9- A bowling ball of mass 7.5 kg travelling at 10 m sec-rolls off a horizontal table 1 m high. (Assume the acceleration due to gravity is 10 m sec-2, and the effects of air resistance may be ignored unless otherwise stated.) a Calculate the ball's horizontal velocity just as it strikes the floor. b What is the vertical velocity of the ball as it strikes the floor? c Calculate the velocity of the ball as it reaches the floor. d What time interval has elapsed between the ball leaving the table and striking the floor? e Calculate the horizontal distance travelled by the ball as it falls.

9- A bowling ball of mass 7.5 kg travelling at 10 m sec-rolls off a horizontal table 1 m high. (Assume the acceleration due to gravity is 10 m sec-2, and the effects of air resistance may be ignored unless otherwise stated.) a Calculate the ball's horizontal velocity just as it strikes the floor. b What is the vertical velocity of the ball as it strikes the floor? c Calculate the velocity of the ball as it reaches the floor. d What time interval has elapsed between the ball leaving the table and striking the floor? e Calculate the horizontal distance travelled by the ball as it falls.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 10.0-kg box is pulled along a horizontal surface by a force of 40.0 N applied at a 30.0° angle above horizontal. coefficient of kinetic friction is 0.30. Calculate the acceleration. O A.9.52 m/s2 O B. 3.76 m/s2 OC1.12 m/s2 O D.3.16 m/s2 O E. None of the above « Question 15 of 50 Moving to another question will save this response.
:A (19L) cylindrical container with a bottom area of (775cm²) is filled with glycerin and rests on the floor: A. determine the fluid container when the acceleration of (0.9m/sec²). B. what resultant force dose the container exerts on the floor of the elevator during this acceleration? c. what will the angle between static and accelerated case if it also decelerated in horizontal direction (0.9m/sec) Answer with sketch pressure at the bottom of the container has an upward has
The 250-lb concrete block A is released from rest in the position shown and pulls the 400 lb log up the 30° ramp. Plot the velocity of the block as it hits the ground at B as a function of the coefficient of kinetic friction ug between the log and the ramp. Let µk vary between 0 and 1. Why does the computer not plot results for the entire range specified? 400lb 250lb A 30 deg 20' Hints: -- Model the system as a dependent motion analysis and derive acceleration equations in terms of the unknown quantities -- Use MATLAB to solve this system of equations (you'll need one equation for each unknown!) Define uk as a range in MATLAB from 0 to 0 in 0.01 increments -- Plot the function of the velocity for the block as it hits the ground
A box slides from rest at point A down an inclined 30 degrees to the horizontal. After reaching the bottom of the plane, the box moves on a horizontal floor at a distance 2m before coming to rest. Coefficient of friction between the box and the floor is 0.40 a. What is the distance from point A to the intersection of the inclined plane and the horizontal floor? b. What is the velocity of the block as it reaches the intersection of the inclined plane and the horizontal floor? c. What is the total time of travel until it stop?
Q8) You are designing a system for moving aluminum cylinders from the ground to a loading dock. You use a sturdy wooden ramp that is 2.00 m long and inclined at 37.0 degrees above the horizontal. Each cylinder is fitted with a light, frictionless yoke through its center, and a light (but strong) rope is attached to the yoke. Each cylinder is uniform and has mass 420 kg and radius 0.300 m. The cylinders are pulled up the ramp by applying a constant force F to the free end of the rope. F* is parallel to the surface of the ramp and exerts no torque on the cylinder. The coefficient of static friction between the ramp surface and the cylinder is 0.120. a) What is the largest magnitude F° can have so that the cylinder still rolls without slipping as it moves up the ramp? b) If the cylinder starts from rest at the bottom of the ramp and rolls without slipping as it moves up the ramp, what is the shortest time it can take the cylinder to reach the top of the ramp?
Q1: A plate (0.005 cm )distance from a fixed plate move at ( 72000 mm/min) and requires a force of (2.2 N/m2) to maintain in this speed.Find the viscosity of the fluid between the plates. * 9.16*10-5 91.6*10-5 916.5*10-5
A 10.0-kg box is pulled along a horizontal surface by a force of 40.0 N applied at a 30.0° angle with vertical. Coefficient of kinetic friction is 0.30. Calculate the acceleration. O A. 0.52 m/s2 O B. 3.76 m/s2 OC.1.12 m/s2 O D. 3.16 m/s2 O E. None the above
0 1".ll Asiacell Home work m... -> Q1: The position of a particle moving along the x-axis is given by X =4t -9 calculate the acceleration and displacement if velocity =Im/sec Q2 : a ball thrown from the top of a house is given an initial velocity 10 m/sec straight upward the house is 55 m high and after ball reach the maximum hight then down to the ground calculate : 1-time at which the ball reach maximum and the maximum height 2- The velocity and the position of the ball at time = 2 sec Q3: A senior physics class conducting a research project on projectile motion constructs a device that can launch a cricket ball. The launching device is designed so that the ball can be launched at ground level with an initial velocity of 50 m s-1 at an angle of 45° to the horizontal. Calculate 1- The horizontal & vertical components of the velocity of the ball initially. 2- What is the maximum height that is achieved by the ball? 3-How far from lunching point will the ball attain its original level…
Q3: The space between two large flat and parallel walls 25 mm apart is filled with a liquid of absolute viscosity 0.7 Pa.sec. Within this space a thin flat plate 25 cm x 25 cm is towed at a velocity of 0.15 m/s at a distance of 6 mm from one wall, the plate and its movement being parallel to the walls. Determine the force exertem by the liquid on the plate. Stationary plate 6 mm 19 mm 0.15 m/s Stationary plate
A ball is thrown from the top of a building with an initial velocity of 10:0 m/s straight upward, at an initial height of 55 m above the ground. The ball just misses the edge of the roof on its way down. Determine the time needed for the ball to reach the ground. O 4.4 sec O 2.5 sec O 4.6 sec
Quèstion 42 A 10.0-kg box is pulled along a horizontal surface by a force of 49.0 N applied at a B0.0 angle above horizontal. Coefficient of kinetic friction is 0.30. Calculate the acceleration. OA e.52 m/s2 OB.3.76 m/s2 OC1.12 m/s2 OD.3.16 m/s2 O E. None of the above A Moving to another question will save this response. « » acer F6 F7 F8 F9 F10 F11 F12 PrtSc Pause Del Home Po Scr Lk SysRq Break Ins & * Backspace 8 9. U P
A golf ball is driven off a tree that is elevated 10m above fairway. The initial velocity of the ball is 40m/s with an angle of 40° at the horizontal. a. Maximum height? b. Range? c. Velocity of ball when it reaches fairway?