-plane shear stress in the box beam at point A. Show the results on an element located at this point - Determine the principal stresses in the box beam at point B. Show the results on an element located at this point
arjumo Но |ha PA r Figure 1 calculais
80mm Q2/ 20mm 70mm IF: N.A. |= 15.52 mm4 V=10 KN 160 mm 110mm Compute the shear at horizontal layer 20 mm apart from bottom to top depending on the calculation of the area up of the taken layer. 20mm
Calculate the active and passive earth pressures AND. determine the distance at which the net active and passive force will acting on the retaining wall Ya=19 kN /m3 - 34 c=3kp 2m 6=34 %3D Vd = 17.54kN/m3 8=32"; ċ=o %3D 1.5m %3D = 21. BkN/m3 V sat 8= 31; c'= o %3D 1.5m %3D Ysat = 22.lkN/m3 5 m 8=30;cio
A 150 mm diameter rivet resists a shear force of V =8 kN. Find the average shear stress in the rivet. %3D 150 mm (A) 230 kPa (B) 370 kPa (C) 430 kPa (D) 450 kPa
Consider a retaining wall supporting a fill-soil as shown in the figure. The wall is moving from right to left. q=15kN.m2 0.5m Yconcrete=24kN.m Y1=16KN.m 01=32° Cz=0 3.5m P1 n=16KN.m P2 01=32° 0.5m C==0 [0.5m. 1m 1m 1m (a) Compute the active force P, and on the wall and its location. (b) Compute the passive force P2 on the wall. (c) Analyze the factor of safety against sliding.
A 40m steel tape is suspended in the air between a theodolite and vertical rod, which is placed exactly at the 40m mark, under a pull of 12.5kg. The slope of the measured line is 2-degree 40minutes. The tape weighs 1kg, standard pull of 8.5kg, cross-sectional area of 0.039cm^2 and E= 2x10^6 kg/cm^2. a. Determine the correction for sag of the tape in meter.b. Determine the horizontal distance between the theodolite and rod in meters. (Apply 5-decimal places - for letter B only)c. What additional pull must be applied to eliminate the effect of sag?
Pi For the following wall, find the total force and its location? тат 4 = 90 кра 82= 16 kN/m² I ɣsat 18 kv/m³ 4m Сто 4=30 d= =0 сечо кра rsat =17 kN/m3 5m
Determine the resultant active lateral earth force acting on of the wall shown and its location. 10 2. $= 40° ム0m a, a, = 0.0
1.Compute the moment of inertia in ___ x 108 mm4 about the neutral y-axis.0 2.Compute the design compressive strength of the built-up shape in KN.0 3.Determine the % increase in the design compressive strength (after the addition of channels).0